HP P5389A - Intel Pentium III-S 1.4 GHz Processor... Manuel utilisateur

HP Server Ultra3

Non-hot Swap

(68-pin) Hard Disk Drive

Installation Guide

HP Part Number 5990-2610

Printed in January 2002

Notice

The information contained in this document is subject to change without notice.

Hewlett-Packard makes no warranty of any kind with regard to this

material, including, but not limited to, the implied warranties of

merchantability and fitness for a particular purpose. Hewlett-Packard shall not

be liable for errors contained herein or for incidental or consequential damages in

connection with the furnishing, performance, or use of this material.

Hewlett-Packard assumes no responsibility for the use or reliability of its software

on equipment that is not furnished by Hewlett-Packard.

This document contains proprietary information that is protected by copyright. All

rights are reserved. No part of this document may be photocopied, reproduced, or

translated to another language without the prior written consent of Hewlett-

Packard Company.

NetWare®and UnixWare®are registered trademarks of Novell, Inc. Microsoft®

Windows NT, NTAS®, MS-DOS and Windows 2000®are registered trademarks

of Microsoft Corporation. SCO®UNIX®is a registered trademark of The Santa

Cruz Operation, Inc. Banyan®and VINES®are the registered trademark of Banyan

Systems Incorporated. OS/2is the registered trademark of the International

Business Machines Corporation. 3M® is a registered trademark of Minnesota

Mining and Manufacturing Company. TorxTM is a registered trademark of

CamCar/Textron, Inc. SCSI SelectTM is a registered trademark of Adaptec, Inc.

Linux®is a registered trademark of Linus Torvalds.

Hewlett-Packard Company

Network Server Division

Technical Communications/MS 45SLE

10955 Tantau Avenue

Cupertino, CA 95014 USA

Audience Assumptions

This guide is for the person who installs, administers, and troubleshoots LAN

servers. Hewlett-Packard Company assumes you are qualified in the servicing of

computer equipment and trained in recognizing hazards in products with

hazardous energy levels.

iii

It is HP's position that the HP Server product line being acquired is normally

located in spaces frequented only by service personnel for maintenance, repair or

occasional monitoring. Pursuant to FAR 39.204(d), this product is not required to

comply with the accessibility standards at 36 CFR part 1194 published under

Section 508 of the Rehabilitation Act.

Contents

1Prepare Drive for Installation..........................................................................1

Introduction........................................................................................................1

General Installation Steps .............................................................................1

Step 1: Prepare for Installation..........................................................................2

Tools You Need.............................................................................................2

Setup Information You Need.........................................................................2

Unpack the Drive...........................................................................................3

Step 2: Determine the Drive Type ..................................................................... 3

Step 3: Set the SCSI Address ...........................................................................8

Step 4: Continue Installation............................................................................16

2Mount the Drive in the Server L or T Series................................................17

Step 1: Mount the Drive in the System ............................................................17

Step 2: Connect the Drive Activity Light...........................................................18

Step 3: Connect the Drive................................................................................22

Step 4: Configure the Drive .............................................................................23

AJumper Settings............................................................................................. 25

Jumper Legend................................................................................................25

BReturning HP Hard Disk Drives.................................................................... 27

CWarranty and Support................................................................................... 29

Hardware Warranty..........................................................................................29

HP Repair and Telephone Support..................................................................29

Index....................................................................................................................31

1 Prepare Drive for Installation

Introduction

This chapter describes the tools, setup information and the steps necessary to

install a 68-pin SCSI hard disk drive into an HP Server. The drives documented in

this guide are listed in Table 1-1.

Table 1-1. Hard Disk Drive Product Numbers

HP Product Number Capacity RPM

P1167A 18.2 GB 10000

P4616A 18.2 GB 10000

P1169A 36.4 GB 10000

P3578A 73.4 GB 10000

These HP Ultra3 drives can operate in either Single-Ended (SE) mode as Ultra

drives with a maximum bus data rate of 40 MB/sec or in Low-Voltage Differential

(LVD) mode as Ultra3 drives with a maximum bus data rate of 160 MB/sec. The

terminator on the cable, other drives on the bus, and/or the host controller card,

determines whether the drive runs in SE or LVD mode.

NOTE For any drive to run in LVD mode, all SCSI components on

that bus must be in LVD mode.

General Installation Steps

In general, the steps for installing a hard drive are shown below. Please refer to the

detailed instructions in each step before attempting to install your drive.

1. Prepare for Installation

2. Determine the Drive Type

3. Set the SCSI Address

5. Mount the Drive in the System

6. Connect the Drive Activity Light (if appropriate)

7. Connect the Drive

8. Configure the Drive

NOTE Drives with the same product number can be of different types

and require different jumper settings. Match your drive with the

type shown in the figures before installation.

