Sanus Systems VMAV Manuel utilisateur

Assembly Instructions for Model: VMAV

Thank you for choosing a Sanus Systems VisionMount™ VMAV. The VMAV is designed to hold a VCR, DVD player, cable box, satel-

lite receiver or stereo component weighing up to 45 lbs.

Safety Warning: If you do not understand these directions, or have any doubts about the safety of the installation, please call a quali-

ed contractor or contact Sanus at 800.359.5520 or www.sanus.com. Check carefully to make sure that there are no missing or defective

parts. Our customer service representatives can quickly assist you with installation questions and missing or damaged parts. Replace-

ment parts for products purchased through authorized dealers will be shipped directly to you. Never use defective parts. Improper instal-

lation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specied by Sanus Systems.

Sanus Systems can not be liable for damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use. Please call

Sanus Systems before returning products to the point of purchase.

Required Tools: Drill, 1/4” drill bit and a socket set

Supplied Parts and Hardware: Some parts not shown as actual size*

(1) Wall Plate - a* (1) Cover - b* (1) Tube - c* (2) Cap - d

(4) Foot - e (4) Lag Bolt - f (2) Set Screw - g (1) Allen Key - h

Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 7.13.05

Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com

Step 1: Attach Wall Plate

The Wall Plate (a) must be mounted to a wood

stud. Make sure the Wall Plate is oriented so that

the at side is against the wall as shown in Diagram

1. Use the Wall Plate as a template to mark the 4

hole locations for the Lag Bolts (f) between the two

edges of the chosen stud. Pre-drill four holes 2.5”

deep at the marked locations using a 1/4” drill bit.

Attach the Wall Plate to the wall using all 4 of the

Lag Bolts as shown in diagram 1. Tighten each Lag

Bolt with the appropriate socket head.

WARNING: Tighten Lag Bolts (f) only until the

Wall Plate (a) is pulled rmly against the wall. DO

NOT OVER-TIGHTEN THE LAG BOLTS!

Diagram 1

Step 2: Add Cover

Slide the Cover (b) so it clips onto the Wall Plate

(a). See Diagram 2 for assistance.

Step 3: Add Feet and Caps

Press t a Foot (e) into each of the 4 holes in the top

portion of the Tube (c). Press t a Cap (d) into each

end of the Tube. See Diagram 3 For assistance.

Step 4: Install Tube

Insert the Tube (c) into the Wall Plate (a). Insert a

Set Screw (g) into each hole in the Wall Plate as

shown in the Detailed View of Diagram 4. Tighten

each Set Screw rmly with the Allen Key (h).

Diagram 4

Diagram 2

Diagram 3

Detailed View

Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 7.13.05

Customer Service: 800.359.5520. See complementary Sanus products at www.sanus.com

Table des matières

Autres manuels Sanus Systems Support et étagère

Sanus Systems

Sanus Systems VMCA9 Manuel utilisateur

Sanus Systems

Sanus Systems VisionMount MF202 Manuel utilisateur

Sanus Systems

Sanus Systems STEEL FOUNDATIONS SFC Manuel utilisateur

Sanus Systems

Sanus Systems HTSAT Manuel utilisateur

Sanus Systems

Sanus Systems VMFL1 Manuel utilisateur

Sanus Systems

Sanus Systems SD103 Manuel utilisateur

Sanus Systems

Sanus Systems VMFL1 Manuel utilisateur

Sanus Systems

Sanus Systems PFV60-B1 Manuel utilisateur

Sanus Systems

Sanus Systems Wall Mount LL22 Manuel utilisateur

Sanus Systems

Sanus Systems FM37 Manuel utilisateur

Sanus Systems

Sanus Systems Wall Mount LL22 Manuel utilisateur

Sanus Systems

Sanus Systems Sanus Ultimate Foundations UF34 Manuel utilisateur

Sanus Systems

Sanus Systems VMSA Manuel utilisateur

Sanus Systems

Sanus Systems SD115 Manuel utilisateur

Sanus Systems

Sanus Systems New Foundations 100 Series Manuel utilisateur

Sanus Systems

Sanus Systems VisionMount VMCA7 Manuel utilisateur

Sanus Systems

Sanus Systems VMPR1 Manuel utilisateur

Sanus Systems

Sanus Systems Monitor Mount VMTV Manuel utilisateur

Sanus Systems

Sanus Systems VisionMount ML22 Manuel utilisateur

Sanus Systems

Sanus Systems VMCT Manuel utilisateur

Sanus Systems

Sanus Systems BF16 Manuel utilisateur

Sanus Systems

Sanus Systems VMUC1 Manuel utilisateur

Sanus Systems

Sanus Systems Sanus VisionMount LC1A Manuel utilisateur

Sanus Systems

Sanus Systems VM400 Manuel utilisateur

Manuels Support et étagère populaires d'autres marques

Salamander

Salamander Acadia AC/W/L400/WH Manuel utilisateur

Fohhn

Fohhn VAT-09 Guide de l'utilisateur

ricoo

ricoo FS0522 Manuel utilisateur

AMSOIL

AMSOIL BMK-22 Guide rapide

Kargo Master

Kargo Master 48220 Manuel utilisateur

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manuel utilisateur

ricoo

ricoo S1222 Manuel utilisateur

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manuel utilisateur

VidaBox

VidaBox VB MNT FFS2 Manuel utilisateur

Welch Allyn

Welch Allyn 48960 Manuel utilisateur

Arkon

Arkon CM035-ST-2 Manuel utilisateur

PROEL

PROEL PLWIN60C Manuel utilisateur

Agilent Technologies

Agilent Technologies E2609B Manuel utilisateur

Mustang

Mustang MV-ARM4 Manuel utilisateur

Mounting Solutions

Mounting Solutions WRM-320 Manuel utilisateur

Pyle

Pyle PMKSPAD1 Manuel utilisateur

ShelterIt

ShelterIt 21208 Manuel utilisateur

SPL

SPL RackPack?4 1040 Manuel utilisateur