Larson Electronics EPL-SL-5-FL26 Manuel utilisateur

EPL-SL-5-FL26

Explosion Proof String Lights

Class 1 & 2, Division 1 - 5 Drop Lights - 26w Compact LED

Instruction Manual

Thank you for your purchase of the Larson Electronics EPL-SL-5-FL26 explosion proof string lights.

WARNING

TO AVOID THE RISK OFFIRE, EXPLOSION OR ELECTRIC SHOCK, THIS PRODUCT SHOULD BE INSTALLED,

INSPECTED AND MAINTAINED BY A QUALIFIED ELECTRICIAN ONLY, IN ACCORDANCE WITH ALL

APPLICABLE ELECTRICAL CODES.

TO AVOID ELECTRIC SHOCK:

•BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.

•PRODUCT MUST BE CONNECTEDTOA WIRING SYSTEM WITHAN EQUIPMENT-GROUNDING

CONDUCTOR.

TO AVOID EXPLOSION:

•MAKE SURE THE SUPPLY VOLTAGE IS WITHIN THE VOLTAGE RATING.

•ENSURE THE MARKED T RATING IS LESS THAN THE IGNITION TEMPERATURE OF THE HAZARDOUS

ATMOSPHERE.

•DO NOT OPERATE IN AMBIENT TEMPERATURES ABOVE THOSE INDICATED ON THE PRODUCT

NAMEPLATE.

•DO NOT OPERATE IF THE LENS, CORD, SEALS, HOUSING, RECEPTACLES, ETC. IS CRACKED OR

DAMAGED. IF SO, DISCONTINUE USE AND CONTACT MANUFACTURER FOR REPLACEMENT PARTS.

•ALL FASTENERS SHOULD BE PROPERLY SEATED.

The Larson Electronics EPL-SL-5-FL26 Explosion Proof String Light set contains a total of 5 work lights, equipped with

aluminum hooks and connected in series along 90 feet of 12/3 SOOW explosion proof cord. and is ideal for general close

work and inspection activities in hazardous locations requiring explosion proof protection.

Mounting

Each light is equipped with a hook at the top for hang mounting,

and a handle at the bottom for handheld applications. Simply

hang the lamps in a suitable location that is capable of

supporting the load. The hook freely swivels, allowing you to

rotate the light to the desired orientation. Alternatively, you may

hand hold one of the lights if you need to get a closer look in a

tight spot.

Wiring

Warning: Check product label for correct input voltage!

This unit comes pre-wired from factory with the selected cord cap. Take precautionary steps for weatherproofing all

connections if installed in a location where water may come in contact with the unit. All outdoor installations and indoor

installations near a wet location require the use of a GFCI device for safety, according to the National Electrical Code® (NEC).

Ensure the unit is properly grounded. Always follow all applicable local and national electrical codes for the hazardous area in

which the equipment will be used. Position device near work area for operation. Run cable to nearby compatible power source

outputting the correct voltage, as listed on the product label. Insert and twist-lock explosion-proof plug into a compatible

receptacle within the hazardous environment. See plug operation below.

Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 1of 2

EPL-SL-5-FL26

Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 2of 2

Plug Operation

Electrical connection between plug and compatible receptacle is accomplished after plug fully inserts into receptacle and

is rotated clockwise.

1. Lift receptacle door and locate polarization on mating plug pin and receptacle face. Insert plug straight

all the way into receptacle until it cannot go further.

2. Rotate plug to clockwise limit (37º), this closes internal contacts and completes circuit. This also

mechanically locks plug into receptacle so it cannot be pulled out.

3. To remove plug, push plug inward and turn to counterclockwise, pull plug straight out.

GROUND-FAULT CIRCUIT INTERRUPTER (GFCI)

In the event of a ground fault, a GFCI will trip and quickly stop the flow of electricity to prevent serious injury.

Definition of a ground fault:

Instead of following its normal safe path, electricity passes through a person's body to reach the ground. For example, a

defective appliance can cause a ground fault.

A GFCI receptacle does NOT protect against circuit overloads, short circuits, or shocks. For example, you can still be

shocked if you touch bare wires while standing on a non-conducting surface, such as a wood floor.

NOTE:

GFCI's contain a lockout feature that will prevent RESET if:

• There is no power being supplied to the GFCI.

• The GFCI is miswired due to reversal of the LINE and LOAD leads.

• The GFCI cannot pass its internal test, indicating that it may not be able to provide protection in the event of a ground

fault.

GFCI TEST

Use an approved GFCI tester or plug an electrical device, such as a lamp into the receptacle on which you are working.

