Milwaukee MW10 Manuel utilisateur

SPECIFICATIONS

Range 0.00 to 2.50 ppm

Resolution 0.01 ppm

Accuracy ±0.03 ppm ±3% of reading

@ 25 °C

Typical EMC Dev. ±0.01 ppm

Light Source Light Emitting Diode

@525nm

Light Detector Silicon Photocell

Method

Adaptation of USEPA method

330.5. The reaction between

free chlorine and the DPD

reagent causes a pink tint in

the sample.

Environment 0 to 50°C (32 to 122 °F)

max. 95% RH non-condensing

Battery Type 1 x 1.5V AAA

Auto-Shut O After 2 minutes of non-use

Dimensions 87.5 x 63.7 x 35.2 mm

(3.4 x 2.5 x 1.4”)

Weight 65 g (2.29 oz.)

OPTIONAL ACCESSORIES

Reagent Sets

MI526-25 Free Chlorine powder reagent,

25 pcs.

Other Accessories

3000100 Glass cuvettes with caps (2 pcs.)

3000200 Tissue fow wiping cuvettes

(2pcs.)

3000300 1.5V AAA batteries (4 pcs.)

CERTIFICATION

Milwaukee Instruments conform to

the CE European Directives.

Disposal of Electrical & Electronic

Equipment. Do not treat this product

as household waste. Hand it over

to the appropriate collection point

for the recycling of electrical and

electronic equipment.

Disposal of waste batteries. This product

contains batteries. Do not dispose of them with

other household waste. Hand them over to the

appropriate collection point for recycling.

Please note: proper product and battery disposal

prevents potential negative consequences

for human health and the environment. For

detailed information, contact your local

household waste disposal service or go to

www.milwaukeeinstruments.com (USA & CAN)

or www.milwaukeeinst.com.

RECOMMENDATION

Before using this product, make sure it is entirely

suitable for your specific application and for the

environment in which it is used. Any modification

introduced by the user to the supplied equipment

may compromise the tester’s performance. For

your and the tester’s safety do not use or store

the tester in hazardous environment. To avoid

damage or burn, do not perform any measurement

in microwave ovens.

WARRANTY

This instrument is warranted against defects

in materials and manufacturing for a period of

2years from the date of purchase. This warranty

is limited to repair or free of charge replacement if

the instrument cannot be repaired. Damage due to

accidents, misuse, tampering or lack of prescribed

maintenance is not covered by warranty. If

service is required, contact your local Milwaukee

Instruments Technical Service. If the repair is not

covered by the warranty, you will be notified of the

charges incurred. When shipping any instrument,

make sure it is properly packaged for complete

protection.

Milwaukee Instruments reserves the right to

make improvements in design, construction and

appearance of its products without advance notice.

ISTMW10 11/20

USER MANUAL

SATISFACTION

GUARANTEED

milwaukeeinstruments.com (USA & CAN)

milwaukeeinst.com

MW10 Digital

FreeChlorine Tester

PRELIMINARY EXAMINATION

Please examine this product carefully. Make

sure that the instrument is not damaged.

If any damage occured during shipment,

please notify your Dealer.

Each MW10 tester is supplied complete with:

yTwo Sample Cuvettes and Caps

ySix powder reagents for Free Chlorine

y1 x 1.5V AAA Battery

yInstruction Manual

FUNCTIONAL DESCRIPTION

1. Dust cover

2. Cuvette with cap

3. Cuvette holder

4. Liquid Crystal Display

5. Button

OPERATION

yTurn the tester on by pressing the button.

After all the segments are displayed, “C.1”,

“Add” appears with “Press” blinking, the

tester is ready.

yFill the cuvette with 10 mL of unreacted

sample and replace the cap. Place the

cuvette into the tester and close the

tester’s cap.

yPress the button. When the display shows

“Add”, “C.2” with “Press” blinking the tester

is zeroed.

yRemove the cuvette, open it and add the

content of one packet of MI526-0 reagent.

