Linear Mini-Code 3060 Manuel utilisateur

location of both the transmitter and receiver will affect

the range. If the transmitter is stowed well out of sight, it

may be necessary to remove it from its mounting and

hold near the windshield. Try different locations and

positions. If operation is still unsatisfactory, the problem

may be isolated by:

1 . Checking the door operator. If the door will not

open when the wall button is pressed, the problem

is likely to be the operator. If the door will open by

pressing the wall button, but not when the radio

control button is pressed, the problem is probably in

the radios.

2. Replacing the transmitter battery. If, after perform-

ing the above operational checks, the controls still

do not function, they should be returned to your

dealer for repair or replacement.

CAUTION:

Any changes or modifications in intentional or

unintentional radiators which are not expressly approved by

LINEAR CORPORATION could void the user’s authority to

operate this equipment. This applies to intentional and

unintentional radiators certified per part 15 of the F.C.C.

rules and regulations.

This device complies with FCC Part 15 and Industry Canada

Rules and Regulations. Operation is subject to the following

two conditions: (1) This device may not cause harmful

interference, and (2) This device must accept any

interference received, including interference that may cause

undesired operation.

LINEAR CORPORATION

2055 Corte Del Nogal •Carlsbad, CA 92009

INSTALLATION INSTRUCTIONS

MINI-TRANSMITTER MODEL 3060

Congratulations! You have just purchased a Mini-Code

Digital Transmitter, which we believe to be the finest

product of its kind on the market. With a little care this

transmitter should provide you with many years of

excellent service. Please take a moment to read the

following instructions and you will find that setting your

new transmitter will be quite an easy matter.

ACCESSING THE CODE SWITCH AND BATTERY

COMPARTMENT

The model 3060 Mini-Transmitter case is composed of 2

halves which are held together by a small phillips head

screw. Removing this screw will allow access to both the

code setting switch and the battery compartment. (see

diagram #1)

INSTR,INSTL,MC3060,MINI-TX

LINEAR P/N: 214942 B

INK: BLACK

MATERIAL: 20 LB. MEAD BOND

SIZE: 6.250" x 4.500"

SCALE: 1-1

SIDE 1 OF 2

SELECTING A CODE

Set both transmitter and receiver switches to the code of

your choice, being sure both are set the same since a

different setting of just one switch will prevent

operation. The digital code is determined by the position

of 10 small switches numbered 1 through 10 located in

the receiver and transmitter. Any combination of “on”or

“off”positions can be selected by using a pencil or ball

point pen. (Note: The switches are in the “on”position

when the switch is depressed toward the number.) See

diagram # 2.

Once the codes have been set, check operation and

reassemble the transmitter case.

MINI-TRANSMITTER INSTALLATION

This transmitter is completely self contained, including

battery and can be operated while held in hand or while

mounted in the car. It is supplied with “hook and loop”

fabric for easy mounting or it may be added to your key

chain using the slot provided.

TRANSMITTER BATTERY REPLACEMENT

Replacement battery - 12 volt alkaline lighter battery

(Eveready A 23 or equivalent)

The transmitter battery can be checked or changed by

removing the phillips head screw located on the back of

the case and carefully separating the case halves to

expose the circuit board and battery. Simply slide out the

old battery and slide in the new, remembering to observe

the battery polarity molded on the case in the bottom of

the battery compartment. Note that if the red L.E.D. on

your transmitter fails to light you most likely have a weak

or dead battery and it should be replaced. (see diagram

#1)

OPERATIONAL CHECK

To check operation, move back a reasonable distance

(about 50 ft.) and press the transmitter button. Operation

should be reliable at this distance but environment and

INSTR,INSTL,MC3060,MINI-TX

LINEAR P/N: 214942 B

INK: BLACK

MATERIAL: 20 LB. MEAD BOND

SIZE: 6.250" x 4.500"

SCALE: 1-1

SIDE 2 OF 2

BATTERY

TRANSMITTER WITH TOP

HAL F OF CASE REMOVED

DIAGRAM #1

TRANSMITTER TOP COVER

CODE

SWITCH

123456789

OFF

CODE SWITCH

DIAGRAM #2

Table des matières

Autres manuels Linear Émetteur

Linear

Linear WT00Z-1 Manuel utilisateur

Linear

Linear MegaCode ACT-21 Manuel utilisateur

Linear

Linear XT-1H Manuel utilisateur

Linear

Linear DX DXT-61 Manuel technique

Linear

Linear Multi-Code MCS307010 Manuel utilisateur

Linear

Linear DXT-61/EC Manuel utilisateur

Linear

Linear MDT Manuel utilisateur

Linear

Linear MegaCode MCT-3 Manuel utilisateur

Linear

Linear MegaCode MCT-11 Manuel utilisateur

Linear

Linear DT-3 Plus 1 Guide de l'administrateur

Linear

Linear AT71-250 Manuel utilisateur

Linear

Linear 2 GIG 2GIG-Z-BRDG-433 Guide de configuration

Linear

Linear GT-31 Manuel utilisateur

Linear

Linear DIGITAL TRANSMITTER GT-30 Manuel utilisateur

Linear

Linear DX DXT-41 Manuel utilisateur

Linear

Linear DXS-21 Manuel utilisateur

Linear

Linear AT7400 Manuel utilisateur

Linear

Linear MULTI-CODE 1051 Manuel utilisateur

Linear

Linear LINEARCOM3000 Manuel utilisateur

Linear

Linear DXS-64 Manuel utilisateur

Linear

Linear Multi-Code 3022 Manuel utilisateur

Linear

Linear LMT-1 Manuel utilisateur

Linear

Linear Delta-3 DTG Manuel utilisateur

Linear

Linear DXS-LRW Manuel utilisateur

Manuels Émetteur populaires d'autres marques

NIVELCO

NIVELCO EasyTREK SCA-300 Series Manuel du propriétaire

Honeywell

Honeywell 5816WMBR Manuel utilisateur

Kamstrup

Kamstrup READy MTU Mode d'emploi

Omega

Omega ZW Series Manuel utilisateur

ABB

ABB Field 264H Mode d’emploi

Alinco

Alinco DJ-V17T Manuel utilisateur

Dejero

Dejero EnGo 3x Manuel utilisateur

Rosemount

Rosemount 4600 Manuel utilisateur

Speaka Professional

Speaka Professional 2342740 Manuel utilisateur

trubomat

trubomat GAB 1000 Manuel utilisateur

Teledyne Analytical Instruments

Teledyne Analytical Instruments LXT-380 Manuel utilisateur

Rondish

Rondish UT-11 Manuel utilisateur

MG 10JRE Manuel utilisateur

Burkert

Burkert 8177 Manuel utilisateur

Firetide

Firetide HotPort 3203 Manuel

Tele Radio

Tele Radio T9-02 Manuel utilisateur

Rotronic

Rotronic HygroFlex HF3 Series Manuel utilisateur

Jamara

Jamara FCX6 Pro Tel Manuel utilisateur