Outback RC4341C Manuel utilisateur

Photographs are not to scale.

Specifications subject to change

without prior notice.

WARNING

 For outdoor use only. Not for commercial use.

 Read instructions before using the appliance. Failure to follow instructions could

result in death, serious bodily injury, and/or property loss.

 Warning: accessible parts may be very hot. Keep young children and pets away.

 Do not move the appliance during use.

 Turn off the gas supply at the gas bottle after use.

 Any modification of the appliance, misuse, or failure to follow the instructions may be

dangerous and will invalidate your warranty. This does not affect your statutory rights.

 Retain these instructions for future reference.

 Leak test annually, and whenever the gas bottle is removed or replaced. Check that the

hose connections are tight and leak test each time you reconnect the gas bottle.

 For Flare-up control please refer to the ‘OPERATION’ section of this manual.

FOR YOUR SAFETY

If you smell gas:

1. Shut off gas to the appliance.

2. Extinguish any open flame.

3. Open barbecue lid or hood.

4. If odour continues, discontinue use and contact

your local dealer.

FOR YOUR SAFETY

1. Do not store or use petrol or other flammable

vapours or liquids in the vicinity of this or any

other appliance.

2. A gas bottle not connected for use shall not be

stored in the vicinity of this or any other

appliance.

RC4341C

Assembly and Operating Instructions for

Outback® Ranger 3 Gas/Charcoal Hybrid

2575 0359

Parts List

Quantities vary according to model purchased. Specifications subject to change without prior notice. For

more details on hardware, please see ‗Hardware Reference Diagram‘.

CODE PART QTY Ranger 3 Gas/Charcoal Hybrid

HOOD

A1 Hood (Pre-Assembled to Body) 1

A2 Hood Handle 1

A3 Heat Indicator 1

A4 Warming Rack 1

BODY

B1 Cooking Grill 2

B2 Round Grill 1

B3 Charcoal Basket 1

B4 Flame Tamer 3

B5 Barbecue Body 1

B6 Knob 3

B7 Control Panel 1

B8 Main Burner 3

B9 Drip Tray Handle 1

B10 Drip Tray 1

B11 Drip Tray Left Bracket 1

B12 Drip Tray Right Bracket 1

B13 Side Burner Valve, Hose and Regulator Assembly 1

TROLLEY

C1 Side Burner Shelf 1

C2 Side Burner Base 1

C3 Side Burner Ignitor 1

C4 Side Burner 1

C5 Side Burner Electrode 1

C6 Side Burner Grid 1

C7 Side Burner Knob 1

C8 Side Shelf 1

C9 Hook Rail 1

C10 Tool Hook 3

C11 Bottle Opener 1

C12 Left Front Leg 1

C13 Left Rear Leg 1

C14 Right Front Leg 1

C15 Right Rear Leg 1

C16 Front Screen 1

C17 Trolley Base 1

C18 Axle 1

C19 Wheel 2

C20 Hubcap 2

HARDWARE

D1 M5x15 Bolt 4

D2 M5 Washer 4

D3 M5 Nut 4

D4 M6x95 Bolt 8

D5 Spacer 8

D6 1/4-20UNCx25 Bolt 16 

D7 1/4-20UNCx12 Bolt 10 

D8 M6x10 Bolt 2

D9 M6x15 Bolt 4

D10 M6 Nut 4

D11 M4 Step Bolt 2

D12 M4x10 Bolt 2

D13 Wing Nut 1

D14 Locknut 2

 Pre-Assembled Component

Parts Diagrams

Quantities vary according to model purchased. Specifications subject to change without prior notice. For

more details on hardware, please see hardware pack page.

C13

C12

B13

B10

B11 B12

C15

C17

C20

C11

C10

C14

C19

D14

C18

C16

D13

Hardware Reference Diagram

Specifications subject to change without prior notice.

D1,D2,D3

D4,D5

D9,D10

D11

D12

M4 STEP BOLT 2PCS

M5X15 BOLT 4PCS M5 NUT 4PCS

M5 WASHER 4PCS

M6X10 BOLT 2PCS

1/4-20UNCX12 BOLT 8PCS

M6X15 BOLT 4PCS M6 NUT 4PCS

M4X10 BOLT 2PCS

1/4-20UNCX12

BOLT 2PCS

1/4-20UNCX25 BOLT 16PCS

M6X95 BOLT 8PCS SPACER 8PCS

Assembly

IMPORTANT!

 TOOLS NEEDED FOR ASSEMBLY: Medium size flat blade or Phillips/Crosspoint screwdriver,

adjustable spanner or metric spanner set.

 The assembly of this barbecue at least requires 2people.

 Remove any internal components or packaging from the barbecue body.

 Whilst every care is taken in the manufacture of this product, care must be taken during assembly in

case sharp edges are present.

 Please read the Important Information section carefully before assembly and use of your

barbecue.

Attach the Legs (C12,C13,C14,C15) onto Trolley Base (C17) use 1/4-20UNCx12 Bolts (D7x8pcs)

as shown.

Note: Ensure that the legs with the Velcro attached to them are at the front of the barbecue, with

the Velcro facing inwards.

