Ruijie RG-AM5532 Manuel d'installation et d'exploitation

Ruijie RG-AM5532 Access Point

Hardware Installation and Reference Guide

Document Version: V1.04

Date: August 16, 2023

Networks

All rights are reserved in this document and this statement.

Any reproduction, excerption, backup, modification, transmission, translation or commercial

use of this document or any portion of this document, in any form or by any means, without

the prior written consent of Ruijie Networks is prohibited.

Trademark and are owned by Ruijie

Networks.

All other trademarks or registered trademarks mentioned in this document are owned by

their respective owners.

Disclaimer

The products, services, or features you purchase are subject to commercial contracts and

terms. Some or all of the products, services or features described in this document may not

be within the scope of your purchase or use. Unless otherwise agreed in the contract, Ruijie

Networks does not make any express or implied statement or guarantee for the content of

this document.

Due to product version upgrades or other reasons, the content of this document will be

updated from time to time. Ruijie Networks reserves the right to modify the content of the

document without any notice or prompt.

This manual is for reference only. Ruijie Networks endeavors to ensure content accuracy and

will not shoulder any responsibility for losses and damages caused due to content omissions,

inaccuracies or errors.

Preface

Intended Audience

This document is intended for:

Network engineers

Technical support and servicing engineers

Network administrators

Technical Support

Ruijie Networks Website: https://www.ruijienetworks.com/

Technical Support Website: https://ruijienetworks.com/support

Case Portal: https://caseportal.ruijienetworks.com

Community: https://community.ruijienetworks.com

Technical Support Email: service_rj@ruijienetworks.com

Live Chat: https://www.ruijienetworks.com/rita

Conventions

Signs

The signs used in this document are described as follows:

Warning

An alert that calls attention to important rules and information that if not understood or

followed can result in data loss or equipment damage.

Caution

An alert that calls attention to essential information that if not understood or followed can

result in function failure or performance degradation.

Note

An alert that contains additional or supplementary information that if not understood or

followed will not lead to serious consequences.

Specification

An alert that contains a description of product or version support.

Note

The manual offers configuration information (including model, port type and command line

interface) for indicative purpose only. In case of any discrepancy or inconsistency between

the manual and the actual version, the actual version prevails.

Hardware Installation and Reference Guide Product Introduction

Product Introduction

1.1 Product Overview

Following on from the RG-AM5528 and RG-AM5528(ES), RG-AM5532 is an i-Share+ dedicated

wireless access point (AP) released by Ruijie Networks for scenarios with high building

density, such as the campus network for dormitory buildings and the hospital network for

medical wards. The RG-AM5532 provides four optical ports, four copper ports, or two optical

ports and two copper ports for data uplinks. Four uplink copper ports can supply power to

four devices that support IEEE 802.3af or two devices that support IEEE 802.3at for expansion

of APs that support standard PoE. Based on the IEEE 802.11 protocol, the RG-AM5532 can

provide 24 RF modules by using Category-5 cables to deliver dual-band and two spatial-

stream performance for 24 rooms, with 600 Mbps bandwidth for each room. A total of 14.4

Gbps wireless throughput can be achieved, meeting the high-performance access

requirements in dormitory buildings. Important factors such as the wireless network

security, radio control, mobile access, Quality of Service (QoS), and seamless roaming are

fully taken into account for the RG-AM5532. Therefore, the RG-AM5532 can implement STA

data forwarding, security, and access control.

1.2 AP Specifications

1.2.1 RG-AM5532

Specifications

Product Model

RG-AM5532

Supported Optical

Module Type

For details, see Appendix B.

The module types may update without prior notification. Please

contact Ruijie Networks for details.

1000 Mbps Uplink

Copper Port

1000Base-T

SFP+ Port

10GBase-R or 1000Base-X

Hardware Installation and Reference Guide Product Introduction

Power Supply

Rated voltage range: 100 V AC to 240 V AC

Maximum voltage range: 90 V AC to 264 V AC

Frequency: 50/60 Hz

Rated current: 3 A

EEE Function

Supported

PoE Function

Supported. Four uplink copper ports can supply power to four

devices that support IEEE 802.3af or two devices that support IEEE

802.3at. When two uplink ports are used to supply power to two

devices that support IEEE 802.3at, the other two ports cannot be

used to supply power.

Overall Power

Consumption

Less than 300 W with full load

Operating

Temperature

0ºC to 45ºC (32°F to 113°F)

Storage

Temperature

–40°C to +70°C (–40°F to +158°F)

Operating

Humidity

5% to 95% RH

Storage Humidity

5% to 95% RH

Fans

Dual-fan design

Regulatory

compliance

EN 55032, EN 55035, EN 61000-3-3, EN IEC 61000-3-2, ETSI EN 300

386, IEC 62368-1, and EN 62368-1

Dimensions (W ×

D × H)

440 mm × 360 mm × 44 mm (17.32 in. x 14.17 in. x 1.73 in.)

Weight

5.8 kg (12.79 lbs, including the package)

Hardware Installation and Reference Guide Product Introduction

Caution

This is a Class A product. In a domestic environment, this product may cause radio

interference. In this case, users are advised to take proper measures against the

interference.

The following symbol on the product nameplate indicates that the RG-AM5532 is applicable

only to areas below 2000 m (6561.68 ft.) above sea level.

Product Appearance

The front panel of the RG-AM5532 provides 24 × 10/100/1000Base-T Ethernet ports, 4 × 1000

Mbps uplink copper ports, 4 × 10 Gbps SFP+ optical ports, and one console port. The rear

panel has an AC power connector.

