GIRA
Info Multifunction Radio Transmitter
Installation Instructions
Multifunction Radio Transmitter 05/01 Page: 5 of 8
7)
8)
7) ALL-OFF, lightscapes 3 to 5
E1: Switching OFF all programmed receivers.
(ALL-OFF function).
E2: Calling or saving lightscape 3.
E3: Calling or saving lightscape 4.
E4: Calling or saving lightscape 5.
8) Lightscapes 1-4
E1 to E4: Calling or saving lightscapes 1 to 4.
Other microswitch positions not described are without
function.
Programming of radio receivers
A multifunction transmitter channel can be programmed into
any number of radio receivers. Programming affects only the
radio receiver.
During programming of a transmitter, the sensitivity of the
receiver is reduced to approx. 5 m. The distance between
the radio receiver and the radio transmitter to be pro-
grammed should therefore be between 0.5 m and 5 m.
H
Procedure
1. Switch the radio receiver into the programming mode.
(Refer to the "Radio Receiver" operating instructions).
2a. Programming of modes 1 and 2:
- Set microswitch to the desired position.
- Press the installation pushbutton of the desired input
for at least 1 s.
Note: For double rocker modes, press one push-button
per radio channel only.
2b. Programming of modes 3 and 4
- Set microswitch first to position 00000 (refer to Fig. H).
- Press the connected switch of the desired input for at
least 1 s.
- Now, set the associated microswitch position.
2c. Programming of modes 5 to 8:
- Set microswitch to the desired position.
- Depending on the function selected, press the
lightscape key for at least 3 s or the ALL-ON or ALL-
OFF key for at least 10 s.
Important:
When a lightscape key is programmed, the ALL-ON or
ALL-OFF key will be stored automatically by the radio
receiver.
(Refer to the "ALL-ON/ALL-OFF" or "Calling/ Saving a
Lightscape" chapters.)
3. Set the radio receiver to the operation mode. (Refer to
the "Radio Receiver" operating instructions).
