H3C SecPath NSQM2GP24TSSC0 Manuel utilisateur

Manual version: 6PW105-20190725 BOM: 3123A1M0

H3C SecPath NSQM2GP24TSSC0 interface module

1 Identifier

The module identifier NSQM2GP24TSSC0 is in the upper right corner of the front panel.

2 About the module

The NSQM2GP24TSSC0 interface module provides twenty-four 1000BASE-X SFP fiber ports and

four 10GBASE-R SFP+ fiber ports. By using this module with high-performance service modules,

the device is capable of providing security for 100G networks.

3 Specifications

Figure 1 Front panel

(1) 1000BASE-X SFP fiber port LEDs (2) 10GBASE-R SFP+ fiber port LEDs

(3) 10GBASE-R SFP+ fiber ports (4) 1000BASE-X SFP fiber ports

(5) Ejector lever (6) Captive screw

IMPORTANT:

Before installing the module, you must remove the protection cover from the module.

Table 1 Module specifications

Item Specification

Dimensions (H × W × D) 40.1 × 399.2 × 354.8 mm (1.58 × 15.72 × 13.97 in)

SDRAM (DDR3) 1 GB

Power consumption 27 W to 52 W

Net weight 2.85 kg (6.28 lb)

Hot swapping Supported

Ports •24 × 1000BASE-X SFP fiber ports

•4 × 10GBASE-R SFP+ fiber ports

Connector type LC

Manual version: 6PW105-20190725 BOM: 3123A1M0

Item Specification

Ambient temperature •Operating: 0°C to 45°C (32°F to 113°F)

•Storage: –40°C to +70°C (–40°F to +158°F)

Ambient humidity •Operating: 10% RH to 95% RH, noncondensing

•Storage: 5% RH to 95% RH, noncondensing

Port speed •1000 Mbps

•10 Gbps

Transmission medium and max

transmission distance 1000BASE-X SFP fiber port: see Table 2.

10GBASE-R SFP+ fiber port: see Table 2 and Table 3.

Compatible device models and slots

•M9008-S gateway (slots 2 to 7)

•M9008-S-6GW gateway (slots 2 to 7)

•T9008-S intrusion prevention system (slots 2 to 7)

The 1000BASE-X SFP fiber ports support the SFPtransceiver modules in Table 2. The 10GBASE-R

SFP+ fiber ports support SFP transceiver modules in Table 2 and SFP+ transceiver modules inTable

Table 2 SFP transceiver modules available for the 1000BASE-X SFP fiber ports and

10GBASE-R SFP+ fiber ports

Module Central

wavelength

(nm)

Connector

type Cable

specifications

Maximum

transmission

distance

SFP-GE-SX-MM850-A 850 LC 50/125 µm MMF 550 m (0.34 miles)

62.5/125 µm MMF 275 m (0.17 miles)

SFP-GE-LX-SM1310-A 1310 LC

9/125 µm SMF 10 km (6.21 miles)

50/125 µm MMF 550 m (1804.46 ft)

62.5/125 µm MMF 550 m (1804.46 ft)

SFP-GE-LH40-SM1310 1310 LC 9/125 µm SMF 40 km (24.86 miles)

SFP-GE-LH40-SM1550 1550 LC 9/125 µm SMF 40 km (24.86 miles)

SFP-GE-LH80-SM1550 1550 LC 9/125 µm SMF 80 km (49.71 miles)

SFP-GE-LH100-SM1550 1550 LC 9/125 µm SMF 100 km (62.14 miles)

Table 3 SFP+ transceiver modules available for the 10GBASE-R SFP+ fiber ports

Module Central

wavelength

(nm)

Connector

type Cable

specifications

Maximum

transmission

distance

SFP-XG-SX-MM850-A 850 LC

50/125 µm MMF

300 m (984.25 ft)

82 m (269.03 ft)

66 m (216.54 ft)

62.5/125 µm MMF 33 m (108.27 ft)

26 m (85.30 ft)

SFP-XG-LX-SM1310 1310 LC 9/125 µm SMF 10 km (6.21 miles)

SFP-XG-LH40-SM1550 1550 LC 9/125 µm SMF 40 km (24.86 miles)

Manual version: 6PW105-20190725 BOM: 3123A1M0

iii

4 LEDs

The module provides a LED for each 1000BASE-X SFP fiber port and 10GBASE-R SFP+ fiber port

to indicate their operating status.

