Philips SRP3011 Manuel utilisateur
www.philips.com/support
User manual
Always there to help you
Register your product and get support at
SRP3011
Question?
Contact
Philips
2EN
1 Your universal
remote
Congratulations on your purchase, and
welcome to Philips! To fully benet from the
support that Philips offers, register your product
at www.philips.com/welcome
Introduction
With the universal remote, you can use it to
operate your device.
Overview of the universal
remote
a INPUT: select available source inputs
(antenna, cable, etc.).
: power on or off.
: LED indicator
b Digit buttons
I/II: select the audio channel.
-/--: select between one and two-gure
channel numbers.
c / / / : scroll the menu up/down/
left/right.
OK: conrm your selection.
d BACK: go back one menu level.
: mute
3EN
CH+/-: go to the next/previous channel.
VOL / : adjust the volume.
: menu on or off.
e / / / : teletext off/teletext mix/
teletext on/teletext hold
Red/Green/Yellow/Blue: context sensitivity
buttons
4EN
2 Get started
Insert batteries (not included)
Warning
• Check the battery polarity when inserting in the
battery compartment. Incorrect polarity may damage
the product.
Caution
• Risk of explosion! Keep batteries away from heat,
sunshine or re. Never discard batteries in re.
• Risk of decreased battery life! Never mix different
brands or types of batteries.
Note
• When you replace the batteries, all user settings will
be retained in the memory of the universal remote for
5 minutes.
Set up the universal remote
You must rst set up the universal remote
before operating your device.
Manual registration
1 Switch on your device.
2 Press and hold "1" and "6" at the same time
for 5 seconds until the blue LED is on.
3 Look up the 5-digit code for your brand
in the code list. Codes are listed by the
device type and brand name.The most
popular code is listed rst.
4 Enter the rst 5-digit code using the digit
buttons.
5EN
5 If the light is off, a valid code is saved.
Otherwise, the light will ash once, and
then remains on for code re-entry.
6 Operate the device with the universal
remote. If your device responds correctly,
it means you have entered the right code.
Otherwise, repeat from step 2, and enter
the second code on the list.
Note
• It is possible sometimes that your device only responds
to some of the buttons. In such case, set up with the
next code in the code list, and try operating your
device again.
Auto registration
1 Switch on your device.
2 Press and hold "1" and "6" at the same time
for 5 seconds until the blue LED is on.
3 Point at your device with the universal
remote.Then press and release to
start searching the code for your brand.
A different infrared signal is sent every 2
seconds as the universal remote searches,
indicated by a blue ash.
6EN
4 When the device is off, immediately press
and release OK to save the code.The blue
LED indicator will turn off.
5 Operate the device with the universal
remote. If your device responds correctly, it
means you have saved the right code.
Note
• Auto registration can be reversed, by pressing and
releasing once more during the auto registration
process.This is helpful if you missed out the chance to
press OK within 2 seconds. Make sure that the device
is rst powered on again.
• It is possible sometimes that your device only responds
to some of the buttons. In such case, set up with the
next code in the code list, and try operating your
device again.
max. 20
minutes
7EN
3 Notice
Disposal of your old product
and battery
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
This symbol on a product means that the
product is covered by European Directive
2012/19/EU.
This symbol means that the product contains
batteries covered by European Directive
2013/56/EU which cannot be disposed of with
normal household waste.
Inform yourself about the local separate
collection system for electrical and electronic
products and batteries. Follow local rules and
never dispose of the product and batteries
with normal household waste. Correct disposal
of old products and batteries helps prevent
negative consequences for the environment and
human health.
Removing the disposable batteries
To remove the disposable batteries, see section
‘Insert batteries’.
When this logo is attached to a product, it
means a nancial contribution has been paid to
the associated national recovery and recycling
system.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
8EN
4 Service and
support
Frequently asked questions
My universal remote does not work at all.
•Check if you have correctly setup the
device with the right code.
•Check if you have pressed the
corresponding device key for your device.
•Check if the batteries are inserted
properly. If the battery level is low, replace
the batteries.
•Check if your device is powered on.
If several device codes are listed under the
brand of my device, how can I select the
correct device code?
To seek the correct device code, test the codes
one by one.The codes are sorted by popularity,
and the most popular code is listed rst.
My device responds only to some of the
commands.
You have set a code for which only some
commands work properly but some do not.Try
other codes until most keys work properly.
Need help?
We advise you to rst read this user manual
carefully. It helps you set up and use the
universal remote.
If, however, you require extra information or
have additional questions about setup, usage,
warranty, etc of the SRP3011, you can always
contact us.
When calling our helpline, make sure to have
the SRP3011 at hand when you call, so that our
operators can help you determine whether
SRP3011 is working properly.
You will nd our contact details at the end of
this user manual.
For online support, visit
www.philips.com/support
Autres manuels pour SRP3011
1
Table des matières
Autres manuels Philips Télécommande
Philips
Philips SRC2063/27 Manuel utilisateur
Philips
Philips Pronto TSU9800 Manuel utilisateur
Philips
Philips Pronto NG Manuel utilisateur
Philips
Philips SRP6011 Manuel utilisateur
Philips
Philips SRU 530/86 Manuel utilisateur
Philips
Philips City line Manuel utilisateur
Philips
Philips RC1974503/00RF Manuel utilisateur
Philips
Philips SRU4105WM/17 Manuel utilisateur
Philips
Philips SRP4010 Manuel utilisateur
Philips
Philips 29PT8403/32 Manuel utilisateur
Philips
Philips 22AV8573 Manuel utilisateur
Philips
Philips SRU4002X/10 Manuel utilisateur
Philips
Philips IRT 9090 Manuel utilisateur
Philips
Philips SRU5130/53 Manuel utilisateur
Philips
Philips G96SVCAA01 Manuel utilisateur
Philips
Philips Perfect replacement SRC2063WM Manuel utilisateur
Philips
Philips SRU 5150/87 Manuel utilisateur
Philips
Philips SRU740NC/05 Manuel utilisateur
Philips
Philips 22AV1106B Manuel utilisateur
Philips
Philips 29PT9413/12 Manuel utilisateur
Manuels Télécommande populaires d'autres marques
Panasonic
Panasonic EUR7622KB0 Manuel utilisateur
Bang & Olufsen
Bang & Olufsen Beo4 Manuel utilisateur
Sunwave Tech.
Sunwave Tech. RemoteComm SRC-7000 Manuel utilisateur
Multiplex
Multiplex PROFI TX 9 Manuel utilisateur
One Remote
One Remote RMB4 Manuel utilisateur
FUTABA
FUTABA 9ZAP - PART2 Manuel utilisateur
