Interlogix ATS1831 Instructions de montage

ATS1831/32 IUM Modules Installation Sheet

Figure 1: ATS1832 8 MB IUM module

Description

The intelligent user memory (IUM) module is an optional

memory expansion component that works with the Advisor

Master system. Two models are available: ATS1831 (4 MB)

and ATS1832 (8 MB).

Table 1: Advisor Master system capacities with IUM modules

User records (cards)

ATS1831

ATS1832

17,873/15,000

65,535/55,000

Users with PIN code (4 to 10 digits)

All users

Users names (max. 16 characters)

Users 1 to 200

Card data formats

Up to 48-bit

Programmable alarm groups

128

Door groups

128

Floor groups

Time zones

Alarm events buffer

1,000

Access events buffer

1,000/5,000/10,000*

* Applies to a control panel where ATS1831 can support 5,000 and

ATS1832 can support 10,000 access events. In all other cases 1,000

access events are supported.

Installation

WARNING: A qualified service person, complying with all

applicable codes, should perform all required hardware

installation.

IUM modules are plugged into a control panel PCB and any of

the panel’s intelligent four-door/four-lift controller PCBs to

increase system capacity. The control panel and any intelligent

four-door/four-lift controller must use memory expansion

modules of the same capacity.

Cautions

•When installing an IUM module onto a control panel, the

existing records for users, door groups, and floor groups

are erased from the control panel’s memory. You must

back up these records (if required) and reprogram them

into the control panel after installing the module.

•Take static preventative measures during installation.

A conductive wrist strap should be worn and connected to

a 0 V terminal (e.g. “Batt−” or “Aux Pwr−”). If a wrist strap

is unavailable, touch the 0 V terminal before installing, and

then avoid touching the pins of the chip.

Note the alignment notch on one end of the module.

To install the IUM module:

1. Disconnect the plug pack and battery from the control

panel or intelligent four-door/four-lift controller.

2. Carefully remove the module from its packaging, taking

extreme care that none of the pins are bent.

3. Note the orientation of the module. The module has a

notch, which corresponds with a notch on the IC socket.

If the IC socket is already fitted with a memory expansion

module, you must remove the module so that you can

insert the IUM module in its place.

4. With the notch on the module aligned with the notch on

the IC socket, carefully insert the module into the socket

marked “RAM/IUM” making sure that no pins are bent

under.

5. Gently press the module into the socket until all of the pins

sit firmly in the socket.

6. Clear the panel’s memory by shorting the KILL jumper for

a minimum of 30 seconds (refer to installation guides for

details).

7. Reapply power to the control panel or intelligent four-

door/four-lift controller.

Regulatory information

Manufacturer

PLACED ON THE MARKET BY:

UTC Fire & Security Americas Corporation, Inc.

3211 Progress Drive, Lincolnton, NC, 28092, USA

AUTHORIZED EU REPRESENTATIVE:

UTC Fire & Security B.V.

Kelvinstraat 7, 6003 DH Weert, Netherlands

2 / 2 P/N 146489999-1 • REV C • ISS 09JUL19

Product warnings

and disclaimers

THESE PRODUCTS ARE INTENDED FOR SALE

TO AND INSTALLATION BY QUALIFIED

PROFESSIONALS. UTC FIRE & SECURITY

CANNOT PROVIDE ANY ASSURANCE THAT

ANY PERSON OR ENTITY BUYING ITS

PRODUCTS, INCLUDING ANY “AUTHORIZED

DEALER” OR “AUTHORIZED RESELLER”, IS

PROPERLY TRAINED OR EXPERIENCED TO

CORRECTLY INSTALL FIRE AND SECURITY

RELATED PRODUCTS.

For more information on warranty disclaimers and

product safety information, please check

https://firesecurityproducts.com/policy/product-

warning/ or scan the QR code.

Certification

UTC Fire & Security hereby declares that this

device is in compliance with the applicable

requirements and provisions of the Directive

2014/30/EU and/or 2014/35/EU. For more

information see www.utcfireandsecurity.com or

www.interlogix.com.

2012/19/EU (WEEE directive): Products marked

with this symbol cannot be disposed of as

unsorted municipal waste in the European Union.

For proper recycling, return this product to your

local supplier upon the purchase of equivalent

new equipment, or dispose of it at designated

collection points. For more information see:

www.recyclethis.info

Contact information

www.utcfireandsecurity.com or www.interlogix.com

For customer support, see www.utcfssecurityproducts.eu

Ce manuel convient aux modèles suivants

Autres manuels Interlogix Unité de contrôle

Interlogix

Interlogix ATS1520 Instructions de montage

Interlogix

Interlogix ATS7340 Instructions de montage

Interlogix

Interlogix ITI SuperBus 2000 Manuel utilisateur

Interlogix

Interlogix AdvisorOne AVO-ZW Instructions de montage

Interlogix

Interlogix UM-ZW Manuel utilisateur

Interlogix

Interlogix Simon XT Manuel utilisateur

Interlogix

Interlogix UltraSync UM-C-H1 Instructions de montage

Interlogix

Interlogix ATS1201 8 Instructions de montage

Interlogix

Interlogix TX-E121 Manuel utilisateur

Interlogix

Interlogix DIGITAL INVERTER GENERATOR Instructions de montage

Interlogix

Interlogix 60-677 Manuel utilisateur

Interlogix

Interlogix ATS7200E Instructions de montage

Interlogix

Interlogix UltraSync UM-Z8 Instructions de montage

Interlogix

Interlogix NXG-7002 Instructions de montage

Interlogix

Interlogix ATS 500A Series Manuel utilisateur

Interlogix

Interlogix NX-595E Manuel utilisateur

Interlogix

Interlogix TruPortal TP-ADD-2D Series Manuel utilisateur

Interlogix

Interlogix DTIM Instructions de montage

Interlogix

Interlogix ATS7200N Instructions de montage

Interlogix

Interlogix NX-586E Manuel utilisateur

Interlogix

Interlogix SuperBus 2000 PIV Manuel utilisateur

Interlogix

Interlogix SuperBus 2000 Manuel utilisateur

Interlogix

Interlogix TruPortal TP-ADD-2D-BRD Manuel utilisateur

Interlogix

Interlogix NX-586E Manuel utilisateur

Manuels Unité de contrôle populaires d'autres marques

Festo

Festo Compact Performance CP-FB6-E Manuel de la liste des pièces

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur

JS Automation

JS Automation MPC3034A Manuel utilisateur

JAUDT

JAUDT SW GII 6406 Series Guide rapide

Spektrum

Spektrum Air Module System Manuel utilisateur

BOC Edwards

BOC Edwards Q Series Manuel utilisateur

KHADAS

KHADAS BT Magic Manuel utilisateur

Etherma

Etherma eNEXHO-IL Manuel utilisateur

PMFoundations

PMFoundations Attenuverter Manuel utilisateur

GEA

GEA VARIVENT Manuel utilisateur

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuel utilisateur

Altronix

Altronix LINQ8PD Instructions de montage

Eaton

Eaton Powerware Series Manuel utilisateur

WAGO

WAGO 750-407/040-000 Manuel utilisateur

Sony

Sony CCU-590 Manuel utilisateur

Graco

Graco 25D614 Manuel utilisateur

Task Force Tips

Task Force Tips YE-RF-900 Manuel de programmation

Shini

Shini SPV-U Series Manuel utilisateur