Honeywell PW6K1R1E Manuel de l'opérateur

PW6K1R1E Input/Output Module

Installation and Configuration Guide

Honeywell Integrated Security is a registered trademark of Honeywell International.

All other product and brand names are the service marks, trademarks, registered

trademarks, or registered service marks of their respective owners. Printed in the

United States of America. Honeywell Integrated Security reserves the right to change

any information in this document at any time without prior notice.

Microsoft and Windows are registered trademarks of Microsoft Corporation.

Windows Server is a trademark of Microsoft Corporation.

Ordering Information

Please contact your local Honeywell Integrated Security representative or visit us on

the web at www.honeywellintegrated.com for information about ordering.

Feedback

Honeywell Integrated Security appreciates your comments about this manual. Please

visit us on the web at www.honeywellintegrated.com to post your comments.

PW6K1R1E Configuration and Installation Guide, Document 800-07986V1, Revision A iii

CONTENTS

Chapter 1 Introduction

1.1 Overview ................................................................................................. 2

1.2 General UL-Compliance ......................................................................... 2

1.3 Card Readers ........................................................................................... 3

1.4 Warranty................................................................................................. 4

1.5 Liability ................................................................................................... 4

1.6 FCC Compliance ..................................................................................... 4

Chapter 2 PW6K1R1E Wiring and Setup

2.1 PW6K1R1E Hardware ............................................................................ 6

2.2 Terminal Connections ............................................................................. 7

2.3 Jumper Configuration.............................................................................. 8

2.4 DIP Switch Configuration....................................................................... 8

2.5 Input Power ............................................................................................. 8

2.6 Communication Wiring........................................................................... 9

2.7 Reader Wiring ......................................................................................... 9

2.8 Input Circuit Wiring .............................................................................. 10

2.9 Relay Circuit Wiring ............................................................................. 10

2.10 Status LEDs......................................................................................... 11

2.11 Specifications ...................................................................................... 12

2.12 Additional Mounting Information....................................................... 15

iv www.honeywell.com

PW6K1R1E Configuration and Installation Guide, Document 800-07986V1, Revision A 1

Introduction

In this chapter...

1.1 Overview 2

1.4 Warranty 4

1.5 Liability 4

1.6 FCC Compliance 4

2www.honeywell.com

Introduction

Overview

1.1 Overview

The PW6K1R1E reader interface provides a network connected, single door with

paired reader, PoE based solution to the OEM integrator for interfacing TTL/

Wiegand/RS-485 type readers to door hardware. The on-board twisted pair Ethernet

jack with PoE support enables easy installation.

A maximum of 16 PW6K1R1E downstream boards can be connected to PW6K1ICE

controller board.

You can control one physical barrier with PW6K1R1E, using single or paired readers.

The first reader port can accommodate a read head that utilizes Wiegand, magnetic

stripe, or 2-wire RS-485 electrical signaling standards, one or two wire LED controls,

and buzzer control (one wire LED mode only).

The second reader port can accommodate a read head that utilizes Wiegand or

magnetic stripe signaling, one or two wire LED controls, and buzzer control (one wire

LED mode only).

You can use two form-C relay outputs for door strike control or alarm signaling.The

relay contacts are rated at 5A @ 30VAC/DC, dry contact configuration. Four inputs

are provided for monitoring the door contacts, exit push buttons, and alarm contacts.

The PW6K1R1E requires power from PoE or local 12VDC. The reader power should

be based on peak reader power consumption.

The PW6K1R1E may be mounted in a 3-gang switch box; a mounting plate is

supplied with the unit. The PW6K1R1E may be mounted in an enclosure; the supplied

mounting plate has mounting holes that match the MR50 mounting footprint. Refer to

Additional Mounting Information (p. -15) for UL enclosure requirements.

The PW6K1R1E has to be installed on the same subnet as PW6101 (i.e., PW6K1ICE)

or PW6000. The encryption between both PW6000 and PW6K1ICE, and, PW6101

and PW6K1ICE, is built-in and automatic.

