Samsung MWR-WW00N Manuel utilisateur
Wired Remote Control
MWR-WW00N
DVM Hydro unit / Hydro unit HT
installation manual
imagine the possibilities
Thank you for purchasing this Samsung
product.
DB68-03973A-06
DVM HT_HE RC-EU_IM_EN_DB68-03973A-06.indd 1 2017-05-25 오후 4:18:26
2
Safety information
This installation manual explains how to install a wired remote controller connected to a Hydro unit/Hydro unit HT.
Please read this manual thoroughly before installing the remote controller.
(Please refer to the corresponding installation manual for product and other optional installation.)
WARNING Hazards or unsafe practices that may result in severe personal injury or death.
CAUTION Hazards or unsafe practices that may result in minor personal injury or property damage.
WARNING
Contact a service center for installation.
Failure to do so may result in product malfunction, water leak, electric shock and re.
Install the product with rated power supply.
Failure to do so may result in re or damage to a wired remote controller.
Do not modify or repair the wired remote controller yourself.
Failure to do so may result in product malfunction, electric shock, and re. When you need to repair the product, you
should contact a service center.
All the electric work should be performed in accordance with local regulation and installation manual by a certied
technician.
Failure to do so may result in product malfunction, electric shock and re due to defect.
Install the product on a hard and even surface that can support its weight.
If the surface cannot support its weight, the wired remote controller may fall down and it may cause product damage.
Do not move or reinstall the connected wired remote controller yourself.
Failure to do so may result in electric shock and re.
Check whether the installation work is correctly performed in accordance with installation manual.
When the wired remote controller is incorrectly installed, electric shock and re may occur.
When disposing of the wired remote controller, please contact a service center.
DVM HT_HE RC-EU_IM_EN_DB68-03973A-06.indd 2 2017-05-25 오후 4:18:26
3
ENGLISH
CAUTION
Do not install the product where imammable content may leak.
Failure to do so may result in re and explosion.
Ensure no water gets into the wired remote controller.
Failure to do so may result in electric shock and re.
Install the product away from direct exposure to sunlight, in room temperature range of 0°C(32°F)~39°C(102°F).
Failure to do so may result in electric shock or abnormal operation.
Do not handle the product with sharp objects.
Failure to do so may result in electric shock or part damage.
Do not install the product in specic areas exposed to oil or vapor.
Failure to do so may result in part damage or abnormal operation.
Do not put undue stress on the power cable.
Failure to do so may result in broken cable and re.
Do not install the product in areas where acid or alkali liquid or special spray are used.
Failure to do so may result in electric shock or abnormal operation.
Do not connect power cable to a communication terminal.
Failure to do so may result in re.
Be cautious not to interfere with any other electrical devices if the product is installed in a place such as hospital.
Failure to do so may result in abnormal operation.
DVM HT_HE RC-EU_IM_EN_DB68-03973A-06.indd 3 2017-05-25 오후 4:18:26
4
Wired remote controller installation
Accessories
Name Wired remote
controller Cable tie Cable clamp M4X16 Screw User Manual Installation
Manual U-Terminal
Quantity 1235116
Shape
• The wired remote controller should be installed by a certied technician.
• Check and conrm the power is o before installing your wired remote controller.
• Install the wired remote controller cables in accordance with the electrical wiring regulation, and allow it to pass
through the inner area of the wall so that other people can’t reach it.
CAUTION
External Dimensions
120(4.72)
124(4.88)
63.8(2.51)
19.5(0.76)
Unit : mm(inch)
DVM HT_HE RC-EU_IM_EN_DB68-03973A-06.indd 4 2017-05-25 오후 4:18:27
5
ENGLISH
1. Push the two hooks at the bottom of your Wired Remote Controller at the same time, and then pull up the front cover to
separate it from the rear cover.
Push the two hooks at the same time.
NOTE
• Insert a at head screwdriver into the square groove in the upper area of the hook
to disassemble it easily.