Replace the cap and shake gently for

20 seconds. Replace the cuvette into the

tester.

yWait for 1 minute and then press the button

or press and hold the button until the timer

is displayed on the LCD.

yThe instrument directly displays the

concentration of free chlorine in ppm.

The tester automatically turns o after

2minutes.

BATTERY REPLACEMENT

To save the battery, the instrument shuts down

after 2minutes of non-use. One fresh battery

lasts for a minimum of 5000measurements,

depending on the light level. When the

battery capacity is under 10% “bAt” appears

on the LCD at start-up.

If the battery is empty and accurate

measurements can’t be taken any more, the

instrument shows “bAd” then ”bAt” each

for 1 second and turns o. To restart the

instrument, the battery must be replaced with

a fresh one.

To replace the instrument’s battery, follow the

steps:

yTurn the instrument o by holding the

button until the tester shuts o.

yTurn the instrument upside down

and remove the battery cover with a

screwdriver.

yRemove the battery from its location and

replace it with a fresh one.

yInsert the battery cover and replace the

screw with a screwdriver.

Autres manuels Milwaukee Instrument de mesure

Milwaukee

Milwaukee MW14 Manuel utilisateur

Milwaukee

Milwaukee MW13 Manuel utilisateur

Milwaukee

Milwaukee M12 CLLP-301C Manuel utilisateur

Milwaukee

Milwaukee MI415 Manuel utilisateur

Milwaukee

Milwaukee SM700 Manuel utilisateur

Milwaukee

Milwaukee 48-22-9801 Manuel utilisateur

Milwaukee

Milwaukee MI405 Manuel utilisateur

Milwaukee

Milwaukee REDLITHIUM 3521-20 Manuel utilisateur

Milwaukee

Milwaukee MW100 Manuel utilisateur

Milwaukee

Milwaukee LDM 80 Manuel utilisateur

Milwaukee

Milwaukee MI 405 Manuel utilisateur

Milwaukee

Milwaukee MW12 Manuel utilisateur

Milwaukee

Milwaukee MW150 Manuel utilisateur

Milwaukee

Milwaukee CALIBRATION 2238-20 Mode d'emploi

Milwaukee

Milwaukee 2205-20 Manuel utilisateur

Milwaukee

Milwaukee MI405 Manuel utilisateur

Milwaukee

Milwaukee 3421 Manuel utilisateur

Milwaukee

Milwaukee pH600 Manuel utilisateur

Milwaukee

Milwaukee MI 106 Manuel utilisateur

Milwaukee

Milwaukee MA886 Manuel utilisateur

Milwaukee

Milwaukee 3631-20 Manuel utilisateur

Milwaukee

Milwaukee MAX MW160 Manuel utilisateur

Milwaukee

Milwaukee Smart Monitoring System SMS110 Manuel utilisateur

Milwaukee

Milwaukee LDM 45 Manuel utilisateur

Manuels Instrument de mesure populaires d'autres marques

Suaoki

Suaoki D40 Manuel utilisateur

Elster

Elster BK-G1.6 Manuel utilisateur

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manuel

Duratool

Duratool D03128 Manuel utilisateur

Vega

Vega VEGAPULS 65 Manuel utilisateur

Tonghui

Tonghui TH2618B Manuel utilisateur

Tenmars

Tenmars TM-801 Manuel utilisateur

MSR

MSR 145 Manuel utilisateur

TPS

TPS WP-82 Manuel utilisateur

ELMETRON

ELMETRON CP-511 Manuel utilisateur

PCB Piezotronics

PCB Piezotronics 003C30 Manuel utilisateur

Tenma

Tenma 72-10465 Manuel utilisateur

Endress+Hauser

Endress+Hauser Proline Promag 50 Caractéristiques techniques

Siemens

Siemens SITRANS F Coriolis FCT030 Manuel de la liste des pièces

KLINGER

KLINGER CMF V Series Manuel utilisateur

EXFO

EXFO FTB-2 Manuel d'exploitation et d'entretien

Keysight

Keysight M8290A Manuel utilisateur

ADTEK

ADTEK MW-5 Manuel utilisateur