Larson Electronics HL-85-HID Manuel utilisateur

Larson Electronics LLC www.LarsonElectronics.com [email protected] 9419

E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364

HL-85-HID

POWER

This spotlight operates on either 12V or 24V DC power. Spotlight can be plugged into cigarette plug

sockets, attached directly to 12 volt batteries, 24 V battery systems, etc. A single hot and ground wire

brings power to the unit. Cords and other wiring means should route through the 2 pin Deutsch

connectors. A single coil cord with cigarette plug terminated with a 2 pin Deutsch plug is provided.

BEAM ADJUSTMENT

•The lens/reflector assembly is on a center threaded post. Rotating the lens/reflector causes the

beam to expand or contract. Counterclockwise rotation creates a wider flood. Clockwise rotation

creates a narrower, longer spot beam.

•The lens/reflector assembly can be removed completely to change to the red lens or change the

bulb.

BULB REPLACEMENT

1. Remove the lens/reflector assembly by rotating counterclockwise until fully unthreaded. Pull the

assembly out away from the light to remove.

2. Unscrew the ring holding the bulb in place.

3. Remove the 4 screws holding the top cover in place. The screws are accessed from the

underside.

4. Remove the top cover. Set the ballast aside. Remove the 4 screws at the base of the ballast box

housing

5. Slide back the protective sheath and expose the bullet connectors for the 2 leads coming from

the HID bulb. Once the wires are disconnected, you can remove the bulb from the housing.

6. Inserting the wire leads first, place the new bulb in the same position as the old bulb.

7. Reconnect the bullet connections.

8. Replace the 4 screws at the base of the ballast box.

9. Replace the ballast, positioning the wires in the same manner as when first opened.

10. Replace the 4 screws that hold the ballast box cover in place.

11. Replace chrome bulb holding ring.

TO CHANGE THE BALLAST/STARTER

1. Remove the 4 screws holding the top cover in place. The screws are accessed from the

underside.

2. Remove the top cover. Set the ballast aside. Remove the 4 screws at the base of the ballast box

housing.

3. The ballast and starter are hard wired together and must be replaced together. The ballast and

starter are linked to the incoming power via bullet connectors. Detach the bullet connectors and

Larson Electronics LLC www.LarsonElectronics.com sales@larsonelectronics.com

9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364 free the

ballast/starter combination. Reconnect the ballast/starter in the same manner as the

replaced units.

4. Replace the 4 screws at the base of the ballast box.

5. Replace the ballast, positioning the wires in the same manner as when first opened.

6. Replace the 4 screws that hold the ballast box cover in place.

DETACHABLE CORDS

1. The cords are detachable by depressing the tab on the top of the connectors. This enables the

operator to leave the cord connected to the power source and remove and store the light.

2. To re‐attach the cord, insert the plug into the socket.

3. The coil cord is designed to provide 16 feet of length. Stretching it beyond that length will

damage the cord, connectors and/or light. Don’t do it.

4. The cigarette plug provided contains a standard fuse. The fuse is replaceable. By pressing down

the silver tip, twisting it and pulling out, the fuse can be seen and replaced.

Table des matières

Autres manuels Larson Electronics Mettre en lumière

Larson Electronics

Larson Electronics GL-8130 Manuel utilisateur

Larson Electronics

Larson Electronics GL-9950 Manuel

Larson Electronics

Larson Electronics GL-3110-S-12-E Manuel

Larson Electronics

Larson Electronics HL-85-3W1-IR Manuel utilisateur

Larson Electronics

Larson Electronics LEDWL 1227 Series Manuel

Larson Electronics

Larson Electronics Golight Radioray 2000 Manuel

Larson Electronics

Larson Electronics Golight Stryker GL-30064ST Manuel utilisateur

Larson Electronics

Larson Electronics Golight Radioray GL-2051GT Manuel utilisateur

Larson Electronics

Larson Electronics HID-X970-SA Manuel utilisateur

Larson Electronics

Larson Electronics HUL-LED25WRE-12.3-50GCR-24I Manuel utilisateur

Larson Electronics

Larson Electronics HL-85-LED-CPR-NC Manuel utilisateur

Larson Electronics

Larson Electronics Golight 51494 Manuel

Larson Electronics

Larson Electronics Golight 51674 Manuel

Larson Electronics

Larson Electronics GL-9100H-S Manuel

Larson Electronics

Larson Electronics LED10W-1SCB Manuel utilisateur

Larson Electronics

Larson Electronics LE-4100-6-A Manuel utilisateur

Larson Electronics

Larson Electronics HML-5M-RC Manuel utilisateur

Larson Electronics

Larson Electronics GL-9951 Manuel

Larson Electronics

Larson Electronics GL-3100-S-12-E Manuel

Larson Electronics

Larson Electronics GL-4600-XD Manuel

Larson Electronics

Larson Electronics WALTP-Q500 Manuel utilisateur

Larson Electronics

Larson Electronics GL-30675-F Manuel utilisateur

Larson Electronics

Larson Electronics HL-85-HID-CPR Manuel utilisateur

Larson Electronics

Larson Electronics Golight GL-2 GT Series Manuel

Manuels Mettre en lumière populaires d'autres marques

Guangzhou Yinhe Lighting&Sound Equipment Factory

Guangzhou Yinhe Lighting&Sound Equipment Factory NE-204 Manuel utilisateur

LIVARNO home

LIVARNO home 375304 2101 Instructions originales

Cameo

Cameo CLQS40WW Manuel utilisateur

Leviton

Leviton Ellipsoid 5/50 Manuel utilisateur

Monacor

Monacor img Stage Line PARL-56PDX/CR Manuel utilisateur

Vector

Vector SL3AKV Manuel utilisateur

Quantum

Quantum Q262 Manuel d'exploitation

Philips

Philips Vari-lite VL3015LT Manuel utilisateur

EUROSPOT

EUROSPOT C51 Manuel utilisateur

DTS

DTS MINI BRICK ARC Manuel utilisateur

Federal Signal Corporation

Federal Signal Corporation VISIBEAM II Manuel

ACME

ACME LED-MS350B Manuel utilisateur

EuroLite

EuroLite Akku flat light 1 Manuel utilisateur

Commercial Electric

Commercial Electric SPTM-1401 Manuel utilisateur

Vision & Control

Vision & Control SLB-500-W5K7-P-SL Manuel utilisateur

Teknik

Teknik FLEXI Manuel utilisateur

Craftsman

Craftsman CMXLSB10 Manuel utilisateur

EuroLite

EuroLite LED SLS-144 UV Floor Spot Manuel utilisateur