Ekwb EK-FC6990 Manuel

All disclosures, notices and warranty conditions are being written on the back of the box. Released on 7th of April, 2011.

Installation and mounting manual for EK-FC6990 backplate

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability

whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwaterblocks.com for updates. Before

installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

STEP 1: GENERAL INFORMATION. Sample picture of AMD Radeon HD 6990 graphic card (reference design).

STEP 2: PREPARING YOUR GRAPHIC CARD AMD RADEON HD 6990

EK-FC6990 GTX backplate is very easy to install. First install EK-FC6990 water block according to its manual. If you have it already installed, please

check below which mounting screws for water block are to be left in their position. Please remove the nine (9) M3x8 DIN7991 screws marked with

arrow and the original AMD backplate.

STEP 3: APPLYING THE THERMAL PADS

EK-FC6990 backplate features passive cooling of the printed circuit board and it’s components therefore it is mandatory to install the enclosed

thermal pads. Please install the 0.5mm thick thermal pads on the memory ICs itself and 1mm thermal pad on the two extruded stubs on the

backplate itself. You may need to trim excess pad on some of the 1mm thermal pads.

Thickness 0.5mm (for memory ICs)

Thickness 1.0mm

(for VRM)

Thickness 0.5mm (for

memory ICs)

Original AMD

aluminum backplate

All disclosures, notices and warranty conditions are being written on the back of the box. Released on 7th of April, 2011.

STEP 3: ATTACHING EK-FC6990 BACKPLATE

Take enclosed mounting screws and install them as shown on picture below. Before mounting the EK-FC6990 backplate it is obligatory to screw in

additional M3x4 DIN7985 screw and an appropriate washer as shown on the picture below. EKWB recommends users to start with M3x9 screws in

the middle (HINT: do not tighten screws until they are all positioned in their mounting holes). Backplate has milled in standoffs, so there is no fear

of overtightening the screws. Nevertheless, do not exaggerate with screwing force as there is no need for it.

(Please note that EKWB holds no responsibility of any kind if assembly is not made by instructions. This applies also for all products that are not out

of EKWB production line. Users must by all means also consider instructions that are being made for proper use of FC blocks.)

IMPORTANT DISCLOSURES

VERY IMPORTANT NOTICE: Once the installation is completed, it is a recommended practice to test the cooling circuit for leaks prior to powering up the

computer. We recommend a 24 hour leak test prior to powering up the computer. Do not test the water block using city water pressure. This will rupture the top

of the housing and render the block unusable (and will void your warranty).While all efforts have been made to provide the most comprehensive tutorial possible,

EK Water Blocks assumes no liability expressed or implied for any consequential damage(s) occurring to your equipment as a result of using EK Water Blocks

cooling products, either due to errors or omissions on our part in the above instructions, or due to failure or defect in the EK Water Blocks cooling products.

WARRANTY:

Our products are warranted against defects in materials or workmanship for a period of 24 months beginning from the date of delivery to the final user. During

this period, products will be repaired or have parts replaced at our discretion provided that: (I) the product is returned to the agent from whom it was

purchased; (II) the product has been purchased by an end user and has not used for commercial purposes; (III) the product has not been misused, handled

carelessly, or used in a manner other than in accordance with the instructions provided describing its installation and proper use. This warranty does not confer

rights other than those expressly set out above and does not cover any claims for consequential loss or damage. This warranty is offered as an extra benefit and

does not affect your statutory rights as a consumer. This warranty is voided if the product comes in contact with aggressive UV additives or other improper

liquids.

EK blocks are sealed with warranty void circular label, which proves that the block has withstood a pressure leak test. Removing it will void only leaking issues.

Any other RMA issues can be reported to support@ekwaterblocks.com for further analysis.

REQUIRED TOOLS AND MOUNTING SCREWS:

scissors 9 ×PVC washers 1× screw M3x4 DIN7985 8 x screws M3x9 7991DIN 2mm allen key

Use enclosed allen key

on screws to attach

backplate.

M3x9 DIN7991 screw

Please use enclosed PVC

washers under milled

standoffs!

Washer

M3x4 DIN7985 screw

Washer

Install the additional M4x3 DIN7985screw

Table des matières

Autres manuels ekwb Matériel informatique

ekwb

ekwb EK-FB MSI X370 XPower Monoblock Manuel utilisateur

ekwb

ekwb EK-FC 780 GTX DCII Series Manuel

ekwb

ekwb EK-Quantum Momentum Aorus Z490 Master D-RGB Manuel utilisateur

ekwb

ekwb 3831109816202 Mode d’emploi

ekwb

ekwb EK-Annihilator EX/EP Series Manuel utilisateur

ekwb

ekwb EK-FC R9-290X Manuel

ekwb

ekwb EK-FC470 GTX Manuel

ekwb

ekwb EK-Classic Pump Reservoir 160 SPC PWM D-RGB Mode d’emploi

ekwb

ekwb EK-FC980 GTX Strix Manuel

ekwb

ekwb EK-Quantum Vector Trinity RTX 3080/3090 Manuel utilisateur

ekwb

ekwb EK-FC970 GTX ACX Series Manuel

ekwb

ekwb EXTREME 240 Manuel utilisateur

ekwb

ekwb EK-UNI Holder D5 V3 Manuel

ekwb

ekwb EK-Quantum Momentum Aorus X570 Master D-RGB -... Manuel utilisateur

ekwb

ekwb EK-FC1080 GTX Ti FTW3 Manuel utilisateur

ekwb

ekwb EK-Pro CPU Water Block SP5 Manuel utilisateur

ekwb

ekwb EK-FC WX9100 PRO BACKPLATE Manuel utilisateur

ekwb

ekwb EK-FC 5970 Manuel

ekwb

ekwb EK-FC R9-285 Manuel

ekwb

ekwb EK-Classic 115x/20xx D-RGB Manuel utilisateur

ekwb

ekwb EK-FC7950 Manuel

ekwb

ekwb EK-Quantum Momentum VRM Bridge ROG Maximus XII Formula D-RGB -... Manuel utilisateur

ekwb

ekwb EK-FB ASUS Strix X299-E RGB Monoblock Manuel utilisateur

ekwb

ekwb EK-FC980 GTX Classy Manuel

Manuels Matériel informatique populaires d'autres marques

EMC2

EMC2 VNX Series Manuel du propriétaire

Panasonic

Panasonic DV0PM20105 Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Manuel utilisateur

Gigabyte

Gigabyte B660M DS3H AX DDR4 Manuel utilisateur

Raidon

Raidon iT2300 Manuel utilisateur

National Instruments

National Instruments PXI-8186 Manuel utilisateur

Hauppauge

Hauppauge WinTV-HVR-2250 Manuel utilisateur

Kontron

Kontron CP6002 Manuel utilisateur

Manhattan

Manhattan 702843 Manuel utilisateur

Aphex

Aphex 230 Manuel utilisateur

AMD

AMD Phenom II Manuel d'exploitation

Intel

Intel NUC 12 Pro Manuel utilisateur

dbx

dbx Zone Pro 1260 Manuel utilisateur

Galaxy

Galaxy GHDX2-2430S-24F4D Manuel utilisateur

Intel

Intel AXXRMFBU4 Manuel utilisateur

Kontron

Kontron DIMM-PC/MD Manuel utilisateur

ST X-NUCLEO-SAFEA1B Mode d'emploi

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Manuel utilisateur

ekwb EK-FC6990 Manuel

Manuels Matériel informatique populaires d'autres marques