1.2 General UL-Compliance

A UL-compliant installation requires the following:

• The PW6K1R1E board must be installed within the protected area.

• The PW6K1R1E board is installed for indoor use only.

• The PW6K1R1E board must be installed with a tamper switch mounted to the

enclosure cover.

• The fail secure locking mechanism shall only be installed where is is allowed

by the local authority having jurisdiction (AHJ), and it shall not impair the

operation of panic hardware and emergency egress.

Note: The PW6K1R1E board is not UL Listed for burglary installations.

Introduction

Card Readers

PW6K1R1E Configuration and Installation Guide, Document 800-07986V1, Revision A 3

1.3 Card Readers

The Pro-Watch PW6K1ICE controller and PW6K1R1E input/output board have been

tested for use with the following Listed (ALVY) card readers:

Manufacturer Model Part Number

HID ProxPro HU/5355AGN00

ProxPro II HU/5455BGN00

ProxPro K HU/5355AGK00

MiniProx HU/5365EGP00

ThinLine II HU5395CB100

HU/5395CG100

HU/5395CK100

Honeywell OM40 OM40BHONC

OM40GHONC

OM41 OM41BHONC

OM41GHONC

OM55 OM55BHONB

OM55GHONB

OP-10 OP10GENR

OP10HONR

OP-30 OP30GENR

OP30HONR

OP-40 OP40GENR

OP40HONR

4www.honeywell.com

Introduction

Warranty

1.4 Warranty

Honeywell Security Access warrants that the product is free from defects in material

and workmanship under normal use and service with proper maintenance for one year

from the date of factory shipment.

Honeywell Security Access assumes no responsibility for products damaged by

improper handling or installation. This warranty is limited to the repair or replacement

of the defective unit.

There are no expressed warranties other than set forth herein. Honeywell Security

Access does not make, nor intends, nor does it authorize any agent or representative to

make any other warranties, or implied warranties, and expressly excludes and

disclaims all implied warranties of merchantability or fitness for a particular purpose.

Returned units are repaired or replaced from a stock of reconditioned units. Returns

must be accompanied by a Returned Merchandise Authorization (RMA) number

obtained from customer service, and prepaid postage and insurance.

1.5 Liability

You should use the Interface only to control exits from areas where an alternative

method for exit is available.

This product is not intended for, nor is rated for operation in life-critical control

applications.

Honeywell Security Access is not liable under any circumstances for loss or damage

caused by or partially caused by the misapplication or malfunction of the product.

Honeywell Security Access's liability does not extend beyond the purchase price of

the product.

1.6 FCC Compliance

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may

cause undesired operation.

PW6K1R1E Configuration and Installation Guide, Document 800-07986V1, Revision A 5

PW6K1R1E Wiring and Setup

In this chapter...

2.1 PW6K1R1E Hardware 6

2.2 Terminal Connections 7

2.3 Jumper Configuration 8

2.4 DIP Switch Configuration 8

2.5 Input Power 8

2.6 Communication Wiring 9

2.7 Reader Wiring 9

2.8 Input Circuit Wiring 10

2.9 Relay Circuit Wiring 10

2.10 Status LEDs 11

2.11 Specifications 12

2.12 Additional Mounting Information 15

6www.honeywell.com

PW6K1R1E Wiring and Setup

PW6K1R1E Hardware

2.1 PW6K1R1E Hardware

Figure 2-1: PW6K1R1E Control Board

Figure 2-2: PW6K1R1E Control Board Solder Side

123456

J3J7

12V

PoE

TB1 TB2 TB3 TB4 TB5 TB6

111111

IN1 IN2 IN3 IN4 VO LED BZR CLK DAT GND VO GNDDATCLKBZRLED GNDVIN NO NC2-CNONC1-C

0.2 [5.08] 2.35 [59.69]

