Quantum Maxtor Fireball lct10 Manuel utilisateur

Jumper Settings

DS CS PK Rsvd

Stand Alone (Default) ON OFF XOFF

Master with Slave Present ON OFF XOFF

Slave to Master OFF OFF XOFF

Cable Select * OFF ON XOFF

X= PK is a Parking position. The presence or absence of this jumper has no effect on the drive. Labeling may

indicate to place this jumper when configuring as a slave. This is to provide for retention of the jumper in the

event that it is needed later.

*Note: Cable Select (CS) utilizes a special cable configuration where the drive setting (Master or Slave) is

determined by its position on the 40-pin ATA cable. In this type of configuration both drives will have their

jumper set to CS. Cable Select is utilized on some OEM systems and is typically required for systems utilizing

Ultra ATA/66. For Ultra ATA/66 compliant cables, the master drive is placed on the outside (end) cable

on the intermediate cable connector.connector and the slave drive is placed

Fireball lct10

fireball_lct10_jumper.pdf

1 of 1

Fireball lct10

fireball_lct10_jumper.pdf

Jumper Locations

The Maxtor® Fireball™ lct10 disk drive has only one location where user configurable jumpers are found. The

jumper block is incorporated into the ATA / IDE cable connector. Using the jumper pins you can establish the drive

Master/Slave configuration.

The Maxtor Fireball lct10 was developed by Quantum Corporation prior to its merger with Maxtor.

BIOS Settings

The following BIOS parameters are provided for customers needing to manually configure the Fireball lct10 disk

drive. Both base 2 and base 10 capacity values are displayed.

5.1 GB 10.2 GB 15.0 GB 20.4 GB 30.0 GB

Logical Cylinders 10,585 16,383 * 16,383 * 16,383 * 16,383 *

Logical Heads 15 16 16 16 16

Logical Sectors/Track 63 63 63 63 63

Total Logical Sectors 10,002,825 20,044,080 29,336,832 39,876,480 58,633,344

Base 10 Capacity 5,121 MB 10,262 MB 15,020 MB 20,416 MB 30,020 MB

Base 2 Capacity 4,884 MB 9,787 MB 14,324 MB 19,470 MB 28,629 MB

*Note: ATA (IDE) drives with a physical capacity greater than 8.4GB have their default logical C/H/S values limited

to 16,383/16/63 as per the ATA-4 specification. Drives greater than 8.4GB in capacity require LBA support.

Capacity could be restricted to 8.4GB (or less) due to system BIOS limitations. Check with your system or

motherboard manufacturer to determine if your BIOS supports LBA mode for ATA hard drives greater than 8.4GB.

2 of 2

Fireball lct10

fireball_lct10_jumper.pdf

3 of 3

Special Considerations

BIOS/Operating System Limitations

Hard drives greater than 2.1GB may need to be divided into multiple partitions / logical drives. MS-DOS versions

4.0 through 6.22 allow a maximum primary partition / logical drive size of 2.1GB and are limited to 8.4GB in

physical drive capacity. The file systems supported by Windows 95, Windows 98 and Windows NT are not restricted

to the 8.4GB physical drive limit, but LBA support in the system BIOS is required.

Hard drives greater than 8.4GB in capacity may be restricted to 8.4GB (or less) due to system BIOS limitations,

operating system limitations, or both. Check with your system manufacturer to determine if your BIOS supports

the correct LBA extensions for hard drives greater than 8.4GB.

Ultra ATA/66 Operation

In order to achieve the Ultra ATA/66 transfer speed, you must have a system and a BIOS that will support Ultra

ATA/66. The correct drivers must be loaded, and an Ultra ATA specific data cable must be used. The Ultra ATA

cables use the Cable Select (CS) method rather than the Drive Select (DS) master/slave scheme, so the drive must

be jumpered to enable Cable Select. Please review our application note entitled Ultra ATA System Requirements for

further details.

