Fluke SigmaPace 1000 Manuel utilisateur

SigmaPace 1000

Safety Sheet

External Pacemaker Analyzer

Introduction

The SigmaPace™ 1000 External Pacemaker Analyzer

(the Analyzer), is the latest in external pacemaker

analyzer technology. This efficient, handheld

Analyzer satisfies a wide range of external pacemaker

testing.

Table 1-1 describes the symbols used on the

instrument.

Table 1. Symbols

Symbol Description

Important information; refer to manual.

Hazardous voltage

Do not dispose of this product as unsorted

municipal waste. Go to Fluke’s website for

recycling information.

Conforms to relevant Australian EMC

requirements

Conforms to relevant Canadian and US

standards

Conforms to European Union directives

CAT I

IEC Measurement Category I – CAT I

equipment designed to protect against

transients in equipment on circuits not

directly connected to MAINS. Under no

circumstances should the terminals of the

Analyzer be connected to any MAINS

voltage.

Warnings and Cautions

A Warning identifies hazardous conditions and

actions that could cause bodily harm or death.

A Caution identifies conditions and actions that

could damage the Analyzer, the equipment under test,

or cause permanent loss of data.

 Warning

To avoid possible electrical shock or

personal injury, follow these

guidelines:

•Use this product only in the

manner specified by the

manufacturer, or the protection

provided may be impaired.

•Read the Operators Manual

before operating the Product.

•Do not use the product if it

operates abnormally.

•Do not use the product around

explosive gas, vapor, or in damp

or wet environments.

•Use extreme caution when

working with voltages above 30

volts.

•Use the proper terminals,

functions and ranges for the test

being performed.

•Do not connect the Analyzer to a

patient or equipment connected

to a patient. The Analyzzer is

intended for equipment

evaluation only and should never

be used in diagnostics, treatment

or in any other capacity where

the Analyzer would come in

contact with a patient.

Power Supply

Make sure the external battery charger / power supply

is rated and configured for your voltage source, and

compatible with the voltage and current ratings of the

Analyzer. Use only the specified power supply

included with this instrument.

SigmaPace 1000

Safety Sheet

Defibrillators and

Transcutaneous Pacemakers

Caution

To avoid possible damage the

Analyzer, do not discharge

defibrillator pulses into the

instrument.

 Warning

To avoid injury to a patient, do not

connect the Analyzer to a patient or

equipment connected to a patient.

The Analyzer is intended for

equipment evaluation only and

should never be used in diagnostics,

treatment or in any other capacity

where the Analyzer would come in

contact with a patient.

Ventilation

Caution

To avoid heat buildup damage to the

Analyzer, do not block the ventilation

slots during use or while the

instrument is charging.

Avoiding Damage

Caution

To avoid damage to the Analyzer or

adverse affects on its performance,

do not expose the system to

temperature extremes. Ambient

temperatures should remain between

18 and 40 °C. System performance

may be adversely affected if

temperatures fluctuate above or

below this range.

Cleaning

Caution

To avoid damage to the Analyzer or

adverse affects on its performance,

clean it only by gently wiping down

with a clean, lint-free cloth dampened

with a mild detergent solution. Do

not immerse the unit.

Service and Calibration

Caution

To avoid damage to the produt or

adverse affects on its performance,

allow only qualified technical

personnel to service the Analyzer.

Autres manuels pour SigmaPace 1000

Table des matières

Autres manuels Fluke Instrument de mesure

Fluke

Fluke i400s Manuel utilisateur

Fluke

Fluke 435-II Manuel d'instructions

Fluke

Fluke A3003 FC Manuel d'utilisation et d'entretien

Fluke

Fluke RUSKA 2456-LEM Manuel utilisateur

Fluke

Fluke CableAnalyzer DSP-4000 Series Manuel utilisateur

Fluke

Fluke CPS-40M-HC40 Manuel utilisateur

Fluke

Fluke 8808A Manuel d'utilisation et d'entretien

Fluke

Fluke 80i-2010s Manuel utilisateur

Fluke

Fluke BT520 Manuel utilisateur

Fluke

Fluke 3000/6000A-TF-4 Manuel utilisateur

Fluke

Fluke 3210-PR-TF-II Manuel utilisateur

Fluke

Fluke 414D Manuel utilisateur

Fluke

Fluke MICROSCANNER Manuel utilisateur

Fluke

Fluke 481 Manuel utilisateur

Fluke

Fluke PRO3000 Manuel utilisateur

Fluke

Fluke 369 Manuel utilisateur

Fluke

Fluke 724 Manuel utilisateur

Fluke

Fluke 789 Manuel du propriétaire

Fluke

Fluke 373 Manuel d'instructions

Fluke

Fluke 917 Series Manuel utilisateur

Fluke

Fluke 741B Manuel utilisateur

Fluke

Fluke FS17XX Manuel utilisateur

Fluke

Fluke QA-ES III Manuel de la liste des pièces

Fluke

Fluke OptiView T1/E1 Manuel utilisateur

Manuels Instrument de mesure populaires d'autres marques

Suaoki

Suaoki D40 Manuel utilisateur

Elster

Elster BK-G1.6 Manuel utilisateur

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manuel

Duratool

Duratool D03128 Manuel utilisateur

Vega

Vega VEGAPULS 65 Manuel utilisateur

Tonghui

Tonghui TH2618B Manuel utilisateur

Tenmars

Tenmars TM-801 Manuel utilisateur

MSR

MSR 145 Manuel utilisateur

TPS

TPS WP-82 Manuel utilisateur

ELMETRON

ELMETRON CP-511 Manuel utilisateur

PCB Piezotronics

PCB Piezotronics 003C30 Manuel utilisateur

Tenma

Tenma 72-10465 Manuel utilisateur

Endress+Hauser

Endress+Hauser Proline Promag 50 Caractéristiques techniques

Siemens

Siemens SITRANS F Coriolis FCT030 Manuel de la liste des pièces

KLINGER

KLINGER CMF V Series Manuel utilisateur

EXFO

EXFO FTB-2 Manuel d'exploitation et d'entretien

Keysight

Keysight M8290A Manuel utilisateur

ADTEK

ADTEK MW-5 Manuel utilisateur