Larson Electronics WAL-TL-2X12W-C-SP Manuel utilisateur

WAL-TL-2X12W-C-SP

24 Watt LED Signal Stack Spot Light

Dual Color LED Traffic Light - NEMA 4X - Corrosion Resistant

Instruction Manual

Thank you for your purchase of the Larson Electronics WAL-TL-2X12W-C-SP LED Signal Stack Light.

IMPORTANT

READ CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE

REFERENCE. THE WAL-TL-2X12W-C-SP MUST BE WIRED IN ACCORDANCE WITH NATIONAL ELECTRICAL

CODE AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.

WE STRONGLY ENCOURAGE ONLY A LICENSED ELECTRICIAN INSTALL, OPERATE AND MAINTAIN THIS

PRODUCT. IF YOU ARE NOT QUALIFIED OR UNFAMILIAR WITH ANY ASPECT OF THIS INSTRUCTION SHEET,

CONSULT AN ELECTRICIAN. THERE ARE NO SERVICEABLE PARTS INSIDE.

WARNING: MAKE SURE POWER IS TURNED OFF BEFORE STARTING THE

INSTALLATION OR PERFORMING ANY MAINTENANCE.

RISK OF FIRE/ELECTRIC SHOCK –DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING.

RISK OF PERSONAL INJURY –FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOT INSTALLED PROPERLY.

RISK OF BURN –ALLOW FIXTURE TO COOL BEFORE SERVICING.

The WAL-TL-2X12W-C-SP LED traffic light is an ideal indicator lighting solution for for industrial, marine, and

manufacturing facilities. The light housings are fully sealed within a waterproof aluminum chassis fixture that features a

very small profile for easy and unobtrusive mounting in tight and space limited areas. The mounting plate is also made

from aluminum and can be custom built to customer specifications. This multi-colored indicator light provides color output

as chosen when ordering, has a 50,000 hour operational life, and is available in 120-277 VAC. We also offer a 12/24 VDC

configuration for low voltage operation.

INSTALLATION

We strongly recommend only a licensed electrician install this product.

WARNING: Make sure power is disconnected prior to installing.

This fixture must be mounted to a flat surface that can structurally support the load.

Mounting holes are predrilled into the side flanges of the stack light back plate.

Choose mounting location, lift unit into place, and drive mounting screws through the

pre-drilled mounting holes in the side flanges. It may be necessary to have two

people complete this installation.

WIRING

We strongly encourage only a licensed electrician install this product, in all

locations, especially in outdoor areas where weatherproofing may be required.

Warning: Check product label for correct input voltage!

Secure each pair of wires according to the wiring diagram shipped with your unit.

Utilize a junction box or similar device and take precautionary steps for weather-

proofing all connections if installed in a location where water may come in contact

with the unit. Ensure the unit is properly grounded and that wiring is done according

to all local and national electrical/building codes.

Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 1of 2

Note: Line-in power is connected to the wires labeled "120-277V Inbound". The lights are then individually wired via the

wires labeled 9-32V and the corresponding color (this will be the + for the light it corresponds to), which is then mated with

the 9-32V DCP wire to power the light (this will be the - to complete the connection for each light). Final configuration and

controller or switch setup is left to the installer. Lights can be setup to operate independently, or separately, depending on

the controller or switch being used.

WAL-TL-2X12W-C-SP

Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 2of 2

MAINTENANCE

There are no serviceable parts inside the fixture. However, it is good practice to routinely clean and check the

fixture for proper function.

•Disconnect power running to the lamp and be sure the fixture is cool to the touch.

•Use a non-abrasive glass cleaning solution to clean the lens.

Note: It is not necessary to open the fixture and clean or touch the LED’s.

USE AND CARE

Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.

Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of

children when not in use.Inspect for good working condition prior to storage and before re-use.