Table 4 1000BASE-X SFP fiber port LED description

Status Description

Flashing The port is sending or receiving data.

On A link is present on the port.

Off No link is present on the port.

Table 5 10GBASE-R SFP+ fiber port LED description

Status Description

Flashing The port is sending or receiving data.

On A link is present on the port.

Off No link is present on the port.

5 Installing and removing the module

CAUTION:

•Wear a reliably-grounded ESD wrist strap or ESD gloves when installing or removing the module.

•Do not touch the components on the module.

5.1 Installing the module

1. Face the front panel of the device. Remove the filler panel from the target slot.

This example uses slot 2.

2. Place the module on a flat surface with the components facing up. Open the ejector levers on

the module.

3. Push the module slowly into the slot along the guide rails.

4. Close the ejector levers and make sure the module is in close contact with the backplane.

5. Use a Phillips screwdriver to fasten the captive screws on the module.

Manual version: 6PW105-20190725 BOM: 3123A1M0

Figure 2 Installing the module

5.2 Removing the module

1. Use a Phillips screwdriver to loosen the captive screws on the module until all pressure is

released.

2. Simultaneously open the ejector levers of the module to separate the module from the

backplane, and pull the module slowly out of the slot along the guide rails.

3. Place the module on an anti-static workbench or put it in an anti-static bag, with the component

side facing up.

4. If you are not to install a new module, install a filler panel in the slot to prevent dust and ensure

good ventilation in the device.

The information in this document is subject to change without notice.

Autres manuels H3C Unité de contrôle

H3C

H3C S9500E Series Manuel de la liste des pièces

H3C

H3C SecPath M9000-AI NSQM5AIASKA1 Manuel utilisateur

H3C

H3C S12500 LST1LB1A1 Manuel utilisateur

H3C

H3C LSQM1SDNB0 Manuel utilisateur

H3C

H3C LSVM2106SFAN Manuel utilisateur

H3C

H3C SecPath AC2500 Manuel utilisateur

H3C

H3C PSR1600B-12A-B Manuel utilisateur

H3C

H3C SecPath M9000 NSQM1MBFEA0 Manuel utilisateur

H3C

H3C SecBlade Manuel utilisateur

H3C

H3C PSR250-12A1 Manuel utilisateur

H3C

H3C LSWM116FC Manuel utilisateur

H3C

H3C LSVM152SCFAN Manuel utilisateur

H3C

H3C SecPath PSR300-12A2 Manuel utilisateur

H3C

H3C PSR650C-12A Manuel utilisateur

H3C

H3C SecPath M9000-AI NSQM5MBSHA1 Manuel utilisateur

H3C

H3C NSQM1FWDFGC1 Manuel utilisateur

H3C

H3C R6900-FAN Manuel utilisateur

H3C

H3C PSR150-A1 Manuel utilisateur

H3C

H3C PSR750-A Manuel utilisateur

H3C

H3C NSQ1TGS32SF0 Manuel utilisateur

H3C

H3C LSUM1TGT24FD0 Manuel utilisateur

H3C

H3C SIC-4G-CAT6 Manuel utilisateur

H3C

H3C S9500E LSR1FW2A1 Manuel utilisateur

H3C

H3C PSR300-12A Series Manuel utilisateur

Manuels Unité de contrôle populaires d'autres marques

Festo

Festo Compact Performance CP-FB6-E Manuel de la liste des pièces

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuel utilisateur

JS Automation

JS Automation MPC3034A Manuel utilisateur

JAUDT

JAUDT SW GII 6406 Series Guide rapide

Spektrum

Spektrum Air Module System Manuel utilisateur

BOC Edwards

BOC Edwards Q Series Manuel utilisateur

KHADAS

KHADAS BT Magic Manuel utilisateur

Etherma

Etherma eNEXHO-IL Manuel utilisateur

PMFoundations

PMFoundations Attenuverter Manuel utilisateur

GEA

GEA VARIVENT Manuel utilisateur

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuel utilisateur

Altronix

Altronix LINQ8PD Instructions de montage

Eaton

Eaton Powerware Series Manuel utilisateur

WAGO

WAGO 750-407/040-000 Manuel utilisateur

Sony

Sony CCU-590 Manuel utilisateur

Graco

Graco 25D614 Manuel utilisateur

Task Force Tips

Task Force Tips YE-RF-900 Manuel de programmation

Shini

Shini SPV-U Series Manuel utilisateur