Ikelite 200DL Manuel utilisateur

Product Registration

Please register your product at ikelite.com within 15 days of purchase.

Our product registration database is the best way for us to contact you

in the event of a product update.

200DL Underwater Housing for Canon EOS 5D Mark

III, 5D Mark IV, 5DS, 5DS R DSLR

Product Number 71702

50DL Underwater Housing for Canon EOS 5D Mark

III, 5D Mark IV, 5DS, 5DS R DSLR

Product Number 73702

About this Product

Thank you for your purchase of Ikelite equipment. Please read this

instruction manual completely before attempting to operate or dive

with this product. Please visit ikelite.com to register your product to

receive information on any updates, notices, or recalls pertaining to

your equipment.

Included in the Box

• Housing

• Main O-ring # 0132.61

• Port O-ring # 0132.45

• Zoom Gear Retainer # 75900

• Tool for Zoom Gear Retainer # 0945.06

• Body Cap # 0200.92

• Waterproof Bulkhead Cap # 9104.5

• Silicone Lubricant # 0184.2

• Base with Left-Hand Quick Release Handle # 4077.67

Important Notices

»This housing requires a compatible Lens Port for waterproof

operation. The housing is not waterproof without a Lens Port

attached.

»A bulkhead cap or sync cord must be attached to the housing

for waterproof operation. Never submerge the housing without

either a sync cord or waterproof bulkhead cap attached.

»To prevent salt build-up and sticking controls, turn the camera

off and submerge the sealed housing in clean, freshwater.

Operate the controls several times each while underwater to

ush out any residue.

»Never leave a housing in a rinse tank, even if it is the only

system in the tank. Most catastrophic oods happen when the

user walks away from a housing while it is in the rinse tank.

»Do not use alcohol, cleaning agents, spray lubricants, Rain-X,

or other solvents on the housing or lens port. Use of an

incompatible chemical compound can damage the plastic and

o-rings, and may result in leaking.

Contents

Product Registration 1

About this Product 2

Included in the Box 2

Important Notices 3

Getting to Know Your Housing 6

Vacuum Valve 8

Accessory Port 8

Installing an Accessory via the Accessory Port 9

Setting Up Your Camera 10

Pre-Installation Checklist 10

Setting Up Your Housing 11

Attaching the Base with Quick Release Handle 11

Opening the Housing 11

Inserting the Camera 12

Attaching the Hotshoe 13

Closing the Housing 14

Installing an Optional Zoom Gear (not included with housing) 15

Attaching the Lens Port or Port Extension

Final Check 18

Entering the Water 18

Shooting Under Water 19

Setting Up An External Strobe 20

About Sync Cords 20

TTL Strobe Exposure 20

Attaching a Sync Cord 21

Constant-On Video Lighting 22

Maintenance 22

Post-Dive 22

Lens Port 23

Storage 23

Lubricant 24

Push buttons 24

Control Shafts 25

Troubleshooting 27

Spare Parts 29

Limited Warranty 30

Service and Repairs 30

Getting to Know Your Housing

IKELITE

Shutter Button

Lid Snap

Accessory Port

Hole Plug

AF/Drive Mode

Meter/White Balance

Lens Release

Vacuum

Valve

Plug

= Featured on 200DL Product Number 71702 Only

Zoom

Control

Super-eye

Viewnder

73702 features

a clear window

AF-ON

Button

Main Dial

Power Switch

ISO Speed

Strobe Bulkhead

and Cap

Mode Dial

INFO Button

Erase Button

Playback Button

Index/Magnify/Reduce

RATE Rating Button

Creative Photo/Comp.Playback

MENU Button Live View Shooting/Movie

Start/Stop

Quick Control Button

Setting Button

AF Area Button

AE Lock

AF Point

Q. Control Dial

Vacuum Valve

Your housing features a Vacuum Valve to check watertightness before

a dive. Use of the vacuum valve requires a pump, sold separately.

»DO NOT remove Vacuum Valve Plug unless you are plugging

in a Vacuum Pump.

»DO NOT submerge the housing without the vacuum valve

plug installed. The housing will NOT be waterproof without the

vacuum valve plug installed.

Vacuum Valve

Plug

Nut

Accessory Port

Your housing features one 1/2-20 threaded Accessory Port which

may be used for attachment of factory optional or aftermarket housing

accessories. Visit ikelite.com for an updated list of factory optional

accessories

IKELITE

Accessory Port

Hole Plug

Installing an Accessory via the Accessory Port

1. Remove the Hole Plug using an 11/16” open end wrench.

2. Check the accessory tting o-ring sealing area. Check o-ring and

housing o-ring sealing area. All should be clean and free of hair,

sand, or other debris.

