Reed Instruments R9910SD Manuel utilisateur
Data Logging
Air Quality
Meter
Instruction
Manual
R9910SD
REED Instruments
2
Table of Contents
Introduction ................................................................................................ 3
Product Quality........................................................................................... 4
Safety ......................................................................................................... 4
Features...................................................................................................... 4
Included...................................................................................................... 4
Specications..........................................................................................5-6
Instrument Description............................................................................... 7
Display Description .................................................................................... 8
Operating Instructions...........................................................................9-11
Power ON/OFF ...................................................................................... 9
Selecting Measurement Modes ............................................................. 9
Humidity/Temperature Mode ............................................................... 10
Dew Point Measurement Mode ........................................................... 10
Wet Bulb Temperature Measurement Mode ........................................ 10
CO/Temperature Measurement Mode ................................................. 10
O2/Temperature Measurement Mode................................................... 10
CO2/Temperature Measurement Mode................................................ 11
Data Hold ............................................................................................. 11
Recording Maximum and Minimum Readings..................................... 11
Backlight .............................................................................................. 11
Setup Mode.........................................................................................12-16
Formatting the SD Card (Sd F)......................................................12-13
Setting the Time and Date (dAtE)....................................................... 13
Setting the Data Logging Sampling Rate (SP-t) ................................. 13
Enabling/Disabling Auto Power Off (PoFF)......................................... 14
Enabling/Disabling the Beeper (bEEP) ............................................... 14
Setting Data Decimal Format (dEC).................................................... 14
Selecting the Temperature Unit of Measure (t-CF)............................. 15
Setting Alarm Value for CO2............................................................... 15
continued...
REED Instruments
3
Advanced Setup Mode (CO2mode only) ........................................... 15
Setting CO2Height Compensation Value (m).................................. 15
Setting CO2Height Compensation Value (ft)................................... 15
ESC .................................................................................................... 15
Verify Set Time and Date.................................................................... 16
Verify Sampling Rate .......................................................................... 16
Data Logging.......................................................................................16-22
Data Recording Modes....................................................................... 16
Manual Data Logging Mode ..........................................................16-17
Automatic Data Logging Mode .......................................................... 17
Transferring Data from the SD Memory Card to a Computer........17-21
Calibration of O2Sensor..................................................................... 21
Data Stream Output ................................................................................. 22
3.5mm Terminal to RS-232 Serial Connection ................................... 22
System Reset ........................................................................................... 23
Battery Replacement................................................................................ 23
Applications.............................................................................................. 23
Accessories and Replacement Parts ....................................................... 24
Frequently Asked Questions (FAQ's)...................................................24-25
Product Care ............................................................................................ 25
Product Warranty ..................................................................................... 26
Product Disposal and Recycling .............................................................. 26
Product Support....................................................................................... 26
Introduction
Thank you for purchasing your REED R9910SD Data Logging Air Quality
Meter. Please read the following instructions carefully before using your
instrument. By following the steps outlined in this manual your meter will
provide years of reliable service.
REED Instruments
4
Product Quality
This product has been manufactured in an ISO9001 facility and has been
calibrated during the manufacturing process to meet the stated product
specications. If a certicate of calibration is required please contact the
nearest authorized REED distributor or authorized Service Center. Please
note an additional fee for this service will apply.
Safety
Never attempt to repair or modify your instrument. Dismantling your
product, other than for the purpose of replacing batteries, may cause
damage that will not be covered under the manufacturer's warranty.
Servicing should only be provided by an authorized service center.
Features
22
temperature and humidity
Included
REED Instruments
5
Specifications
Temperature
Humidity
CO2
Measuring Range: 0 to 4,000 ppm
Accuracy: < 999 ppm: ±40 ppm
>1,000 ppm ≤3000 ppm: ±5% rdg
>3,000 ppm: ±250 ppm
Resolution: 1 ppm
CO
Measuring Range: 0 to 1,000 ppm
Resolution: 1 ppm
O2
Measuring Range: 0 to 30% O2
2)
Resolution: 0.10%
continued...
REED Instruments
6
General Specifications
Alarm Threshold: <18% O2
Response Time: 1 second
Display: 4-digit dual LCD
Backlit Display: Yes
Min: Yes
Datalogging Capabilities: Yes
Real-Time Clock
and Date Stamp: Yes
Selectable Sampling Rate: Yes (1 second to 8 hours, 59 minutes
and 59 seconds)
card (optional)
Kick Stand: Yes
Tripod Mountable: Yes
Low Battery Indicator: Yes
Power Supply:
Data Output: Yes (RS-232)
Product Certications: CE
CO2
O2
Weight: 0.8lb (350g)
REED Instruments
7
Instrument Description
Air Quality Meter
SD Series Data Logger
TIME
LOG/SET
FUNCTION
SAMPLING
CHECK
ALARM
POWER
HOLD
ESC
REC
ENTER
R9910SD
2
3
4
5
6
7
8
910
11
12
13
14
15
16 17
18
19
20
21
22
23
24
25
26
1. POWER
ALARM Button
3. TIME Button
4. SD Card Slot
5. LCD Display
6.