Drive Mounting/Handling Precautions

It is highly recommended that the hard drive be mounted on to the chassis of the system being used for general

operation as well as for test purposes. Failure to hard mount the drive can result in erroneous errors during testing

or normal operation. Please review our ATA Configuration Card for specifications on drive mounting.

Warning: Never allow objects to come into direct contact with the hard drive’s printed circuit board (PCB) during

operation. This could result in an electrical short and cause irreparable damage to the hard drive as well as loss of

all data. Please observe proper mounting guidelines and specifications as described above when power is applied to

the hard drive.

For Further Review:

• ATA Configuration Card (Includes Drive Mounting)

• ATA Installation Flowchart

• ATA Installation Guide for Windows NT

• ATA Installation Guide for Windows95/98

• BIOS Support for logical cylinder values > 4095

• DOS/Windows 95 logical drive limitations

• Knowledge Base

• Windows NT 4.0 Capacity Issue

• The Ultra ATA/66 bus interface

• Ultra ATA/66 Compatibility with Award BIOS

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Quantum Stockage

Quantum

Quantum Travan 20GB Manuel utilisateur

Quantum

Quantum Scalar 50 Mode d’emploi

Quantum

Quantum Maxtor Fireball CR Manuel utilisateur

Quantum

Quantum PowerStor L200 Manuel utilisateur

Quantum

Quantum StorNext QD6000 Manuel utilisateur

Quantum

Quantum DXi V-Series Manuel utilisateur

Quantum

Quantum Scalar i40 Manuel utilisateur

Quantum

Quantum LTO-3 Manuel utilisateur

Quantum

Quantum P2000 Series Manuel utilisateur

Quantum

Quantum Superloader 3 Manuel utilisateur

Quantum

Quantum ATL 7100 Manuel

Quantum

Quantum Quantum Atlas 10K II 9.2/18.4/36.7/73.4 GB Manuel utilisateur

Quantum

Quantum Tape Drive A-Series Manuel utilisateur

Quantum

Quantum ValueLoader DLT VS160 Mode d'emploi

Quantum

Quantum QX Series Manuel utilisateur

Quantum

Quantum Tape Drive SDLT 600A Manuel utilisateur

Quantum

Quantum Scalar i500 Manuel utilisateur

Quantum

Quantum Scalar i500 Comment utiliser

Quantum

Quantum DAT 320 CD320UE Manuel utilisateur

Quantum

Quantum DLT 2500 Manuel utilisateur

Quantum

Quantum DXi3500 Manuel utilisateur

Quantum

Quantum PX720 Manuel utilisateur

Quantum

Quantum Scalar 24 Mode d'emploi

Quantum

Quantum DXi6900 Guide de démarrage rapide

Manuels Stockage populaires d'autres marques

QNAP

QNAP TS 32PXU Series Manuel utilisateur

LaCie

LaCie RUGGED RAID Manuel utilisateur

Freecom

Freecom CLS DOCK Manuel utilisateur

PNY

PNY Attache P-FD64MBATT3 Manuel utilisateur

HP StorageWorks MSL2024 Manuel utilisateur

OLT

OLT 6x6 Maximizer Manuel utilisateur

Transcend

Transcend JetFlash 160 Manuel utilisateur

LaCie

LaCie RUGGED MINI Manuel utilisateur

Thunderbolt

Thunderbolt 600 Manuel utilisateur

Panasonic

Panasonic LB-DH8 series Manuel

Intel

Intel RAID High Availability Manuel utilisateur

LaCie

LaCie 12big Thunderbolt 3 Manuel utilisateur

Spectra Logic

Spectra Logic T-Series Spectra T50e Manuel utilisateur

Panasonic

Panasonic LKM-F931-1 Manuel utilisateur

Tabernus

Tabernus Enterprise Erase E2400 Manuel utilisateur

Rocstor

Rocstor COMMANDER 3F series Manuel utilisateur

HP P9000 Manuel utilisateur

Western Digital

Western Digital Ultrastar Data60 Manuel utilisateur