LEGRAND 0 648 85L Manuel utilisateur

Sleep

Wake Up

Setup button

Stickers

Do not remove

the cover plate

Wake Up/Sleep control

LE12496AB-EN

Wireless and batteryless Wake Up/Sleep control

0 648 84L/85L - 0 677 86L

0 770 57L - 6 000 84L

5 742 87/93 - 5 743 22 - 5 748 36

7 418 03L/33L/63L

Requires to install the connected starter pack and one or more «... with Netatmo» connected switch, micromodule

or socket outlet

Module Control Gateway power outlet and home/away wireless

master switch

Pack contents:

Frequency bands: 2.4 - 2.4835 GHz

Power level: < 20 mW

> 3 s

Start the configuration

Press the configuration button of Module Control or press the middle of the wireless master switch (with battery)

until its light briefly turns green, and then stop pressing. All wired products lights will turn green.

A2BC

A1B

To complete your installation, briey press the congu-

ration of the Module Control or the middle of the wire-

less Home / Away master switch.

All the indicator lights on the products switch o

Complete the installation

< 1 s

If necessary, erase the conguration of the wireless

batteryless control (factory reset)

While holding the "setup" button on the wireless batteryless

control, press the "Wake Up" button for 5 seconds.

Conrm that your control is correctly reset by making an

"Wake Up" command, then "Sleep"

5 s

Pair the wireless, batteryless switch to your connected installation.

Make sure that the indicator lights on the wired products are green and not flashing.

If not, go back to step 1.

Tap 3 times any wired product "with Netatmo" with the wireless, batteryless "Wake Up/Sleep control". The light of the

wired product flashes rapidly.

For the specific case of the latching relay, press the main button of the latching relay until the configuration indicator

flashes slowly in blue, release it then tap it 3 times with the wireless, batteryless "Wake Up/Sleep control". The indicator

light of the wired product flashes rapidly.

While holding the "setup" button on the wireless, batteryless control, briefly press the "Wake Up" or "Sleep" control on the

wireless batteryless control.

The indicator light of the wired product will briefly turn blue, and then will turn green again.The pairing was successful.

Complete the configuration of the scenarios using your HOME + CONTROL application, menu "Settings", then

"Scenarios"

H > 2 m

H < 2 m

Put the stickers in place

he undersigned, Legrand declares that the radio-electric equipment type

(0 648 84L/85L - 0 677 86L - 0 770 57L - 6 000 84L - 5 742 87/93 - 5 743 22 -

5 748 36 - 7 418 03L/33L/63L)

complies with directive 2014/53/EU. The full text of the EU declaration of

conformity is available on the following website: www.legrandoc.com

LEGRAND - Pro and Consumer Service - BP 30076

87002 LIMOGES CEDEX FRANCE • www.legrand.com

www.legrandoc.com/064884L

Model: ZLGP16

FCC ID: 2ACN8-ZLGP1X IC: 12132A-ZLGP1X Model : ZLGP16

Before fixing the wireless control(s) with

the removable stickers provided, test one

on a non-visible area of the wall.

You can also fix the wireless control(s) permanently to the

wall with screws.

Download the app

Your installation is ready. You can download the Legrand Home +

Control application to control your lights remotely.

This device contains licence-exempt transmitter(s)/receiver(s) that comply withFCC RF andInnovation, Science and Economic Development

Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) This device

must accept any interference, including interference that may cause undesired operation of the device.

This device complies with FCC and ISED radiation exposure limits set forth for general population. This device must not be co-located or

operating in conjunction with any other antenna or transmitter.

FCC Caution: the user that changes or modications not expressly approved by the party responsible for compliance could void the user's authority

to operate the equipment.

FCC NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception which can be determined by turning the equipment o and on, the user is encouraged to try to correct

interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on circuit dierent from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Safety instructions

Make sure the power supply is disconnected before any intervention.

Strictly comply with instructions for installation and use.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels LEGRAND Unité de contrôle

LEGRAND

LEGRAND EMDX3 MI Manuel utilisateur

LEGRAND

LEGRAND 7 521 82 Manuel utilisateur

LEGRAND

LEGRAND Bypass MEGALINE/1 Manuel utilisateur

LEGRAND

LEGRAND Galion TV - R- SAT Manuel utilisateur

LEGRAND

LEGRAND 0 676 96 Manuel utilisateur

LEGRAND

LEGRAND 6338 53 Manuel d'instructions

LEGRAND

LEGRAND EMDX AMS Manuel utilisateur

LEGRAND

LEGRAND 4 121 71 Manuel utilisateur

LEGRAND

LEGRAND H4651 Manuel utilisateur

LEGRAND

LEGRAND Wattstopper ELCU-200-347 Manuel utilisateur

LEGRAND

LEGRAND Wattstopper ELCU-100 Manuel utilisateur

LEGRAND

LEGRAND adorne Night Light Manuel utilisateur

LEGRAND

LEGRAND Wattstopper TDFC-1A Manuel utilisateur

LEGRAND

LEGRAND 675 07 Manuel utilisateur

LEGRAND

LEGRAND 67217 Manuel utilisateur

LEGRAND

LEGRAND 422684 Manuel utilisateur

LEGRAND

LEGRAND 882 04 Manuel utilisateur

LEGRAND

LEGRAND 0 677 55L Manuel utilisateur

LEGRAND

LEGRAND Eliocad 766 88 Manuel utilisateur

LEGRAND

LEGRAND 5 735 04 Manuel utilisateur

LEGRAND

LEGRAND PRO 21 7756 40 Manuel utilisateur

LEGRAND

LEGRAND 0 676 97 Manuel utilisateur

LEGRAND

LEGRAND Wattstopper IPPAN3-B Manuel utilisateur

LEGRAND

LEGRAND 0 648 73L Manuel utilisateur

Manuels Unité de contrôle populaires d'autres marques

Festo

Festo Compact Performance CP-FB6-E Manuel de la liste des pièces

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur

JS Automation

JS Automation MPC3034A Manuel utilisateur

JAUDT

JAUDT SW GII 6406 Series Guide rapide

Spektrum

Spektrum Air Module System Manuel utilisateur

BOC Edwards

BOC Edwards Q Series Manuel utilisateur

KHADAS

KHADAS BT Magic Manuel utilisateur

Etherma

Etherma eNEXHO-IL Manuel utilisateur

PMFoundations

PMFoundations Attenuverter Manuel utilisateur

GEA

GEA VARIVENT Manuel utilisateur

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuel utilisateur

Altronix

Altronix LINQ8PD Instructions de montage

Eaton

Eaton Powerware Series Manuel utilisateur

WAGO

WAGO 750-407/040-000 Manuel utilisateur

Sony

Sony CCU-590 Manuel utilisateur

Graco

Graco 25D614 Manuel utilisateur

Task Force Tips

Task Force Tips YE-RF-900 Manuel de programmation

Shini

Shini SPV-U Series Manuel utilisateur