2. Arrange the communication cable so that they t in the housing along the edges of the rear cover.
If you need more space for the wiring
work, you can take it o.
15cm(5.90)
<When the cable is not concealed> <When the cable is concealed>
10cm(3.93)
DVM HT_HE RC-EU_IM_EN_DB68-03973A-06.indd 5 2017-05-25 오후 4:18:27
6
3. Using more than two screws, rmly ax the rear cover of the remote controller to the wall, and then connect
communication cables(F3, F4), making sure these cables have reasonable length, to the terminal at the back of the cover.
10mm (0.4inch) or more
10mm (0.4inch)
or more
50mm (2inch) or more
10mm (0.4inch) or more
Rear cover
Screw hole
Wire (not supplied)
PCB terminal
Front cover
Wired remote
controller
Hydro unit/Hydro unit HT
Hydro unit/Hydro
unit HT PCB
Before xing the rear cover, allow
at least 10mm(0.4inch) space of
upper side, left side, right side, and
50mm(2inch) space of bottom
side.
You must t the screws into the
screw holes.
Do not tighten the screws on the
PCB terminal with excessive force.
4. Reassemble your wired remote controller.
NOTE
• Align the controller with the upper groove rst, and insert it by turning it downward as shown in the
gure. After assembly, check and conrm that no wires are stuck in the gap between the rear and
front cover.
Wired remote controller installation
DVM HT_HE RC-EU_IM_EN_DB68-03973A-06.indd 6 2017-05-25 오후 4:18:28
7
ENGLISH
• When installing a wired remote controller by using a cable longer than 10m, you must install the
communication cable and the power cable separately. (Electrical interference can cause your wired remote
controller to malfunction.)
• When installing your wired remote controller on the wall, consider the size of the wire hole, and select a wire
with a proper thickness.
• Wire that is connectable to wired remote controller PCB.
- If you install the wired remote controller by reclaiming, install it according to U-terminal cable specication.
- If you install the Wired Remote Controller by using two pieces of PVC wire, remove the 30 cm(12 inch) of the
sheath of the cable and install it only with the two pieces of wires. (Recommended specication: AWG20)
- The followings are the specs of the compressed ring terminal connectable to your wired remote controller PCB
W
t
G
E
F
L
Stud D
Stud
Range of Permitted
Wires Rated Size Stud Size Basic Size (mm)
AWG mm2mm2mm tøD G E F W L
22 ~ 16 0.25 ~ 1.65 1.5 30.7 3.8 10.0 4.5 6.5 6.0 21.2
Maximum distance for connection between communication cable and power
cable: 100m
- ScrewsonthePCBterminalmustbetightenedwithlessthan6N•mtighteningtorque.Ifthetighteningtorque
is greater, it may damage the screw thread.
CAUTION
DVM HT_HE RC-EU_IM_EN_DB68-03973A-06.indd 7 2017-05-25 오후 4:18:28
8
Wired remote controller installation
Tracking Hydro unit/Hydro unit HT from a wired remote controller
The number of Hydro unit/Hydro unit HT
currently detected
Display tracking is
being performed.
1. Tracking of your wired remote controller will automatically start when you turn on the power after installation.
2. If you want to perform tracking again after installation, press the Esc and Delete buttons at the same time for more
than 5 seconds.
The system will reset, and tracking will start again.
3. During the tracking, the total number of currently searched Hydro unit/Hydro unit HT will be displayed.
• If you want to do system reset for your wired remote controller, press the Esc and Delete buttons at the same
time for more than 5 seconds.
CAUTION
DVM HT_HE RC-EU_IM_EN_DB68-03973A-06.indd 8 2017-05-25 오후 4:18:28
9
ENGLISH
Individual control with your wired remote controller
Individual control means that you are using one remote controller to control one indoor unit or one Hydro unit/Hydro
unit HT.
