Salus Optima S Manuel utilisateur
For other language versions, please visit: www.salusinc.com
!
Optima!S!Thermostat!
!
User!Manual!
ii!Salus
!
SAFETY'INSTRUCTIONS'
Please read these instructions carefully before installing and using
the Optima S Thermostat. This manual is meant to be used as a
reference guide for the installation, configuration and maintenance of
your device.
• Follow all local and electricity supplier regulations regarding the
installation or replacement of a thermostat. An authorized,
qualified installer may be required.
• Do not connect any of the terminals to the 110/220 VAC
supply. The Optima S Thermostat uses two AA batteries or a 24
VAC power source.
• Do not cover any of the vents on the thermostat.
• Do not install this unit at an altitude of over 2000 meters.
• Do not place the unit in a bathroom or area of excessive moisture.
• Do not allow the unit to get wet. This device serves as a
temperature control system only in dry, closed living and office
spaces.
Optima S Thermostat iii
!
• Do not expose the unit to temperatures below 5°C or above 40°C,
humidity above 80%, or pollution above level 2.
• Do not expose the unit to voltage fluctuations more than +/- 10%.
• Do not use solvents or aggressive cleaning agents. A dry, soft
cloth is recommended.
The manufacturer does not accept responsibility for any damage
caused by not following these instructions.
'
iv!Salus
!
CONTENTS'
IN#THE#BOX# 1!
CONTROLS#AND#DISPLAY# 2!
BUTTONS! 2!
INDICATORS! 3!
HOME!SCREEN! 6!
INSTALLING#THE#THERMOSTAT# 7!
TOOLS! 7!
TURN!OFF!POWER!TO!HVAC!SYSTEM! 8!
DETERMINE!WIRING!CONFIGURATION! 8!
REMOVE!OLD!THERMOSTAT!10!
INSTALL!MOUNTING!PLATE!10!
ATTACH!WIRING!11!
CHECK!THE!BATTERIES!12!
INITIAL!CONFIGURATION!12!
ATTACH!THERMOSTAT!TO!MOUNTING!PLATE!14!
TURN!POWER!BACK!ON!TO!THE!HVAC!SYSTEM!14!
CONFIGURE!THERMOSTAT!15!
USING#THE#THERMOSTAT#HOME#SCREEN#15!
Optima S Thermostat v
!
CHANGING!THE!SET!POINT!TEMPERATURE!15!
HOLDING!A!SET!POINT!TEMPERATURE!16!
CHANGING!THE!OPERATING!MODE!17!
TURNING!ON!THE!FAN!18!
CONFIGURING#THE#THERMOSTAT#18!
CONFIGURATION!SCREENS!19!
SETTINGS/FUNCTIONS!21!
!"!#$%&$'(#)'$*)+,#-!..........................................................................................!21!
."!/',01#+$--!..........................................................................................................!21!
2"!3,-&4(5*%63$!.....................................................................................................!21!
7"!3,-&4(5*6+*#,%$!................................................................................................!21!
8"!-$#*&6,+#*-&(+!...................................................................................................!22!
9"!:'6-#*&'6#$;#*&6,+#!.......................................................................................!22!
<"!6::-$#!...................................................................................................................!22!
="!4(+0)(0$!.............................................................................................................!23!
>"!'$0,6+!...................................................................................................................!23!
!?"!$@),&%$+#*#5&$!..............................................................................................!23!
!!"!:(+*;6+#'64*A*'$B$'-,+0*B(4B$!................................................................!23!
!."!;46;C*:6'%(#D!................................................................................................!24!
!2"!,3$+#,:5!.............................................................................................................!24!
!7"!-#('#*&(,',+0!...................................................................................................!25!
vi!Salus
!
!8"!:(;#6'5*3$:()4#!............................................................................................!25!
SPECIFICATIONS#26!
TROUBLESHOOTING#27!
SALUS#WARRANTY#28!
APPENDIX#A#–#WIRING#DIAGRAMS#30!
TERMINAL!DEFINITIONS!30!
CONVENTIONAL!SINGLE!TRANSFORMER!HEAT!AND!COOL!SYSTEM!31!
CONVENTIONAL!TWO!TRANSFORMER!HEAT!AND!COOL!SYSTEM!32!
FLOOR!HEATING!SYSTEM!33!
SINGLE!TRANSFORMER!HEAT!PUMP!SYSTEM!34!
TWO!TRANSFORMER!HEAT!PUMP!SYSTEM!35!
APPENDIX#B#–#REGULATORY#STATEMENTS# 36!
FCC!STATEMENTS!36!