Figure 1-1 Appearance of the RG-AM5532

Front Panel

Figure 1-2 Front Panel of the RG-AM5532

Hardware Installation and Reference Guide Product Introduction

Description 1. RG-AM5532 status LED

2. Power button

3. Console port

4. 10/100/1000Base-T auto-sensing

Ethernet port

5. Copper port status LED

6. 1000Base-T 1000 Mbps uplink

copper port

7. 4 × 10 Gbps SFP+ optical ports

Caution

To change the mode of the port status LED (to switching or PoE mode), you can press and hold the power

button for over two seconds.

Port Modes

Ports 25 to 32 on the RG-AM5532 can work in three modes. Only a maximum of four ports

can work simultaneously in each mode.

(1) Mixed mode: two optical ports and two copper ports. As shown in the following figure,

ports 27, 28, 31, and 32 are working simultaneously.

(2) 4GE mode: four copper ports. As shown in the following figure, ports 25 to 28 are 1000

Mbps uplink copper ports, while ports 29 to 32 are not working.

(3) 4SFP+ mode: four optical ports. As shown in the following figure, ports 29 to 32 are 10

Gbps uplink optical ports, while ports 25 to 28 are not working.

Figure 1-3 Port Modes of the RG-AM5532

Hardware Installation and Reference Guide Product Introduction

Rear Panel

Figure 1-4 Rear Panel of the RG-AM5532

Desc

ripti

1. Three-pin AC power

connector

2. Grounding stud

Power Supply

The RG-AM5532 adopts AC input and high voltage DC/AC input.

Rated voltage range: 100 V to 240 V

Maximum voltage range: 90 V to 240 V

Frequency: 50/60 Hz

Rated current: 3 A

Power cord requirements: 10 A power cord

Heat Dissipation Solution

The RG-AM5532 adopts the dual-fan design. To ensure proper heat dissipation, maintain a

minimum clearance of 10 cm (3.94 in.) around the device for air circulation. To install the AP

on a rack, it is recommended to install the AP at a spacing of 1 U. Do not stack the AP. Handle

the AP by strictly following the instructions. Avoid blocking the vents; otherwise, the heat

dissipation of the device will be affected. Dust the device every three months to avoid

blocking the ventilation openings.

Figure 1-5 Heat Dissipation of the RG-AM5532

Hardware Installation and Reference Guide Product Introduction

LEDs

LED

Identifier

on the

Panel

Status

Description

Status LED Status

Off The RG-AM5532 is not powered on.

Blinking

green

The RG-AM5532 is being initialized.

Continuous blinking indicates a fault.

Steady green The RG-AM5532 is normally running.

Steady red An exception occurs.

1000 Mbps

RJ45 port

LED

(power

supply

mode)

1 to 24

Steady green The port is supplying power to an

external device.

Steady yellow The port is not supplying power to an

external device.

1000 Mbps

RJ45 port

LED

1 to 24

Off No link is detected for this port.

Steady green The port has made a successful 1000

Mbps link.

Table des matières

Autres manuels Ruijie Point d'accès sans fil

Ruijie

Ruijie Reyee RAP6260-D Manuel d'installation et d'exploitation

Ruijie

Ruijie Reyee RG-RAP2260 Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-EAP602 Series Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-AP810-L Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-AP180(V3) Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-AP520 Series Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-AP630 IDA2 Series Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-AP180 Series Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-AP820-L(V2) Series Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-AP680-IO Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-AP130(W2) V2 Series Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-AP840-L Manuel d'installation et d'exploitation

Ruijie

Ruijie Reyee Series Manuel utilisateur

Ruijie

Ruijie RG-AP730-L Series Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-AP680-A Manuel d'installation et d'exploitation

Ruijie

Ruijie Reyee RG-RAP73HD Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-MAP852-SF-U Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-AP130(L) Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-MAP852-SF-M Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-AP720-L Series Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-AP680 CD Series Manuel d'installation et d'exploitation

Ruijie

Ruijie Reyee RG-RAP1260 Manuel d'installation et d'exploitation

Ruijie

Ruijie Reyee RG-RAP2200 Manuel d'installation et d'exploitation

Ruijie

Ruijie RG-AP220 Series Manuel utilisateur

Manuels Point d'accès sans fil populaires d'autres marques

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Manuel utilisateur

Ubiquiti

Ubiquiti NanoStation NSM2 Manuel utilisateur

Cisco

Cisco Aironet 1550 Series Manuel utilisateur

Aruba

Aruba IAP-335 Manuel utilisateur

Advantek Networks

Advantek Networks AWN-AP-54MR Manuel utilisateur

IP-COM

IP-COM AP355 Manuel utilisateur

Buffalo

Buffalo AirStation WLA-L11G Manuel utilisateur

EnGenius

EnGenius EnStationACv2 Manuel utilisateur

D-Link

D-Link DAP-3662 Manuel utilisateur

xG Technology

xG Technology xMax CN1300 Manuel utilisateur

Widelink

Widelink ezWave WAP-1100 Series Manuel utilisateur

Edimax

Edimax CAP1200 Manuel utilisateur

Ubiquiti

Ubiquiti LBE-5AC-Gen2 Manuel utilisateur

Aruba

Aruba AP-203R Manuel utilisateur

LuXout Shades

LuXout Shades LUXSHADE MOTION Manuel utilisateur

CreatComm

CreatComm TB5F Manuel utilisateur

SineDigital

SineDigital MW-1500AP(H) Manuel utilisateur

TP-Link

TP-Link AP9650 V1 Manuel utilisateur