Chapter 1 Prepare Drive for Installation

Step 1: Prepare for Installation

Gather the tools and the setup information you need to install the drive, before

removing the drive from its packaging.

Tools You Need

To install the disk drive, you need the following tools:

•Tweezers, needle-nose pliers or a similar tool for setting configuration

jumpers.

•A TorxTM T-15 screwdriver or a regular blade screwdriver.

Setup Information You Need

Before you begin, you need the following setup information:

•The HP Operations and Maintenance Guide for your system or

Information Assistant on the HP Server Navigator CD-ROM.

•The SCSI addresses available in your system. (Refer to your system in

Information Assistant on the HP Server Navigator CD-ROM for

information on determining available SCSI addresses.)

Chapter 1 Prepare Drive for Installation

Unpack the Drive

CAUTION Shock: Hard disk drives are very susceptible to mechanical

shock and can be damaged by a drop as short as one-quarter of

an inch (.64 cm). Take care when unpacking and handling the

disk drive. If the drop would crack an egg, it will damage the

drive.

Static: Protect the hard disk drive from static electricity by

leaving it in its antistatic bag until you are ready to install it.

Use an antistatic wrist strap and a grounding mat (3M

8501/8502/8505 or equivalent). If an antistatic work area is

not available, touch any unpainted metal surface to discharge

static electricity before handling the drive.

When you remove the hard disk drive from the antistatic bag,

handle it only by the frame. Do not touch the electrical

components. Place the drive on the antistatic bag whenever

you set it down.

After gathering the information and tools:

•Remove the drive from the packaging.

Step 2: Determine the Drive Type

The type of the drive varies and drives with the same part number may be of

different types.

•Match the drive you unpacked with the type of drive shown in Figure 1-1.

Chapter 1 Prepare Drive for Installation

Figure 1-1. Identification of the Different Types of Drives (1 of 2)

Autres manuels pour P5389A - Intel Pentium III-S 1.4 GHz Processor...

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels HP Stockage

HP C2488A Manuel du produit

HP OmniBook 3100 - Notebook PC Manuel utilisateur

HP nimblestorage CS235 Manuel utilisateur

HP MSA 2040 Manuel de programmation

HP StorageWorks XP10000 - Disk Array Manuel utilisateur

HP StorageWorks MSL5000 series Manuel utilisateur

HP StorageWorks DAT 40i Manuel utilisateur

HP StorageWorks MSL6000 series Manuel utilisateur

HP StorageWorks 6000 Manuel utilisateur

HP Storevirtual 4000 Guide de référence rapide

HP P9000 Guide de configuration rapide

HP LTO-3 HH Manuel utilisateur

HP StorageWorks vs80 Manuel utilisateur

HP StorageWorks P4000 Series Manuel utilisateur

HP AU183AA Manuel utilisateur

HP HP 7936 Instructions d'installation

HP Surestore 64 - Director Switch Manuel utilisateur

HP 3PAR StoreServ 7000 Manuel technique

HP Compaq Presario,Presario 4400 Mode d’emploi

HP StorageWorks P2000 Manuel utilisateur

HP DW017B - StorageWorks Ultrium 448 Tape Drive Mode d’emploi

HP LTO-6 Ultrium FH SAS Manuel utilisateur

HP Designjet 220 Instructions d'utilisation

HP D2D Manuel utilisateur

Manuels Stockage populaires d'autres marques

QNAP

QNAP TS 32PXU Series Manuel utilisateur

LaCie

LaCie RUGGED RAID Manuel utilisateur

Freecom

Freecom CLS DOCK Manuel utilisateur

PNY

PNY Attache P-FD64MBATT3 Manuel utilisateur

OLT

OLT 6x6 Maximizer Manuel utilisateur

Transcend

Transcend JetFlash 160 Manuel utilisateur

LaCie

LaCie RUGGED MINI Manuel utilisateur

Thunderbolt

Thunderbolt 600 Manuel utilisateur

Panasonic

Panasonic LB-DH8 series Manuel

Intel

Intel RAID High Availability Manuel utilisateur

LaCie

LaCie 12big Thunderbolt 3 Manuel utilisateur

Spectra Logic

Spectra Logic T-Series Spectra T50e Manuel utilisateur

Panasonic

Panasonic LKM-F931-1 Manuel utilisateur

Tabernus

Tabernus Enterprise Erase E2400 Manuel utilisateur

Rocstor

Rocstor COMMANDER 3F series Manuel utilisateur

Western Digital

Western Digital Ultrastar Data60 Manuel utilisateur

Dell

Dell PowerVault MD3600f Series Manuel utilisateur

CFI

CFI TERA STOR SATA RAID IV Manuel utilisateur