When connecting the Hydro unit/Hydro unit HT only
Outdoor unit
COM1(F1, F2)
COM2(F3, F4) COM2(F3, F4)COM2(F3, F4)
COM1(F1, F2)
Hydro
unit/
Hydro
unit HT
Wired remote
controller
Wired remote
controller
Wired remote
controller
Hydro
unit/
Hydro
unit HT
Hydro
unit/
Hydro
unit HT
• Regardless of the Hydro unit/Hydro unit HT group address (RMC address) setting, only the Hydro unit/Hydro unit
HT connected to COM2 is individually controlled.
CAUTION
DVM HT_HE RC-EU_IM_EN_DB68-03973A-06.indd 9 2017-05-25 오후 4:18:28
10
Wired remote controller installation
Group control with your wired remote controller
Group control means that you are using one wired remote controller to control two or more Hydro unit/Hydro unit HTs at
the same time.
When connecting the Hydro unit/Hydro unit HT only
1) Using one wired remote controller to control three Hydro unit/Hydro unit HTs
Outdoor unit
COM1(F1, F2)COM1(F1, F2)
COM2(F3, F4) COM2(F3, F4)
COM1(F1, F2)
Hydro
unit/
Hydro
unit HT
Wired remote
controller
Hydro
unit/
Hydro
unit HT
Hydro
unit/
Hydro
unit HT
2) Using one wired remote controller to control Hydro unit/Hydro unit HTs connected to dierent outdoor unit
Outdoor unit
Outdoor unit
COM1(F1, F2)
COM1(F1, F2)
COM2(F3, F4)
COM2(F3, F4)
Hydro
unit/
Hydro
unit HT
Hydro
unit/
Hydro
unit HT
Wired remote
controller
• Regardless of the Hydro unit/Hydro unit HT group address (RMC address), only the Hydro unit/Hydro unit HTs
connected to COM2 are controlled in group.
• Regardless of your outdoor units, you can control a maximum of 16 Hydro unit/Hydro unit HTs as a group.
CAUTION
DVM HT_HE RC-EU_IM_EN_DB68-03973A-06.indd 10 2017-05-25 오후 4:18:29
Ce manuel convient aux modèles suivants
2
Table des matières
Autres manuels Samsung Télécommande
Samsung
Samsung MWR-SH11N Manuel utilisateur
Samsung
Samsung MWR-TH00 Manuel utilisateur
Samsung
Samsung 6 series Manuel utilisateur
Samsung
Samsung UE43MU6179UXZG Manuel utilisateur
Samsung
Samsung MR-BH01 Manuel utilisateur
Samsung
Samsung MWR-WG00UN Manuel utilisateur
Samsung
Samsung MWR-WE13N Manuel utilisateur
Samsung
Samsung LED-C9000 RMC30C1 Manuel utilisateur
Samsung
Samsung SolarCell Remote Manuel utilisateur
Samsung
Samsung SMART TV Mode d’emploi
Samsung
Samsung SWPZ01-RX Manuel utilisateur
Samsung
Samsung MIM-E03*N Manuel utilisateur
Samsung
Samsung MWR-WG00UN Manuel utilisateur
Samsung
Samsung MWR-WE11N Manuel utilisateur
Samsung
Samsung MWR-WE10 Manuel utilisateur
Samsung
Samsung AA5900818A Manuel utilisateur
Samsung
Samsung MWR-WW10JN Manuel utilisateur
Samsung
Samsung MWR-WE10 Manuel utilisateur
Samsung
Samsung Smart Remote BN68 Series Manuel utilisateur
Samsung
Samsung RMC-QTD1 Manuel utilisateur
Manuels Télécommande populaires d'autres marques
Panasonic
Panasonic EUR7622KB0 Manuel utilisateur
Bang & Olufsen
Bang & Olufsen Beo4 Manuel utilisateur
Sunwave Tech.
Sunwave Tech. RemoteComm SRC-7000 Manuel utilisateur
Multiplex
Multiplex PROFI TX 9 Manuel utilisateur
One Remote
One Remote RMB4 Manuel utilisateur
FUTABA
FUTABA 9ZAP - PART2 Manuel utilisateur
