Sharp FU-551KB Manuel utilisateur

FU-551KB

AIR PURIFIER

OPERATION MANUAL

m¢Ój¨sÔp

¥mñpjj

¦¦kp

Wall mounting type

“Plasmacluster” and “Device of a cluster of

grapes” are trademarks of Sharp Corporation.

* Shelf-placement type

A stand for shelf-placement can be used for

installation.

* The number in this technology mark indicates the

approximate number of ions supplied into 1 cm3

of air, which is measured around the center of a

room (with the “High-Density Plasmacluster 25000”

applicable Àoor area), at a height of 1.2m above

the Àoor, at the MAX wind volume setting in air

purifying mode, and when an air puri¿er using the

high-density plasmacluster ion evolving device is

placed close to a wall.

ENGLISH ©

Before operating your new air puri¿er , please read the following

The air puri¿er draws in room air through the air intake, circulates it through a

Pre-Filter, a Deodorizing Filter and a HEPA Filter inside the unit, and then discharges

it through the air outlet. The HEPA Filter can remove 99.97% of dust particles as

small as 0.3 microns that pass through the ¿lter and also helps absorb odors.

The Deodorizing Filter gradually absorbs odors as they pass through the ¿lter.

Some odors absorbed by the ¿lters will break down over time, causing additional

odors. Depending on usage conditions, and especially if the product is used in

environments signi¿cantly more severe than a normal household, these odors may

become noticeable sooner than expected. If these odors persist replace the ¿lters.

NOTE

• The air puri¿er is designed to remove air-suspended dust and the odors they cause. The air

puri¿er is not designed to remove harmful gases such as carbon monoxide contained in cigarette

smoke. The air puri¿er may not completely remove an odor if the source of the odor is still present.

Pre-Filter

HEPA Filter

Deodorizing Filter

E-1

ENGLISH

FEATURES

Thank you for purchasing this SHARP Air

Puri¿er. Please read this manual carefully

before using the air puri¿er.

After reading, keep the manual in a

convenient location for future reference.

Unique Combination of Air Treatment

Technologies

Triple Filtration System + Plasmacluster

Ions

TRAPS DUST*

Pre-¿lter traps dust and other large

airborne particles.

DECREASES ODORS

Deodorizing ¿lter absorbs many common

household odors.

REDUCES POLLEN & MOLD*

HEPA ¿lter traps 99.97% of particles as

small as 0.3 microns.

FRESHENS

By emitting a balance of positive and neg-

ative ions, Plasmacluster air treatment is a

natural process.

*When air is circulated through the ¿lter

system.

Sensor technology continuously monitors

air quality, and automatically adjusts

operation based on air purity level.

ENGLISH

IMPORTANT SAFETY INSTRUCTIONS

..... E-2

PART NAMES...............................................E-4

PREPARATION ............................................E-6

OPERATION .................................................E-7

USEFUL FUNCTION .................................E-10

CARE AND MAINTENANCE ................... E-11

TROUBLESHOOTING ..............................E-15

SPECIFICATIONS......................................E-16

CONTENTS

E-2

IMPORTANT SAFETY INSTRUCTIONS

Always follow basic safety precautions when using electrical appliances, including

the following:

WARNING -

Always observe the following to reduce the risk of electrical shock, ¿re, or injury:

• Read all instructions before using the unit.

• Use only a 220 volt outlet.

• Do not use the unit if the power cord or plug is damaged or if the connection to the wall

outlet is loose.

• Periodically remove dust from the plug.

• Do not insert ¿ngers or foreign objects into the air intake or air outlet.

• When removing the power plug, always hold the plug - never pull on the cord.

Failure to do so can cause a short circuit resulting in electrical shock or ¿re.

• Do not remove the plug while your hands are wet.

• Do not place the unit near gas appliances or ¿replaces.

• Always unplug the unit when cleaning the unit, or when the unit is not in use.

Failure to do so can cause a short circuit resulting in electrical shock or ¿re.

• In order to avoid safety hazards, if the power cord is damaged, it must be replaced

by either the manufacturer, a service agent, a Sharp authorized Service Center or a

similarly quali¿ed service provider.

• Only a Sharp Authorized Service Centre should service this air puri¿er. Contact the nearest

Service Centre for any problems, adjustments, or repairs.

• Do not operate the unit in rooms where aerosol insecticides are present. Do not operate the

unit in rooms where there is oily residue, incense, sparks from lit cigarettes, or chemical fumes

in the air. Do not operate the unit in places where it may get wet, such as a bathroom.