REPLACEMENT PARTS

The WAL-TL-2X12W-C-SP is designed to provide years of reliable performance. Should the need for replacement parts

arise, please contact Larson Electronics.

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.

SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT

SAL[email protected] OR BY PHONE AT 1-877-348-9680 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

Table des matières

Autres manuels Larson Electronics Équipement d'éclairage

Larson Electronics

Larson Electronics HAL-RSL Series Manuel utilisateur

Larson Electronics

Larson Electronics GAU-PT-150LTL-LED-480V Manuel utilisateur

Larson Electronics

Larson Electronics LEDWP-600E-M-E2E-20C Manuel utilisateur

Larson Electronics

Larson Electronics LED18W-PAR36 Manuel utilisateur

Larson Electronics

Larson Electronics SOL240-2XWP50E2X200A-RMBB-DNS-7.63SQ Manuel utilisateur

Larson Electronics

Larson Electronics EPL-PM-50LED-100 Manuel utilisateur

Larson Electronics

Larson Electronics EPL-24-2L-LED-VISRED Manuel utilisateur

Larson Electronics

Larson Electronics EPL-FL1524-LED Series Manuel utilisateur

Larson Electronics

Larson Electronics EPLC2-LED-150W-RT-DNS Manuel utilisateur

Larson Electronics

Larson Electronics LM-21-9.1-4S-EW Manuel utilisateur

Larson Electronics

Larson Electronics PTB-1-75FT Manuel utilisateur

Larson Electronics

Larson Electronics EPL-24-2L-LVSOL-80C-C1D2-20C Manuel utilisateur

Larson Electronics

Larson Electronics EPLC2-LED-50W-RT-JB5 Manuel utilisateur

Larson Electronics

Larson Electronics LEDWP-600E-M-E2E Manuel utilisateur

Larson Electronics

Larson Electronics GL-9051-F-M Manuel utilisateur

Larson Electronics

Larson Electronics GAU-ID-36-1L-UVC-SPF Manuel utilisateur

Larson Electronics

Larson Electronics VPLHL-7WLED-GR30 Manuel utilisateur

Larson Electronics

Larson Electronics HALD-48-1X4-2X50LED Manuel utilisateur

Larson Electronics

Larson Electronics EPL-AMB-150LED-50 Manuel utilisateur

Larson Electronics

Larson Electronics IND-DHA-FUVC-EX-36-3L-V2 Manuel utilisateur

Larson Electronics

Larson Electronics HALD-48-1X100LED Manuel utilisateur

Larson Electronics

Larson Electronics EPL-HB-2X150LED-RT Manuel utilisateur

Larson Electronics

Larson Electronics IND-HVAC-DTW-XX-SP0108-120W Manuel utilisateur

Larson Electronics

Larson Electronics EPL-16BS-1X150LED-25 Manuel

Manuels Équipement d'éclairage populaires d'autres marques

Brizo

Brizo 8SP-MU-4 Manuel utilisateur

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuel utilisateur

IKEA

IKEA BJÖRKSPIREA Manuel utilisateur

Laserworld

Laserworld Evolution Series ES-400RGB Manuel utilisateur

Alien

Alien RG STAR Manuel utilisateur

EuroLite

EuroLite LED B-40 Manuel utilisateur

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuel utilisateur

Commercial Electric

Commercial Electric 54568141 Manuel utilisateur

CREE LIGHTING

CREE LIGHTING 304 Series Manuel utilisateur

Goobay

Goobay 49867 Manuel utilisateur

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuel utilisateur

Alkalite

Alkalite Krypton KT-81 Manuel utilisateur

Clas Ohlson

Clas Ohlson GU10 Manuel utilisateur

DTS

DTS DELTA 10 F Manuel utilisateur

ring

ring Solar Steplight Manuel utilisateur

One Stop Gardens

One Stop Gardens 57696 Instructions de montage

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuel utilisateur

SIREM

SIREM Swimeo A2 Manuel utilisateur