Larson Electronics EPL-FL26-LED Series Manuel utilisateur

MAINTENANCE:

WARNING: It is very important that only qualied per-

sonnel perform maintenance and repair operaons in a

NON-HAZARDOUS area. The integrity of the component

assembly and ame-path must be maintained in order

to provide adequate protecon for personnel using this

light. Comply with all NEC Rules and Regulaons when

performing maintenance operaons. Failure to comply

with these could result in an explosion, electrical shock,

or personal injury.

WARNING: When performing maintenance operaons

disconnect power. Failure to do so could result in electri-

cal shock.

Make a thorough visual inspecon of the work light for any

chips, cracks, or burns within the glass, aluminum handle,

and cage. Check the enre length of the cord for any frays

or visible wires that could aect the performance of the

light. Check that all the rubber bumpers are integral with

the aluminum. If there are any frays in the cord, cracks in

the glass or disturbances in the aluminum outside of nor-

mal wear, remove the light from service immediately and

contact Larson Electronics for replacement.

CAUTION: Clean external parts of work light only; inter-

nal parts do not require cleaning. Applying solvent could

result in damage to the electrical equipment.

The EPL-FL26-LED can be cleaned applying Simple Green®

or an equivalent cleanser and wiping any dust or grease off

with a rag. After cleaning process is performed, allow

adequate time for light to completely dry before placing in

operation.

INTRODUCTION

This document covers the operation, maintenance, and

re-lamping procedures for an EPL-FL26-LED hazardous

locations work light. This light is suitable for the

following hazardous locations only:

Class I, Divisions 1 & 2, Groups C & D

Class II, Divisions 1 & 2, Groups E, F, and G

Class III, Divisions 1 & 2

Refer to the National Electric Code (NEC) NFPA 70 for

more information on hazardous locations.

OPERATIONS AND USE

WARNING:

FOR FLYING LEADS:

This light is not supplied with a plug. If the light is used

in a hazardous location environment, it must be

terminated with a suitable plug or hard wired into an

appropriate junction box rated for the environment it

is to be used in. Comply with all NEC Rules and Regu-

lations when terminating light with a plug. Failure to

comply with this could result in an explosion, electri-cal

shock, or personal injury.

CAUTION:

Follow manufacturer’s instructions for attaching plug

to light ensuring all wires are properly terminated and

grounded.

CAUTION:

When hanging the light using the hook, use an ap-

propriate entity capable of holding at least 6 lbs. (2.72

kg).

EPL-FL26-LED Series

Explosion Proof Compact LED Handlamp

Instruction Manual

Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 1 of 2

PLUG OPERATION (for units pre-wired with explosion proof cord cap)

Electrical connection between plug and compatible receptacle is accomplished after plug fully inserts into receptacle and is rotated

clockwise.

1. Lift receptacle door and locate polarization on mating plug pin and receptacle face. Insert plug straight all the

way into receptacle until it cannot go further.

2. Rotate plug clockwise limit (37º), this closes internal contacts and completes circuit. This also mechanically locks

plug into receptacle so it cannot be pulled out.

3. To remove plug, push plug inward and turn to counterclockwise, pull plug straight out.

Relamping Instructions for EPL-FL26-LED

FIG. 1 EXPLODED VIEW EPL-FL26-LED WORK LIGHT

WARNING: When relamping work light, disconnect

power. Failure to do so could result in electrical

shock.

1. Loosen strain relief from handle end of light and

slide down the cord.

2. Loosen and remove the four brass Allen Head

screws using the appropriate tool.

3. Slide handle cap doughnut off the end of the

handle to gain access to the handle cap. With a

slow rocking motion, slide the handle cap and

lamp-head assembly from the handle and cage

casing assembly.

4. Remove the shock from the end of the lamp and

set aside. Grasping lamp holder in one hand and

lamp in other hand, remove the lamp with a slow

rocking motion and discard.

5. Replace lamp with same type and rating lamp or

equivalent. Slide shock on the end of the lamp.

Slide lamp into lamp holder assembly until a click

is heard.

6. Make a visual inspection of the “O” Ring. If “O”

Ring has any sign of wear contact Larson

Electronics for replacement part. Check the black

shrink-wrap fitting for any signs of damage.

