Ekwb EK-FC780 Mode d’emploi

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.0. Released on 21th of March, 2014.

Installation and mounting manual for EK-FC780 GTX Ti DCII Backplate

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability

whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwb.com for updates. Before

installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

STEP 1: GENERAL INFORMATION. Sample picture of nVidia GeForce 780 GTX Ti DCII graphics card.

STEP 2: PREPARING YOUR GRAPHICS CARD

EK-FC780 GTX Ti DCII Backplate is very easy to install. First install EK-FC780 GTX Ti DCII series water block according to its installation manual. If

you have it already installed, please check the picture below to see which mounting screws are to be left in their position and which are to be

removed. Please remove the six (6) M3x4 DIN7985 screws. Leave all washers on their place.

STEP 3: APPLYING THE THERMAL PADS

EK-FC780 GTX Ti DCII Backplate features passive cooling of the printed circuit board and it’s components therefore it is mandatory to install the

enclosed thermal pad. Please install enclosed 1mm thick thermal pad (Thermal Pad A –1,0mm (100x16) and (Thermal Pad C –1,5mm (25x25)

as shown on the picture below. You may need to trim the excess thermal pad. Trim 1,5mm Thermal Pad to fit hole.

Thermal PAD A 1,0mm

EK-FC780 GTX Ti

DCII Backplate

Thermal pad C -1,5mm (50x25)

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.0. Released on 21th of March, 2014.

STEP 4: ATTACHING EK-FC780 GTX DCII BACKPLATE TO THE GRAPHICS CARD

Take enclosed mounting screws and install them as shown on picture below. EKWB recommends users to start with six(6) M3x8 DIN 7991 or.

four(4) M3x8 DIN 7991 and two(2) M3x10 DIN 7991 screws, (HINT: do not tighten screws until they are all positioned in their mounting holes) in

the middle of the card and then continue outwards. The backplate has milled in standoffs, so there is no fear of over tightening of the screws.

Nevertheless do not exaggerate with screwing force as there is no need for it.

(By all means users must also consider that this product is intended to be used only with EK-FC780 GTX Ti DCII series water blocks. No other 3rd

party heat sinks or coolers are supported!)

EKWB short top versions: ACETAL, CSQ TOP-s:

IMPORTANT DISCLOSURES

VERY IMPORTANT NOTICE: Once the installation is completed, it is a recommended practice to test the cooling circuit for leaks prior to powering up the

computer. We recommend a 24 hour leak test prior to powering up the computer. Do not test the water block using city water pressure. This will rupture the top

of the housing and render the block unusable (and will void your warranty).While all efforts have been made to provide the most comprehensive tutorial possible,

EK Water Blocks assumes no liability expressed or implied for any consequential damage(s) occurring to your equipment as a result of using EK Water Blocks

cooling products, either due to errors or omissions on our part in the above instructions, or due to failure or defect in the EK Water Blocks cooling products.

WARRANTY:

Our products are warranted against defects in materials or workmanship for a period of 24 months beginning from the date of delivery to the final user. During

this period, products will be repaired or have parts replaced at our discretion provided that: (I) the product is returned to the agent from whom it was purchased;

(II) the product has been purchased by an end user and has not used for commercial purposes; (III) the product has not been misused, handled carelessly, or

used in a manner other than in accordance with the instructions provided describing its installation and proper use. This warranty does not confer rights other

than those expressly set out above and does not cover any claims for consequential loss or damage. This warranty is offered as an extra benefit and does not

affect your statutory rights as a consumer. This warranty is voided if the product comes in contact with aggressive UV additives or other improper liquids.

EK blocks are sealed with warranty void circular label, which proves that the block has withstood a pressure leak test. Removing it will void leak-free guarantee

and not the guarantee on the product itself. Any other RMA issues can be reported to EK Support at http://www.ekwb.com/support for further analysis.

REQUIRED TOOLS AND MOUNTING SCREWS:

Philips head screwdriver scissors 2mm allen key

M3X8 DIN 7991 screw

M3x10 DIN 7991 screw

PVC WASHER

M3 NUT

Table des matières

Autres manuels ekwb Matériel informatique

ekwb

ekwb EK-Quantum Reflection2 PC-O11D EVO D5 PWM... Manuel utilisateur

ekwb

ekwb MSI MPG X570S Carbon EK X Manuel utilisateur

ekwb

ekwb EK-FC780 GTX Ti Manuel

ekwb

ekwb EK-XRES 140 Revo D5 Series Mode d’emploi

ekwb

ekwb EK-Momentum MSI Z390 MEG GODLIKE Manuel utilisateur

ekwb

ekwb EK-FC Fury X Manuel

ekwb

ekwb EK-Quantum Velocity Ryzen Edition UNC Standoffs -... Manuel utilisateur

ekwb

ekwb EK-FB ASUS Strix X299-E RGB Monoblock Manuel utilisateur

ekwb

ekwb EK-SB ASUS M6G Mode d’emploi

ekwb

ekwb EK Series Manuel utilisateur

ekwb

ekwb EK-PRO GPU WB RTX A100 80GB Manuel utilisateur

ekwb

ekwb EK-Vector RTX 2080 FTW3 Manuel utilisateur

ekwb

ekwb EK-FCQ6000 Manuel

ekwb

ekwb EK-FC780 GTX Ti Manuel

ekwb

ekwb EK-FC780 GTX WF3 Manuel

ekwb

ekwb EK-FC R9-390X TF5 Mode d’emploi

ekwb

ekwb EK-FB KIT GA P67A UD7 Manuel

ekwb

ekwb EK-FC980 GTX Ti Strix Manuel

ekwb

ekwb Velocity - AMD Manuel utilisateur

ekwb

ekwb EK-FC 780 GTX Lightning Manuel

ekwb

ekwb EK-FC670 GTX Series Manuel

ekwb

ekwb EK-FC 6970 V2 Manuel

ekwb

ekwb EK-SF3D Inflection Point EVO Manuel utilisateur

ekwb

ekwb EK-FB KIT RE4 Manuel

Manuels Matériel informatique populaires d'autres marques

EMC2

EMC2 VNX Series Manuel du propriétaire

Panasonic

Panasonic DV0PM20105 Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuel utilisateur

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuel utilisateur

Raidon

Raidon iT2300 Manuel utilisateur

National Instruments

National Instruments PXI-8186 Manuel utilisateur

Hauppauge

Hauppauge WinTV-HVR-2250 Manuel utilisateur

Kontron

Kontron CP6002 Manuel utilisateur

Manhattan

Manhattan 702843 Manuel utilisateur

Aphex

Aphex 230 Manuel utilisateur

AMD

AMD Phenom II Manuel d'exploitation

Intel

Intel NUC 12 Pro Manuel utilisateur

dbx

dbx Zone Pro 1260 Manuel utilisateur

Galaxy

Galaxy GHDX2-2430S-24F4D Manuel utilisateur

Intel

Intel AXXRMFBU4 Manuel utilisateur

Kontron

Kontron DIMM-PC/MD Manuel utilisateur

ST X-NUCLEO-SAFEA1B Mode d'emploi

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuel utilisateur

ekwb EK-FC780 Mode d’emploi

Manuels Matériel informatique populaires d'autres marques