Turn the lamp or device ON. Then, press the TEST button on the GFCI box and power should immediately be switched

off. If not, contact an electrician. Press the RESET button to restore power.

MAINTENANCE

There are no serviceable parts inside the fixture. However, it is good practice to routinely clean and check the

fixture for proper function.

•Disconnect power running to the lamp and be sure the fixture is cool to the touch.

•Use a non-abrasive glass cleaning solution to clean the lens.

Note: It is not necessary to open the fixture and clean or touch the LED’s.

USE AND CARE

Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.

Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of

children when not in use.Inspect for good working condition prior to storage and before re-use.

REPLACEMENT PARTS

The EPL-SL-5-FL26 is designed to provide years of reliable performance. Should the need for replacement parts arise,

please contact Larson Electronics.

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.

SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT

SAL[email protected] OR BY PHONE AT 1-877-348-9680 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

Table des matières

Autres manuels Larson Electronics Équipement d'éclairage

Larson Electronics

Larson Electronics TPM-GL20004-12C-1227-10C Manuel utilisateur

Larson Electronics

Larson Electronics EPL-16C-2X150LED-RT Manuel utilisateur

Larson Electronics

Larson Electronics HALP-24-2L-LED-2XH Manuel utilisateur

Larson Electronics

Larson Electronics EXHL-TRN-LE4-FKWL Series Manuel utilisateur

Larson Electronics

Larson Electronics EPLRL-50-16.4-HR-SWB Manuel utilisateur

Larson Electronics

Larson Electronics TPM-2XWP60E-25C Manuel utilisateur

Larson Electronics

Larson Electronics EPLC2-PT-2X150LED-RT Manuel utilisateur

Larson Electronics

Larson Electronics EPL-HB-50LED-RT Manuel utilisateur

Larson Electronics

Larson Electronics XLE-UVC-XX-SGKT-2X Manuel utilisateur

Larson Electronics

Larson Electronics EPLFL-26W-P-LED-25 Manuel utilisateur

Larson Electronics

Larson Electronics EPL-HB-150LED-RT-DLC Manuel utilisateur

Larson Electronics

Larson Electronics HALPRM-PS-1000WMH Manuel utilisateur

Larson Electronics

Larson Electronics LM-20-3S-EW-LV Manuel utilisateur

Larson Electronics

Larson Electronics EPL-EMG-CM-42W Mode d’emploi

Larson Electronics

Larson Electronics EPL-HB-150LED-RT-IBSC Manuel utilisateur

Larson Electronics

Larson Electronics IND-AHF-CD-UVC-R1-220V-50C Manuel utilisateur

Larson Electronics

Larson Electronics LEDP5W-30-TP1-50CR Manuel utilisateur

Larson Electronics

Larson Electronics EPL-TP-2XRUL10 Manuel utilisateur

Larson Electronics

Larson Electronics EPLC2-QP-1X70LED-100 Manuel utilisateur

Larson Electronics

Larson Electronics IND-LP-SS-24-2X2-2L-UVC Manuel utilisateur

Larson Electronics

Larson Electronics EXP-EMG-2L-LE6 Manuel utilisateur

Larson Electronics

Larson Electronics PTB-1-75FT Manuel utilisateur

Larson Electronics

Larson Electronics LM-25-3S-EW-THM-12VDC Manuel utilisateur

Larson Electronics

Larson Electronics EPL-HB-150LED-RT-140DB-JB3 Manuel utilisateur

Manuels Équipement d'éclairage populaires d'autres marques

Brizo

Brizo 8SP-MU-4 Manuel utilisateur

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuel utilisateur

IKEA

IKEA BJÖRKSPIREA Manuel utilisateur

Laserworld

Laserworld Evolution Series ES-400RGB Manuel utilisateur

Alien

Alien RG STAR Manuel utilisateur

EuroLite

EuroLite LED B-40 Manuel utilisateur

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuel utilisateur

Commercial Electric

Commercial Electric 54568141 Manuel utilisateur

CREE LIGHTING

CREE LIGHTING 304 Series Manuel utilisateur

Goobay

Goobay 49867 Manuel utilisateur

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuel utilisateur

Alkalite

Alkalite Krypton KT-81 Manuel utilisateur

Clas Ohlson

Clas Ohlson GU10 Manuel utilisateur

DTS

DTS DELTA 10 F Manuel utilisateur

ring

ring Solar Steplight Manuel utilisateur

One Stop Gardens

One Stop Gardens 57696 Instructions de montage

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuel utilisateur

SIREM

SIREM Swimeo A2 Manuel utilisateur