3. Lightly lubricate o-ring with Ikelite lubricant. Use ONLY Ikelite

lubricant. Other manufacturer lubricants can cause the o-ring to

swell.

4. Carefully screw in and tighten accessory tting. The accessory port

features a 1/2-20 threaded hole. Make sure your tting is the same

thread pattern. DO NOT cross-thread. DO NOT overtighten.

5. After installing an accessory, pressure test the housing by diving

without a camera inside.

NOTICE: Your Ikelite housing warranty DOES NOT extend

to cover the attachment of aftermarket housing accessories by

3rd parties. Warranty DOES cover factory optional accessories

attached by certied Ikelite service technicians.

»Do not remove the Accessory Port Hole Plug unless you are

installing a compatible accessory.

Setting Up Your Camera

Pre-Installation Checklist

1. Insert a fully charged camera battery.

2. Insert a properly formatted memory card.

3. Set Mode Dial to “M.” Set shutter speed to 1/60th second or

1/125th second for fast moving subjects. Set aperture to F8 for

general photography or F22 for macro photography (close-ups).

Adjust settings as needed for each shooting situation.

4. When using an external ash, set External Speedlight control to

“Flash ring - Enable.”

Autres manuels pour 200DL

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Ikelite Accessoires pour appareils photo

Ikelite

Ikelite 5509.15 Manuel utilisateur

Ikelite

Ikelite TG-7 Manuel utilisateur

Ikelite

Ikelite 6801.70 Manuel utilisateur

Ikelite

Ikelite 6430 W-30 Manuel utilisateur

Ikelite

Ikelite 6146.02 Manuel utilisateur

Ikelite

Ikelite WD-4 Manuel utilisateur

Ikelite

Ikelite 6871.2 Manuel utilisateur

Ikelite

Ikelite 6116.11 Manuel utilisateur

Ikelite

Ikelite 200DLM/A Manuel utilisateur

Ikelite

Ikelite 6146.16 Manuel utilisateur

Ikelite

Ikelite #6184.80 Manuel utilisateur

Ikelite

Ikelite 5510.45 Manuel utilisateur

Ikelite

Ikelite 6210.61 Manuel du propriétaire

Ikelite

Ikelite 69621 Manuel utilisateur

Ikelite

Ikelite SD770 Manuel du propriétaire

Ikelite

Ikelite 6243.03 Manuel du propriétaire

Ikelite

Ikelite HDR SR5 Manuel du propriétaire

Ikelite

Ikelite DS51 Manuel utilisateur

Ikelite

Ikelite TG-1 Manuel utilisateur

Ikelite

Ikelite 6910.63 Manuel utilisateur

Ikelite

Ikelite 6047 Manuel du propriétaire

Ikelite

Ikelite 4077.01 Fiche technique

Ikelite

Ikelite 200DLM/A Manuel utilisateur

Ikelite

Ikelite 6170.70 Manuel utilisateur

Manuels Accessoires pour appareils photo populaires d'autres marques

Viltrox

Viltrox EF-NEX Instructions d'installation

Calumet

Calumet 7100 Series CK7114 Manuel utilisateur

Ropox

Ropox 4Single Series Manuel utilisateur

Cambo

Cambo Wide DS Digital Series Mode d'emploi

Samsung

Samsung SHG-120 Manuel utilisateur

Ryobi

Ryobi BPL-1820 Manuel d'utilisation

Aegis

Aegis ABL-36020P Manuel utilisateur

Pentax

Pentax Data Back Fc Manuel utilisateur

Fantasea

Fantasea EyeGrabber F Series Manuel utilisateur

Honeywell

Honeywell HDZ20HD Manuel utilisateur

EGO

EGO BA1400T Manuel utilisateur

Sima

Sima SRW-62 Manuel utilisateur

Shape

Shape A7SSMKIT Manuel utilisateur

Slide Kamera

Slide Kamera HST-2 Manuel utilisateur

Power works

Power works 2902613 Manuel utilisateur

SES

SES SE-2047-2 Manuel utilisateur

Olympus

Olympus PT-EP05L Manuel utilisateur

Starlite

Starlite OctoDome nxt Manuel utilisateur