7. Slide the lamp assembly back into handle and

cage assembly, aligning the four screw holds.

Tighten brass screws and torque to 35lbf-ft

(47.5N-m). Slide handle cap doughnut onto handle

cap, align holes with screws. Slide strain-relief into

place and tighten to a snug fit.

8. Test light in a non-hazardous location before using

in a hazardous location to ensure proper opera-

tion of lamp.

Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 2 of 2

EPL-FL26-LED Series

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.

SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT

SAL[email protected] OR BY PHONE AT 1-877-348-9680 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

Table des matières

Autres manuels Larson Electronics Équipement d'éclairage

Larson Electronics

Larson Electronics WAL-TL-2X12W-C-SP Manuel utilisateur

Larson Electronics

Larson Electronics GL-29000GB Manuel utilisateur

Larson Electronics

Larson Electronics EPL-LED-150W-RT-140DB-480V Manuel utilisateur

Larson Electronics

Larson Electronics EPL-HB-150LED-RT Manuel utilisateur

Larson Electronics

Larson Electronics HAL-48-33W-LED-1227-70C Manuel utilisateur

Larson Electronics

Larson Electronics HALPRM-PS-1000WMH Manuel utilisateur

Larson Electronics

Larson Electronics TPM-2XLEDEQ-4X3-CPR Manuel utilisateur

Larson Electronics

Larson Electronics EPL-HB-150LED-RT-IBSC Manuel utilisateur

Larson Electronics

Larson Electronics IND-HVAC-ACS-R1-DP-24-2L-XB Manuel utilisateur

Larson Electronics

Larson Electronics EPL-HB-2X150LED-RT Manuel utilisateur

Larson Electronics

Larson Electronics EPLC2-LED-50W-RT Manuel utilisateur

Larson Electronics

Larson Electronics C1D2 Manuel utilisateur

Larson Electronics

Larson Electronics EPL-16C-1MLED-50 Manuel utilisateur

Larson Electronics

Larson Electronics LM-20-3S-EW-LV Manuel utilisateur

Larson Electronics

Larson Electronics RL-15-LED-CPR Manuel utilisateur

Larson Electronics

Larson Electronics LEDP5W-60XC-1227 Manuel utilisateur

Larson Electronics

Larson Electronics LEDLB-12ET-IR-M Manuel utilisateur

Larson Electronics

Larson Electronics VPLHL-15WLED-PC-GR30 Manuel utilisateur

Larson Electronics

Larson Electronics TPM-GL20004-12C-1227-10C Manuel utilisateur

Larson Electronics

Larson Electronics EPL-LED-50W-RT-JB2 Manuel utilisateur

Larson Electronics

Larson Electronics VPLHL-7WLED-PC-XGFI Manuel utilisateur

Larson Electronics

Larson Electronics LEDLB-12E-F-M-1227 Manuel utilisateur

Larson Electronics

Larson Electronics IND-LLP-UVC-KT.EV-R1-120V-0.75IN Manuel utilisateur

Larson Electronics

Larson Electronics HALD-48-1X4-2X50LED-DIMM Manuel utilisateur

Manuels Équipement d'éclairage populaires d'autres marques

Brizo

Brizo 8SP-MU-4 Manuel utilisateur

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuel utilisateur

IKEA

IKEA BJÖRKSPIREA Manuel utilisateur

Laserworld

Laserworld Evolution Series ES-400RGB Manuel utilisateur

Alien

Alien RG STAR Manuel utilisateur

EuroLite

EuroLite LED B-40 Manuel utilisateur

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuel utilisateur

Commercial Electric

Commercial Electric 54568141 Manuel utilisateur

CREE LIGHTING

CREE LIGHTING 304 Series Manuel utilisateur

Goobay

Goobay 49867 Manuel utilisateur

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuel utilisateur

Alkalite

Alkalite Krypton KT-81 Manuel utilisateur

Clas Ohlson

Clas Ohlson GU10 Manuel utilisateur

DTS

DTS DELTA 10 F Manuel utilisateur

ring

ring Solar Steplight Manuel utilisateur

One Stop Gardens

One Stop Gardens 57696 Instructions de montage

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuel utilisateur

SIREM

SIREM Swimeo A2 Manuel utilisateur