Unscrew the Locknuts (D14x2pcs) from both ends of the Axle (C18). Slide the axle through the

corresponding holes in the left legs. Slide a Wheel (C19) over each end of the axle. Secure the

wheels into place with the locknuts. Place the Hubcaps (C20) ont the outsides of the wheels.

C20 C19

D14 C18

C14

C17

C12

C13

C15

Insert M6x95 Bolts (D4x8pcs) through the trolley legs, the Spacers (D5x8pcs), and keep the tip of

the bolts inside the spacers. While holding the barbecue body into position (2 people required),

screw the bolts into the barbecue body as shown.

CAUTION! Care must be taken to ensure the hood or lid does not fall open unexpectedly or

becomes damaged when it is set on the ground.

D5 D4

Attach the Drip Tray Left Bracket (B11) to the barbecue body using M5x15 Bolts (D1x2pcs), M5

Washers (D2x2pcs) and M5 Nuts (D3x2pcs) as shown. Repeat above process for Drip Tray Right

Bracket (B12).

NOTE: Ensure that the big tabs of the brakets which stop the drip tray are located at the

front of the barbecue.

FRONT

REAR

B11D1 D2 D3

Remove the retaining bolts from Drip Tray Handle (B9), and then attach it onto the Drip Tray (B10)

using the retaining bolts.

Insert the drip tray by sliding it underneath the barbecue body.

B10

Attach the Bottle Opener (C11) to the right front leg using 1/4-20UNCx12 Bolts (D7x2pcs).

C11

C9C10 C8

Attach the Tool Hooks (C10) to the Hook Rail (C9) as shown; make sure the direction of

tool hook is facing outwards. Attach the tool hook assembly to the Side Shelf (C8) using

M6x10 Bolts (D8x2pcs).

Attach the side shelf assembly to the Right Front / Rear Legs using 1/4-20UCNx25 Bolts

(D6x8pcs) as shown.

Attach the Side Burner Shelf (C1) to the Left Front / Rear Legs using 1/4-20UNCx25 Bolts

(D6x8pcs) as shown.

D6 C1

Unscrew the retaining nut from Side Burner Ignitor (C3). Insert the ignitor through the Side

Burner Base (C2) and secure with the retaining nut.

Carefully lay the side burner base into the side burner shelf horizontally, and fix it using

M6x15 Bolts (D9x4pcs) and M6 Nuts (D10x4pcs).

Retaining Nut

D10

Attach the side burner valve onto the side burner base using M4x10 Bolts (D12x2pcs) as shown.

Press the Side Burner Knob (C7) onto side burner valve stem.

D12

Table des matières

Autres manuels Outback Gril

Outback

Outback Omega 100 Manuel utilisateur

Outback

Outback Spectrum 2 Burner Manuel utilisateur

Outback

Outback Omega 200 Manuel utilisateur

Outback

Outback Meteor 4 Manuel utilisateur

Outback

Outback TS201 Manuel utilisateur

Outback

Outback Party FS5680 Manuel utilisateur

Outback

Outback Cuisine Manuel utilisateur

Outback

Outback THG3302S Manuel utilisateur

Outback

Outback Hunter Plus 3 Manuel utilisateur

Outback

Outback TPA101-6 Guide de référence rapide

Outback

Outback Spectrum 2 Burner Manuel utilisateur

Outback

Outback TPA101-4 Manuel utilisateur

Outback

Outback Meteor MT-H4461-3 Manuel utilisateur

Outback

Outback Spectrum 2 Burner Manuel utilisateur

Outback

Outback Jupiter 4 Manuel utilisateur

Outback

Outback Omega 100 Manuel utilisateur

Outback

Outback RB-H5060 Manuel utilisateur

Outback

Outback MH3230 Manuel utilisateur

Outback

Outback RC4340S Manuel utilisateur

Outback

Outback Diamond Hooded Manuel utilisateur

Outback

Outback PX-H4460 Manuel utilisateur

Outback

Outback THG2216AW Manuel utilisateur

Outback

Outback THG3710SS-3 Manuel utilisateur

Outback

Outback Excel 100 Manuel utilisateur

Manuels Gril populaires d'autres marques

Orbegozo

Orbegozo GR 2300 Manuel utilisateur

bora

bora PT11 Manuel utilisateur

Klarstein

Klarstein 10031664 Manuel utilisateur

Garland

Garland MWE3W Manuel utilisateur

Char-Broil

Char-Broil 463722714 Manuel utilisateur

Nexgrill

Nexgrill 720-0830HK Manuel utilisateur

Kenmore

Kenmore 415.16123800 Manuel utilisateur

Camp Chef

Camp Chef PG24CLAU Manuel utilisateur

Tucker Barbecues

Tucker Barbecues GTR Series Instructions de montage

Monogram

Monogram ZGG540NCP1SS Manuel utilisateur

Equipex

Equipex Sodir Savoy Manuel utilisateur

Gaggenau

Gaggenau VR 414 610 Manuel utilisateur

Miele

Miele KM 408-1 Manuel utilisateur

George Foreman

George Foreman GGR50B Manuel utilisateur

AOG

AOG T series Manuel utilisateur

Gorenje

Gorenje TG2000CB Mode d’emploi

Weber

Weber Genesis Silver-B Permamount NG 051701 Manuel utilisateur

Glen

Glen SA 3037 Manuel utilisateur