5 Replacement instructions
5.1 Function test
Once the control has been replaced and before the unit is used, you must always
perform a full test of all of the table’s functions. The same function test must then
always be performed at least once a year by competent personnel:
5.1.1 Before testing the battery:
1. Check that the installation instructions have been followed.
2. Check that all bolt connections are securely tightened.
3. Check that all cables have been connected correctly and that the plugs have
been pushed in completely.
4. There must be no load on the table.
5. There must not be any objects or the like that might prevent the table from
moving within the height setting range.
5.1.2 Now switch on the battery:
6. Press the DOWN button and lower the table to the lowest position. Press the
DOWN button once more and hold it down for an additional 5 seconds to
reset the control box. Check that the movement takes place in an even,
controlled way.
7. Now press the UP button and raise the table to the highest position, and
make sure that this takes place in an even, controlled way.
8. If anti-crushing strips are attached beneath the table top, these must be
tested.
Press the DOWN button and allow the table to move 2-5 cm while enabling
the anti-crushing strip at the same time. The table will now stop its downward
movement, move 1-2 cm upwards and stop.
Once all the above items have been checked, you can use the table.
See section 9, “Safe operation”.
