Emerson Rosemount 3408 Manuel utilisateur

Quick Start Guide

00825-0300-4418, Rev AB

May2023

Rosemount™ 3408 Level Transmitter

LCD Display Kit

1 About this guide

This guide provides instructions for retrofitting and replacing the

LCD display on the Rosemount 3408 Level Transmitter. Refer to the

Rosemount 3408 Reference Manual for instructions on how to set up

the LCD display.

1.1 Safety messages

WARNING

Failure to follow safe installation and servicing guidelines could

result in death or serious injury.

Ensure the transmitter is installed by qualified personnel and in

accordance with applicable code of practice.

For installations in hazardous locations, the transmitter must be

installed according to the Rosemount 3408 Product Certifications

document and System Control Drawing.

WARNING

Explosions could result in death or serious injury.

Before connecting a handheld communicator in an explosive

atmosphere, ensure that the instruments are installed in accordance

with intrinsically safe or non-incendive field wiring practices.

In Explosion-proof/Flameproof and Non-Incendive/Type Ex ec

installations, do not remove the transmitter cover when power is

applied to the unit.

The transmitter cover must be fully engaged to meet Explosion-

proof/Flameproof requirements.

WARNING

Electrical shock could cause death or serious injury.

Ensure the mains power to the transmitter is off and the lines to any

other external power source are disconnected or not powered while

wiring the transmitter.

Quick Start Guide May2023

2 Emerson.com/Rosemount

WARNING

Process leaks could result in death or serious injury.

Ensure that the transmitter is handled carefully. If the process seal is

damaged, gas might escape from the tank.

WARNING

Physical access

Unauthorized personnel may potentially cause significant damage to

and/or misconfiguration of end users’ equipment. This could be

intentional or unintentional and needs to be protected against.

Physical security is an important part of any security program and

fundamental in protecting your system. Restrict physical access by

unauthorized personnel to protect end users’ assets. This is true for

all systems used within the facility.

CAUTION

Hot surfaces

The flange and process seal may be hot at high process

temperatures. Allow to cool before servicing.

1.2 Product recycling/disposal

Recycling of equipment and packaging should be taken into

consideration and disposed of in accordance with local and national

legislation or regulations.

May2023 Quick Start Guide

Quick Start Guide 3

1.3 Spare part numbers

Figure 1-1: LCD Display

A B

A. Graphical LCD display

B. Display cover

Table 1-1: Spare Parts Kits

Part number Description

03408-5000-0001 Graphical LCD (without cover)

03408-5000-0002 Graphical LCD with Bluetooth® connectivity (without

cover)

03408-5000-0003 Graphical LCD upgrade kit (with display cover)

03408-5000-0004 Graphical LCD with Bluetooth connectivity (with display

cover)

1.4 Bluetooth® UID and key

You can find the UID and key on the display unit and on the attached

paper tag.

Figure 1-2: Bluetooth Security Information

Quick Start Guide May2023

4 Emerson.com/Rosemount

2 Install the new LCD display

Prerequisites

Make sure that the device is not exposed to moisture or dust.

Procedure

1. Disconnect the power supply.

2. Turn the jam screw clockwise until it is completely threaded

into the housing.

H2.5 mm

3. Remove the cover.

4. Remove the old LCD display (if fitted).

May2023 Quick Start Guide

Quick Start Guide 5

5. Snap the LCD display into place.

6. Attach and tighten the cover.

a) Verify the cover jam screw is completely threaded into

the housing.

H2.5 mm

b) Attach and tighten the cover.

Note

Make sure the cover is fully engaged. There should be

no gap between the cover and the housing.

Quick Start Guide May2023

6 Emerson.com/Rosemount

c) Turn the jam screw counterclockwise until it contacts

the cover.

Note

Required for explosion-proof/flameproof installations

only.

H2.5 mm

d) Turn the jam screw an additional ½ turn

counterclockwise to secure the cover.

7. Connect the power supply.

May2023 Quick Start Guide

Quick Start Guide 7

3 Affix the radio certification sticker

Prerequisites

This only applies when upgrading to an LCD display with Bluetooth®

connectivity.

Procedure

1. Check the FCC ID and IC numbers on the main label.

2. Pick the sticker with the same FCC ID and IC numbers, but with

an additional "B" at the end.

3. Affix the sticker on the main label over the original FCC ID, IC,

and HVIN numbers.

Quick Start Guide May2023

8 Emerson.com/Rosemount

May2023 Quick Start Guide

Quick Start Guide 9

Quick Start Guide May2023

10 Emerson.com/Rosemount

Autres manuels pour Rosemount 3408

Table des matières

Autres manuels Emerson Émetteur

Emerson

Emerson Rosemount 3051 Manuel utilisateur

Emerson

Emerson Rosemount 4600 Manuel utilisateur

Emerson

Emerson Rosemount 1066 Manuel utilisateur

Emerson

Emerson Rosemount OCX 8800 Manuel utilisateur

Emerson

Emerson Rosemount 3051 Manuel utilisateur

Emerson

Emerson Rosemount 2051G Manuel utilisateur

Emerson

Emerson Rosemount 3051S Series Manuel utilisateur

Emerson

Emerson Rosemount 1057 Manuel utilisateur

Emerson

Emerson Rosemount CX1100 Manuel utilisateur

Emerson

Emerson Micro Motion 5700 Manuel utilisateur

Emerson

Emerson Rosemount 3051 Manuel utilisateur

Emerson

Emerson Rosemount 2051 Manuel utilisateur

Emerson

Emerson Rosemount 248 Manuel utilisateur

Emerson

Emerson Rosemount 3051 Manuel utilisateur

Emerson

Emerson Rosemount 2051 Manuel utilisateur

Emerson

Emerson Rosemount OCX 8800 Manuel utilisateur

Emerson

Emerson Rosemount Analytical HART 5081-A-HT Manuel utilisateur

Emerson

Emerson Rosemount 6888A Manuel utilisateur

Emerson

Emerson Rosemount 644h Manuel utilisateur

Emerson

Emerson Rosemount 3144P Manuel utilisateur

Emerson

Emerson Rosemount 644 Manuel utilisateur

Emerson

Emerson Micro Motion 5700 Manuel utilisateur

Emerson

Emerson Rosemount 1056 Manuel utilisateur

Emerson

Emerson Micro Motion 4200 Guide rapide

Manuels Émetteur populaires d'autres marques

NIVELCO

NIVELCO EasyTREK SCA-300 Series Manuel du propriétaire

Honeywell

Honeywell 5816WMBR Manuel utilisateur

Kamstrup

Kamstrup READy MTU Mode d'emploi

Omega

Omega ZW Series Manuel utilisateur

ABB

ABB Field 264H Mode d’emploi

Alinco

Alinco DJ-V17T Manuel utilisateur

Dejero

Dejero EnGo 3x Manuel utilisateur

Rosemount

Rosemount 4600 Manuel utilisateur

Speaka Professional

Speaka Professional 2342740 Manuel utilisateur

trubomat

trubomat GAB 1000 Manuel utilisateur

Teledyne Analytical Instruments

Teledyne Analytical Instruments LXT-380 Manuel utilisateur

Rondish

Rondish UT-11 Manuel utilisateur

MG 10JRE Manuel utilisateur

Burkert

Burkert 8177 Manuel utilisateur

Firetide

Firetide HotPort 3203 Manuel

Tele Radio

Tele Radio T9-02 Manuel utilisateur

Rotronic

Rotronic HygroFlex HF3 Series Manuel utilisateur

Jamara

Jamara FCX6 Pro Tel Manuel utilisateur