7. Button
Button
9.
Button
10. RS-232 Output Jack
11. Reset Pin
12. Power Adapter Input Jack
13. Tripod Mounting Screw
14. Battery Cover
15. Kickstand
17. O2
18. CO2Input Jacket
21. CO2
22. CO2Probe Plug
23. O2
24. O2Probe Plug
26. CO Probe Plug
REED Instruments
8
Display Description
DEW
3
6
10111213
DATARECORD
%RH
PPM
CO
2
22Mode Indicators
Temperature Measurement
Reading
4. Data Logging Status Indicator
5. SD Card Status Indicator
of Measure
8. Measurement Reading
Indicator
9. CO2Sensor Signal
Indicators
11. Record Mode Indicator
13. Low Battery Indicator
REED Instruments
9
Operating Instructions
Power ON/OFF
Turn the meter on by pressing the POWER button. To turn the meter off,
press and hold the POWER button for 2 seconds.
Note:
adapter (sold separately).
Selecting Measurement Modes
The R9910SD has 6 measurement modes:
2
2
Note:
2, and either the O2or the CO Probe. The meter will data log
all three values, however, only one value can be displayed at a time on the
LCD screen.
2, and either the O2or CO Probe into
the meter.
22
2
(for O2
continued...
REED Instruments
10
Humidity/Temperature Measurement Mode
Selecting
Measurement Modes for details).
2. The top part of the display will leave the humidity
value, and the lower part of the display will show
the temperature value as shown.
Dew Point Measurement Mode
Selecting
Measurement Modes for details).
2. The top part of the display will indicate the Dew
Point value while the lower part of the display will
Wet Bulb Temperature Measurement Mode
Selecting Measurement Modes for details).
2. The LCD display will indicate the wet bulb value
as shown.
Note: The wet bulb value is automatically calculated
CO/Temperature Measurement Mode
Selecting
Measurement Modes for details).
2. The top part of the display will indicate the CO
value in PPM, and the lower part of the display
will show the temperature value as shown.
O2/Temperature Measurement Mode
2
Selecting
Measurement Modes for details).
2. The top part of the display will indicate the
O
2
%
value, and the lower part of the display will show
the temperature value as shown.
continued...
%RH
DEW
PPM
CO
%
O
2
REED Instruments
Table des matières
Autres manuels Reed Instruments Instrument de mesure
Reed Instruments
Reed Instruments R1620 Manuel utilisateur
Reed Instruments
Reed Instruments R1600 Manuel utilisateur
Reed Instruments
Reed Instruments R8070SD Manuel utilisateur
Reed Instruments
Reed Instruments R6013 Manuel utilisateur
Reed Instruments
Reed Instruments LM-8000 Manuel utilisateur
Reed Instruments
Reed Instruments Smart Series Manuel utilisateur
Reed Instruments
Reed Instruments R8050 Manuel utilisateur
Reed Instruments
Reed Instruments R4700SD Manuel utilisateur
Reed Instruments
Reed Instruments Smart R1610 Manuel utilisateur
Reed Instruments
Reed Instruments R7700 Manuel utilisateur
Reed Instruments
Reed Instruments R9920 Manuel utilisateur
Reed Instruments
Reed Instruments R9260 Manuel utilisateur
Reed Instruments
Reed Instruments SMART Series Manuel utilisateur
Reed Instruments
Reed Instruments R8180 Manuel utilisateur
Reed Instruments
Reed Instruments R9230 Manuel utilisateur
Reed Instruments
Reed Instruments R7050 Manuel utilisateur
Reed Instruments
Reed Instruments SMART Series Manuel utilisateur
Reed Instruments
Reed Instruments LM-81HT Manuel utilisateur
Reed Instruments
Reed Instruments R8085 Manuel utilisateur
Reed Instruments
Reed Instruments R9510 Manuel utilisateur
Manuels Instrument de mesure populaires d'autres marques
Endress+Hauser
Endress+Hauser Proline Promag 50 Caractéristiques techniques
Siemens
Siemens SITRANS F Coriolis FCT030 Manuel de la liste des pièces
KLINGER
KLINGER CMF V Series Manuel utilisateur
EXFO
EXFO FTB-2 Manuel d'exploitation et d'entretien
Keysight
Keysight M8290A Manuel utilisateur
ADTEK
ADTEK MW-5 Manuel utilisateur