• Be cautious when cleaning the unit. Strong corrosive cleansers can damage the exterior.

• This appliance is not intended for use by persons (including children) with reduced physical,

sensory, or mental capabilities, nor by persons with insuf¿cient experience and knowledge of

how to operate the unit, unless they are given proper supervision and instruction on how to

use the unit by a person responsible for their safety. Do not allow children to play with the unit.

NOTE - What to do if the unit interferes with radio or TV reception

If the air puri¿er interferes with radio or television reception, try one or more of the following

measures:

• Adjust or reposition the receiving antenna.

• Increase the distance between the unit and the radio or TV.

• Connect the equipment into an outlet on a circuit different from that of the radio or TV

receiver.

• Consult the dealer or a quali¿ed radio or TV technician.

E-3

ENGLISH

CAUTIONS CONCERNING OPERATION

• Do not block the air intake or air outlet.

• Do not place the unit near or on hot objects, such as stoves or heaters, or where it may come

into contact with steam.

• Always operate the unit in an upright position.

• Do not operate the unit without the ¿lters properly installed.

• Do not wash and reuse the HEPA ¿lter and the Deodorizing ¿lter.

Doing so will not improve ¿lter performance and can also cause electric shock or operating

malfunctions.

• Clean the exterior with a soft cloth only.

Do not use volatile liquids or detergents.

Doing so can damage or crack the exterior of the unit.

In addition, doing so can cause sensor malfunctions.

• Keep the unit away from water.

• When cleaning the room with chemicals, please stop the unit and cover with a sheet, etc. so

the chemicals do not adhere to the unit.

• After the room cleaning, please be sure to adequately ventilate the room from chemicals and

gas generated from the chemicals before operating the unit.

INSTALLATION GUIDELINES

• When using the unit, place it at least 2 meters away from equipment that emits electric

waves, such as televisions or radios, to avoid electrical interference.

• Avoid locations where the sensors are exposed to direct wind.

Doing so can cause the unit to malfunction.

• Avoid locations where furniture, fabrics, or other objects can come in contact with the

unit and interfere with the intake and outtake of air.

• Avoid locations where the unit is exposed to condensation or drastic changes in

temperature. Appropriate room temperature is between 0 – 35 ºC.

• Place the unit on a level and stable surface with suf¿cient air circulation.

When placed on heavy carpet, the unit may vibrate slightly.

• Avoid locations that generate grease or oily smoke.

Doing so can cause the unit exterior to crack and the sensors to malfunction.

• Make sure the wall is strong enough to hold the unit’s weight.

• When wall mounted installation is not possible / When installation on a shelf, use a stand for

shelf-placement [FZ-K51STE] for installation.

For more information, please contact your dealer.

FILTER GUIDELINES

• Follow the instructions in this manual for proper ¿lter care and maintenance.

E-4

PART NAMES

UNIT

911 10

12 13 14 16 17 18 19 20

3(Plug shape varies by country)

lndicates air purity according

to 3 color-coded levels.

Clean sign

green

clean

red

impure

Air Outlet (Right & Left) Pre Filter (Bottom)

Air Outlet (Bottom) Remote control sensor area

Power Code/Plug Timer Indicator Light (green)

Plasmacluster Sign/Indicator Light (blue) Fan Speed Indicator Light (blue)

Pre Filter (Front) Filter Cleaning Indicator Light (orange)

Deodorizing Filter Unit Replacement Light (red)

HEPA Filter Unit Cleaning Indicator Light (orange)

Front Panel Check Indicator Light (green)

Sensor Cover (Dust/Odor sensor) Fan Speed Button

Filter Cover Power ON/OFF Button

111

212

313

414

515

616

717

818

919

10 20

E-5

ENGLISH

Remote Control

915

1Transmitter

2Fan Speed icon

3Display for TIME /Timer setting

4Light Control Button

5POWER ON/OFF Button

6Fan Speed setting Button

7OFF TIMER Button

8ON TIMER Button

9TIME /Timer setting Button

10 Battery icon

11 Sending icon

12 PLASMACLUSTER icon

13 PLASMACLUSTER ON/OFF Button

14 TIME Button

15 Reset Button

Remove the battery cover and insert two AAA batteries.

Make sure the positive and negative ends are facing in

the correct direction,as shown below.

1. Remote controller should never be exposed

to direct sunlight.

2. Transmitter & receiver should always be

clean to ensure proper communication. Use

a soft cloth to clean them.