FCC!AND!INDUSTRY!CANADA!37!
INDUSTRY!CANADA!37!
'
Optima S Thermostat 1
!
IN'THE'BOX'
Thermostat with
Mounting Plate
Wall Plate
2 x Wood Screws,
2 x Wall Anchors, and
2 x Locking Pins
Wire Labels
2 x AA alkaline
batteries
User Manual
Setup
Instructions
2!Salus
!
CONTROLS'AND'DISPLAY'
Buttons'
There are six (6) button areas on the Optima
S touchscreen display as shown on the right
and defined below. The Reset button is a
recessed button on the bottom side surface
of the device, below the logo.
Button
Definition
Home Screen
Settings Screens
Main
Home Screen button
Not used
Returns display to Home
Screen
Mode
Operating mode select
(Heat, Cool, Auto or Off)
Change operating
mode
Not used: mode icons
are displayed if needed
Fan
Fan mode select
(On or Auto)
Change Fan mode or
set Permanent Hold
Not used
Settings
Device settings
Enter Settings
screens
Move between Settings
screens
Up
Increment or confirm
changes
Increase Set Point
Increment options /
Confirm
Down
Decrement or cancel
changes
Decrease Set Point
Decrement options /
Cancel
Reset
Restore device to Home screen
Reset
Optima S Thermostat 3
!
Indicators'
The following indicators are available on the LCD display.
Low Battery
Humidity
Display
Message Display
Time Display
Permanent
Hold Status Icon
Main
Temperature
Display
Auxiliary
Heat Icon
Network
Icon
Heat Icon
Mode Button
Outline
Cool Icon
Off Icon
Fan Auto Icon
Fan Icon
Permanent Hold Icon
Fan Status
Icon
Settings Icon
Fan Button Outline
Down Button
Outline
Up Button
Outline
Confirm Icon
Increment Icon
Cancel Icon
Decrement Icon
4!Salus
!
Indicator
Description
Full or Simple
Message Display
Alphanumeric display of HVAC status and
labels
Simple and Full
Time Display
Displays time in 12- or 24-hour format if
provided by the network
Full mode only
Main Temperature
Display
Displays the room temperature or set point
as required
Simple and Full
Permanent Hold
Status Icon
Indicates whether Permanent Hold is active
Simple and Full
Network Icon
Indicates when the thermostat is connected
to a smart home system
Full mode only
Mode Button
Outline
Identifies the boundaries of the Mode button
Full mode only
Mode Icons
HVAC operating modes as follows:
Off – System is OFF
Auto – Heat or Cool as required
Cool – AC or Cooling mode
Heat – Furnace or Heating mode
EmHeat – Emergency Heat mode
(Heat Pump only)
Simple and Full
Fan Icons
Fan operating modes as follows:
Auto – Fan ON while heating or cooling
On – Fan always ON
Simple and Full
Autres manuels pour Optima S
3
Autres manuels Salus Thermostat
Salus
Salus HTRP24 Manuel utilisateur
Salus
Salus ST620 Manuel du propriétaire
Salus
Salus ST620WBC Manuel utilisateur
Salus
Salus FC600-M Manuel utilisateur
Salus
Salus VS20 Manuel utilisateur
Salus
Salus QUANTUM SQ610RF Manuel utilisateur
Salus
Salus HTRS230V(30) Manuel utilisateur
Salus
Salus RT510 Manuel utilisateur
Salus
Salus ERT20 Manuel de service
Salus
Salus RT510BC+ Manuel utilisateur
Salus
Salus iT600 Series Manuel d'utilisation et d'installation
Salus
Salus RT510RF Manuel utilisateur
Salus
Salus DIGITAL PROGRAMMABLE THERMOSTAT Manuel utilisateur
Salus
Salus ERT20RF Manuel utilisateur
Salus
Salus VS30W Manuel utilisateur
Salus
Salus RT510RF Manuel utilisateur
Salus
Salus FC600 Manuel utilisateur
Salus
Salus STP1 Manuel utilisateur
Salus
Salus RT500 Manuel utilisateur
Salus
Salus ST620 Manuel utilisateur
Manuels Thermostat populaires d'autres marques
EWELLY
EWELLY EW-181 Manuel utilisateur
Prolon
Prolon T1100 Instructions d'installation
Computherm
Computherm Q20 Manuel utilisateur
Heatmiser
Heatmiser neoStat Manuel utilisateur
Aube Technologies
Aube Technologies TH111GFCI-NP 240 VCA Manuel utilisateur
Mars
Mars HEAT CONTROLLER IR Wireless Thermostat Manuel utilisateur
