Pro-Ject Audio Systems Align it Manuel utilisateur

INSTRUCTIONS FOR USE

Cartridge alignment tool

Pro-Ject Align it

mBeam

nTonearm type marks (1= 8,6’’ - 2= 9’’ - 3= 9,35’’ - 4= 10’’ - 5= 12’’)

oBeam fixing screw

pBeam adjustment mark

qScale

rAdjustment screw

sRod

tRod fixing screw

uOverhang marks

vBase with spindle hole

wMirror

Assembly

Slide the beam minto the groove in the base vfrom the right (see diagram). Make sure that the beam fixing

screw ois loosened far enough to allow the beam to move easily.

Using the tool

Loosen the rod's fixing screw tand remove the rod sfrom the beam. Place the tool on the turntable

platter so that the hole in the base vfits over the record spindle. Re-fit the rod sin the beam m.

By sliding the beam mto and fro adjust the cup on the end of the rod suntil it covers the tonearm's upper

bearing.

After making sure that the base vis flat on the platter, fix the rod's sposition by tightening the fixing screw t.

By reversing the rod so that the pointed end is downward the tool may be used to establish the

vertical axis of other manufacturer's tonearms.

Adjusting for tonearm length (1"= 2,54cm)

Make sure that the beam adjustment mark plines up with the tonearm type marks n(1– 5) on the beam.

Now adjust the beam and its guide using the adjustment screw runtil its edge aligns with the uppermost

line of the scale q.

Adjust the scale q(1/3 – 5)to the mark given in the following table appropriate to the Pro-Ject turntable type:

1For 0.5, 1, 1.2, 1.2 E, 1.2 Comfort, 1.9,Essential, Debut, Debut Esprit, Juke Box, Juke Box Esprit,

Xpression, Xpression Comfort and models equipped with a 8,6" tonearm

2For 6, 6.1, 6.9, Xperience, 2.9 Wood, 2.9 Classic, Perspective, PerspeX, RPM 4, RPM 5, RPM 5.1,

RPM 6, RPM 6 SB, RPM 6.1 SB, RPM 9, RPM 9 Acryl (X), RPM 9.1, RPM 9.1 Acryl (X),

RPM 9.2 Evolution, Studie, Xtension and models equipped with a 9" tonearm

3For 2and models equipped with a 9.35" tonearm

4For RPM 10, RPM 10.1 Evolution and models equipped with a 10" tonearm

5For Studie and models equipped with a 12" tonearm

After adjusting the scale, fix the beam's mposition by tightening the fixing screw o.

Cartridge alignment

Mount the cartridge under the headshell. Tighten the screws only enough to just fix the cartridge. Now adjust

the downforce approximately to the manufacturer's recommendation. Check the tonearm height adjustment

and adjust if necessary. Both tasks are described in the instructions supplied with your Pro-Ject record player.

Adjust the cartridge fore and aft using the elongated holes in the headshell so that the needle rests on the

correct overhang mark ufor the tonearm type (1 – 4) when the arm is lowered.

Now align the front edge of the cartridge to make it parallel to the lines which run the length of the base.

This adjustment is easier to perform if a thin propelling pencil lead is attached with sticky tape to the front of

the cartridge (provided that this has a flat front edge). Please remember to fasten the cartridge mounting

bolts tightly after completing adjustment. Check the adjustment again after tightening the bolts.

Adjusting azimuth

Loosen the grub screw which fixes the tonearm tube in position as explained in the instructions for use

accompanying your Pro-Ject record player. Lower the arm with the lift so that the needle comes to rest in the

middle of the tool's mirror w. Now revolve the tonearm until the needle is perpendicular to the mirror's

surface or until the cartridge's bottom edge is parallel to it. Re-tighten the grub screw. Re-check all

adjustments and repeat the procedures if necessary.

PRO-JECT is a Registered Trademark of H. Lichtenegger.

This guide was produced by: Audio Trade GmbH

The information was correct at the time of going to

press. The manufacturer reserves the right to make

changes to the technical specification without prior

notice as deemed necessary to uphold the ongoing

process of technical development.

Table des matières

Autres manuels Pro-Ject Audio Systems Platine

Pro-Ject Audio Systems

Pro-Ject Audio Systems ESSENTIAL III Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems Juke Box Esprit Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems Debut Carbon EVO Mode d'emploi

Pro-Ject Audio Systems

Pro-Ject Audio Systems Debut S Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems RPM 6.1 SB SuperPack Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems Align it DS3 Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems 9 Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems VC-S Mise à jour du firmware

Pro-Ject Audio Systems

Pro-Ject Audio Systems Debut III/Phono USB Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pro-Ject RPM 5 SuperPack Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems 2 Xperience Basic + Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems RPM 1 Carbon Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems Xtension 10 Evolution Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems T2 W Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems Debut Carbon DC Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems X2 Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems Debut Carbon DC Esprit SB Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pro-Ject VC-S Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems T1 Phono SB Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems 2Xperience Primary Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems 2 Xperience Basic + Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems Essential II DIGITAL Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems Xtensions 9 S-Shape Manuel utilisateur

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pro-Ject RPM 10 Manuel utilisateur

Manuels Platine populaires d'autres marques

Gemini

Gemini CDT-05 MKII Manuel utilisateur

Rotel

Rotel RP-820 Manuel utilisateur

Shuman

Shuman MC-250BT Manuel utilisateur

Stanton

Stanton STR8-150 Manuel utilisateur

Audio Technica

Audio Technica AT-LPW40WN Manuel utilisateur

Crosley

Crosley McQueen CR7011-GY Manuel utilisateur

Reloop

Reloop SMP-1 Manuel utilisateur

auna

auna TT-Classic Plus Manuel utilisateur

COMO AUDIO

COMO AUDIO Turntable Analog Manuel utilisateur

Dual

Dual 1009 F Manuel utilisateur

REED

REED Muse3C Manuel utilisateur

AXIOMTEK

AXIOMTEK OPS883-H Series Manuel utilisateur

Pioneer

Pioneer PL-71 Manuel utilisateur

Vestax

Vestax PDX-a1 Manuel utilisateur

Denon

Denon DP-400 Manuel utilisateur

Dual

Dual 504 Manuel utilisateur

Audio-Techica

Audio-Techica AT-LP60XBT Manuel utilisateur

Goldring

Goldring G99 Manuel utilisateur