0.15 [3.81]

2.55 [64.77] 2.55 [64.77]

5.4 [137.16]

STATUS LEDs

2.75 [69.85]

DIP SWITCH

RESET SWITCH

PoE/12Vdc

POWER SELECTOR

JUMPER

ETHERNET RJ45

CONNECTOR

ACTIVITY

(YELLOW)

LINK

(GRREN)

123456

VO IN2 IN1

IN3

IN4

LED

BZR

CLK

DAT

GND

LED

BZR

CLK

DAT

NC GNDGND

VIN

RLY 1

RLY 2

NC CC

TB6

TB5

TB4

TB3

TB2

TB1

3.3V

LNK

ACT

(K1)

(K2)

D24

D19

ETHERNET

STATUS

LEDs

RELAY K1

LED

RELAY K2

LED

STATUS LEDs

SOLDER SIDE

Table des matières

Autres manuels Honeywell Unité de contrôle

Honeywell

Honeywell SV2 Series Manuel utilisateur

Honeywell

Honeywell S7800A1167 Manuel utilisateur

Honeywell

Honeywell GSMVLP5 Instructions de montage

Honeywell

Honeywell Ex-Or MLSUC500 Manuel utilisateur

Honeywell

Honeywell NOTIFIER FCM-1 Manuel utilisateur

Honeywell

Honeywell DirectLine DL421 Manuel utilisateur

Honeywell

Honeywell Esser IQ8TAL Manuel utilisateur

Honeywell

Honeywell AVS Manuel utilisateur

Honeywell

Honeywell THP9045 Manuel utilisateur

Honeywell

Honeywell CF4680 Manuel utilisateur

Honeywell

Honeywell SILENT KNIGHT IDP-Control-6 Manuel utilisateur

Honeywell

Honeywell Notifier XP6-R Manuel utilisateur

Honeywell

Honeywell 7800 SERIES Manuel utilisateur

Honeywell

Honeywell CIPer 30 Manuel utilisateur

Honeywell

Honeywell ScanDome ll HTX-3000 Manuel utilisateur

Honeywell

Honeywell FIRE-LITE ALARMS CRF-300 Manuel utilisateur

Honeywell

Honeywell ControLinks S7999 Manuel d'utilisation

Honeywell

Honeywell SG150 Manuel utilisateur

Honeywell

Honeywell RV181 Manuel utilisateur

Honeywell

Honeywell MNG verafix Manuel utilisateur

Honeywell

Honeywell D06F Manuel utilisateur

Honeywell

Honeywell SV2 Series Manuel utilisateur

Honeywell

Honeywell NetAXS-123 Manuel utilisateur

Honeywell

Honeywell Krom Schroeder VAN Series Manuel utilisateur

Manuels Unité de contrôle populaires d'autres marques

Festo

Festo Compact Performance CP-FB6-E Manuel de la liste des pièces

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur

JS Automation

JS Automation MPC3034A Manuel utilisateur

JAUDT

JAUDT SW GII 6406 Series Guide rapide

Spektrum

Spektrum Air Module System Manuel utilisateur

BOC Edwards

BOC Edwards Q Series Manuel utilisateur

KHADAS

KHADAS BT Magic Manuel utilisateur

Etherma

Etherma eNEXHO-IL Manuel utilisateur

PMFoundations

PMFoundations Attenuverter Manuel utilisateur

GEA

GEA VARIVENT Manuel utilisateur

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuel utilisateur

Altronix

Altronix LINQ8PD Instructions de montage

Eaton

Eaton Powerware Series Manuel utilisateur

WAGO

WAGO 750-407/040-000 Manuel utilisateur

Sony

Sony CCU-590 Manuel utilisateur

Graco

Graco 25D614 Manuel utilisateur

Task Force Tips

Task Force Tips YE-RF-900 Manuel de programmation

Shini

Shini SPV-U Series Manuel utilisateur