3. In case other appliance operation is affected

by the remote control, change their position

or consult your dealer.

Screw the holder onto the wall and slide the controller

inside the holder.

NOTE

E-6

PREPARATION

TIME SETTING FOR REMOTE CONTOROL

OPERATION OF REMOTE CONTROL

< Ex. Set the TIME “AM10:30” >

Remote control

sensor area

Transmitter

Point the remote control towards the Remote control

sensor area and press the desired button. The unit

generates a beep when it receives the signal.

• Make sure no items, such as curtains, block the signal

the Remote control sensor area.

• The signal effective distance is 7 meters.

• Do not expose the Remote control sensor area

to direct sunlight. This may adversely affect its

operation.

• Use of certain Àuorescent lamps in the same room

may interfere with transmission of the signal.

CAUTION

E-7

ENGLISH

OPERATION

Power ON / OFF

FAN SPEED

START

STOP

Select the desired fan speed.

AUTO The fan speed is automatically switches between HIGH and LOW depending on the

amount of impurities in the air.

The sensors detect impurities for ef¿cient operation.

OPERATION OF THE UNIT

Beep

AUTO LOW MED MAX FULLPOWER

Beep Beep Beep Beep Beep

START

AUTO LOW MED

FULL POWER MAX

STOP

Beep

Beep Beep

Beep

E-8

OPERATION (continued)

ON TIMER / OFF TIMER

< Ex. Set the TIME “PM9:20” >

SET

OFF TIMER ON TIMER SETTING

Press

CANCELLATION

OFF TIMER

ON TIMER

Beep

Table des matières

Autres manuels Sharp Purificateur d'air

Sharp

Sharp KC-F30E Manuel utilisateur

Sharp

Sharp Plasmacluster KC-830U Manuel utilisateur

Sharp

Sharp KC-G51R Manuel utilisateur

Sharp

Sharp FU-P40S Manuel utilisateur

Sharp

Sharp FP-J50 Manuel utilisateur

Sharp

Sharp KCF31RW Manuel utilisateur

Sharp

Sharp FP-JM30E Manuel utilisateur

Sharp

Sharp FP-JM40B Manuel utilisateur

Sharp

Sharp Plasmacluster KC-850E Manuel utilisateur

Sharp

Sharp FP-J40E Manuel utilisateur

Sharp

Sharp KC-930EKW Manuel utilisateur

Sharp

Sharp KC-860EKW Manuel utilisateur

Sharp

Sharp FZ-WS50SFE Manuel utilisateur

Sharp

Sharp Plasmacluster FU-W53J Manuel utilisateur

Sharp

Sharp Plasmacluster KC-30TX1 Manuel utilisateur

Sharp

Sharp FP-J80E Manuel utilisateur

Sharp

Sharp IG-GC2EU Manuel utilisateur

Sharp

Sharp IG-A10UR Manuel utilisateur

Sharp

Sharp UA-HG60E Manuel utilisateur

Sharp

Sharp FP-A80U Manuel utilisateur

Sharp

Sharp FU-S63E Manuel utilisateur

Sharp

Sharp FU-A80A Manuel utilisateur

Sharp

Sharp UA-PN1E Manuel utilisateur

Sharp

Sharp FP-F30TA Manuel utilisateur

Manuels Purificateur d'air populaires d'autres marques

IKEA

IKEA UPPÅTVIND Manuel utilisateur

Nash

Nash AP-1 PureSmart Manuel utilisateur

LG PH-U450 Series Manuel utilisateur

DeLonghi

DeLonghi DDSX 220WFA Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric MA-E85R-E Manuel utilisateur

Philips

Philips AC2721 Manuel utilisateur

Hitachi

Hitachi EP-A3000 Manuel utilisateur

TruSens

TruSens Z-2000 Manuel utilisateur

Motorola

Motorola MBP87SN Manuel utilisateur

Beko

Beko ATP 7100I Manuel utilisateur

Carrier

Carrier INFINITY 1620 Manuel utilisateur

AtmosAir

AtmosAir P2002 Manuel utilisateur

Winix

Winix NK300 Manuel utilisateur

Friedrich

Friedrich C-90A Instructions d'utilisation et d'installation

Surgically Clean Air

Surgically Clean Air JADE2.0 Manuel utilisateur

Base aire

Base aire 555 Pro Manuel utilisateur

Champion

Champion CP25 Manuel utilisateur

vollara

vollara Air & Surface Pro+ Manuel utilisateur