Sanus Systems Vision Mount VMBR Manuel utilisateur

Assembly Instructions for Vision Mount VMBR

Thank you for purchasing a Vision Mount product. This product is designed to hold a VCR, DVD player, or cable / satellite

box under a VMBR television wall mount. It will accommodate one component up to 15 lbs. Check carefully to make sure

there are no missing or defective parts. Never use defective parts. Improper installation may cause damage or serious injury.

If you do not understand these directions, or have any doubts about the safety of the installation, please call a qualified

contractor or contact Sanus Systems at 800.359.5520 or visit www.sanus.com. We can quickly assist you with installation

questions and missing or damaged parts. Replacement parts for Sanus products purchased through authorized dealers will

be shipped directly to you.

Required Tools: Ratchet or wrench set

Supplied Parts:

(1) Main Arm - a (2) Extension Arm - b (2) Component Holder - c

(2) 17 mm Wide Foam Pad - d (2) 15 mm Wide Foam Pad - e (2) Square Foam Pad - f

(2) Set Screw - g (2) Knob - h (1) Allen Key - i

(1) Mount Bracket - j (2) 6 mm Diameter Bolt - k (2) 6 mm Diameter Nut - l

(1) 8 mm Diameter Bolt - m (1) Tube Spacer - n (2) Washer - o

(1) Plastic Spacer - p (1) 8 mm Diameter Nut - q

Step 1: Place the 2 Square Foam Pads (f) onto the 2 square surfaces on the bottom of the Main Arm (a) as shown

in Diagram 1 below.

Step 2: Place a 17 mm Wide Foam Pad (d) onto the vertical side of each Component Holder (c). Next place a 15

mm Wide Foam Pad (e) onto the horizontal side of each Component Holder as shown in Diagram 2 below.

Sanus Systems 3785 Lexington Ave. North, Saint Paul, MN 55126 800.359.5520 www.sanus.com

Diagram 1 Diagram 2

Step 3: Add an Extension Arm (b) to each side of the Main Arm (a). Lock each Extension Arm into place at the

desired width using a Set Screw (g). Tighten the Set Screw with the Allen Key (i) as shown in Diagram 3 below.

Step 4: A Component Holder (c) ﬁ ts into the track on the inside of each Extension Arm (b). Next, a Knob (h)

passes through the slot in the Extension Arm from the outside and threads into the hole in each Component Holder

as shown in Diagram 4 below.

Determine how you will mount the VMTV to your TV Wall Mount: There are two different methods to attach

the VMBR component bracket to the wall mount. It is recommended that you use Method 1 described in steps

5 through 8. You may also use Method 2 described in steps 9 through 11. Method 2 will be easier if you already

have a television on your TV Wall Mount.

Method 1

Step 6: Place the 8 mm Diameter Bolt (m) down through the TV Platter in place of the bolt provided with the TV

Wall Mount as shown in Diagram 6 below.

Step 7: Next place the Plastic Cap Bottom onto the TV Wall Mount assembly.

Step 8: Finally add the hardware to the bottom of the 8 mm Diameter Bolt (m) in the following order: Tube Spacer

(n), Washer (o), Component Bracket Assembly, Plastic Spacer (p), Washer (o), and the 8 mm Nut (q) as shown in

Diagram 6 below. Adjust the width and height to ﬁ t your component and the assembly is complete.

Method 2

Step 9: Place the Mount Bracket (j) over the Arm of the TV Wall Mount as shown in Diagram 7 below.

Step 10: Next place both 6 mm Diameter Bolts (k) down through the Mount Bracket (j) so that the square neck of

the bolts ﬁ t into the square holes in the bracket also shown in Diagram 7.

Step 11: Add the component bracket to the assembly so that the two 6 mm Bolts (k) ﬁ t down through the two

square holes in the Main Arm (a) and tighten a 6 mm Nut (l) onto each 6 mm Bolt as shown in Diagram 7 below.

Sanus Systems 3785 Lexington Ave. North, Saint Paul, MN 55126 800.359.5520 www.sanus.com

Step 5: First ﬁ nd the Plastic Cap Bottom from the TV Wall Mount. There is a

pre-punctured hole in the bottom that you must push out as shown in Diagram 5.

032204

Diagram 3 Diagram 4

Threaded Hole

Diagram 5

Hole

Diagram 6 Diagram 7

Plastic Cap

Bottom Component Bracket

Assembly

Arm

Component Bracket

Assembly

Autres manuels Sanus Systems Support et étagère

Sanus Systems

Sanus Systems VisionMount ML22 Manuel utilisateur

Sanus Systems

Sanus Systems VisionMount VMCA7 Manuel utilisateur

Sanus Systems

Sanus Systems WMS5 Manuel utilisateur

Sanus Systems

Sanus Systems VM2 Manuel utilisateur

Sanus Systems

Sanus Systems VMCA9 Manuel utilisateur

Sanus Systems

Sanus Systems FM37 Manuel utilisateur

Sanus Systems

Sanus Systems SANA1A Manuel utilisateur

Sanus Systems

Sanus Systems VMPL50 Manuel utilisateur

Sanus Systems

Sanus Systems PFFP Manuel utilisateur

Sanus Systems

Sanus Systems VM2 Manuel utilisateur

Sanus Systems

Sanus Systems SD115 Manuel utilisateur

Sanus Systems

Sanus Systems STEEL FOUNDATIONS SFC Manuel utilisateur

Sanus Systems

Sanus Systems Wall Mount LL22 Manuel utilisateur

Sanus Systems

Sanus Systems VisionMount MF203 Manuel utilisateur

Sanus Systems

Sanus Systems VMFL1 Manuel utilisateur

Sanus Systems

Sanus Systems VMSA Manuel utilisateur

Sanus Systems

Sanus Systems Sanus Ultimate Foundations UF34 Manuel utilisateur

Sanus Systems

Sanus Systems MF110 Manuel utilisateur

Sanus Systems

Sanus Systems VisionMount VMAA26 Manuel utilisateur

Sanus Systems

Sanus Systems EFSat Manuel utilisateur

Sanus Systems

Sanus Systems HTB7 Manuel utilisateur

Sanus Systems

Sanus Systems VMAV Manuel utilisateur

Sanus Systems

Sanus Systems Platinum Furniture PFV36sb-01 Manuel utilisateur

Sanus Systems

Sanus Systems HTSAT Manuel utilisateur

Manuels Support et étagère populaires d'autres marques

Salamander

Salamander Acadia AC/W/L400/WH Manuel utilisateur

Fohhn

Fohhn VAT-09 Guide de l'utilisateur

ricoo

ricoo FS0522 Manuel utilisateur

AMSOIL

AMSOIL BMK-22 Guide rapide

Kargo Master

Kargo Master 48220 Manuel utilisateur

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manuel utilisateur

ricoo

ricoo S1222 Manuel utilisateur

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manuel utilisateur

VidaBox

VidaBox VB MNT FFS2 Manuel utilisateur

Welch Allyn

Welch Allyn 48960 Manuel utilisateur

Arkon

Arkon CM035-ST-2 Manuel utilisateur

PROEL

PROEL PLWIN60C Manuel utilisateur

Agilent Technologies

Agilent Technologies E2609B Manuel utilisateur

Mustang

Mustang MV-ARM4 Manuel utilisateur

Mounting Solutions

Mounting Solutions WRM-320 Manuel utilisateur

Pyle

Pyle PMKSPAD1 Manuel utilisateur

ShelterIt

ShelterIt 21208 Manuel utilisateur

SPL

SPL RackPack?4 1040 Manuel utilisateur