Eaton Nova AVR 500 Manuel utilisateur

www.eaton.com

Installation and User Manual

Manuel d’installation et

d’utilisation

Nova AVR 500

Nova AVR 625

Nova AVR 1250

Battery back-up UPS

Onduleur - ASI

MAU-00046AD - Page 2

IMPORTANT SAFETY INSTRUCTIONS

Read before installing product.

Safety of Persons

The UPS has its own internal power source (the battery). Consequently, the power outlets may be energized even if the UPS is◗

disconnected from the AC-power source.

Dangerous voltage levels are present within the◗

UPS

. It should be opened exclusively by qualified service personnel.

The◗

UPS must be properly earthed. Measurements are required to ensure that the total leakage current of the UPS and the protected

equipment does not exceed 3.5 mA by checking their characteristics.

The battery supplied with the◗

UPS

contains small amounts of toxic materials. To avoid accidents, the directives listed below

must be observed:

- Never burn the battery (risk of explosion).

- Do not attempt to open the battery (the electrolyte is dangerous for the eyes and skin).

- Comply with all applicable regulations for the disposal of the battery.

- Batteries constitute a danger (electrical shock, burns). The short-circuit current may be very high. Precautions must be taken

for all handling: remove watches, rings, bracelets and any other metal objects, use tools with insulated handles.

Product Safety

The UPS connection in◗structions and operation described in the manual must be followed in the indicated order.

UPS must be connected to a nearby wall outlet that is easily accessible. The UPS can be disconnected from the AC-power source by◗

removing the power cord.

Check that the indications on the rating plate correspond to your AC-power system and to the actual electrical consumption of all the◗

equipment to be connected to the UPS.

Never install the UPS near liquids or in an excessively damp environment.◗

Never let a foreign body penetrate inside the UPS.◗

Never block the ventilation grates of the UPS.◗

Never expose the UPS to direct sunlight or source of heat.◗

If the UPS must be stored prior to installation, storage must be in a dry place.◗

The admissible storage temperature range is -25ºC to +55◗ºC

Special Precautions

Once installed an◗d connected to the AC power source for the first time, the battery will start to charge. Full charging to obtain the

rated battery backup time requires at least 8 hours.

Before and after the installation, if the UPS remains de-energized for a long period, the UPS must be energized for a period of 24◗

hours, at least once every 6 months (for a normal storage temperature less than 25°C). This charges the battery, thus avoiding

possible irreversible damage.

During the replacement of the battery module, it is imperative to use the same type and number of element previously mounted◗

in the UPS, in order to maintain an identical level of performance and safety. In case of doubt, don’t hesitate to contact our after

sales department (for more information, refer to the web site www.eaton.com).

MAU-00046AD - Page 3

1. Introduction

Thank you for your purchase of Nova AVR Uninterruptible Power Supply (UPS) from EATON. The Nova AVR UPS is

specially designed for PC users and will provide many years of accurate, trouble-free power protection. Please read this

manual fully to familiarize yourself with the safety and many other features of the Nova AVR product.

2. Installation

The UPS contains voltages which are potentially hazardous◗

This equipment is operator installable and can be operated by an individual with no previous training◗

All repairs should be performed by qualified personnel.◗

CAUTION:

Always turn off all power to computer prior to making any Nova AVR connections.

Connection :

1. Unpack the Nova AVR and accessories.

2. Use the power cord of the computer to connect UPS input cord to a properly sized AC outlet.

3. Connect critical devices (computer, monitor, modem) on output outlets, using the supplied cables.

Additional features :

4. Connect the telephone line / modem on the surge suppressor (cables are not supplied)

5. Connect USB cable between the UPS and the computer. Use EATON Personal Solution-Pac software for power

management (to be downloaded from the web site www.eaton.com)

Start up :

6. Press the ON/OFF switch to start the UPS and allow recharging for 8 hours for full battery capacity.

3. Control and rear panel presentation

Nova AVR 500

4 2

1. Power on/off switch 3. AC output 5. Telephone line / modem protection

2. AC input 4. Fuse

MAU-00046AD - Page 4

Nova AVR 625/1250

1. Power on/off switch 4. AC output 7. USB port for USB models (B type)

2. Indicator 5. Fuse 8. Telephone line / modem protection

3. AC input 6. Circuit breaker

4. LED and Audible Alarm operation Table

Nova AVR 500

LED Status Audible Alarm UPS Status

Green ON

(On/Off switch) None UPS on normal operation

Green ON

(On/Off switch) 1 beep every 10 seconds UPS on battery power

Green ON

(On/Off switch) 1 beep every 2 seconds UPS on battery power

Low battery level

Green ON Continuous beep Internal failure/load short

Green Blinking Continuous beep Overload, reduce load

Nova AVR 625/1250

LED Status Audible Alarm UPS Status

Green ON

(On/Off switch) None UPS on normal operation

Green ON

(On/Off switch) 1 beep every 10 seconds UPS on battery power

Green ON

(On/Off switch) 1 beep every 1 second UPS on battery power

Low battery level

Red ON Continuous beep Internal failure

Red Blinking 1 beep every 0.5 second Overload, reduce load

Red ON None Battery fault

MAU-00046AD - Page 5

Notes:

1. As soon as the UPS is powered, for Nova AVR 625/1250, the battery begins charging, whatever the On/Off

switch position. For Nova AVR 500, press On/Off switch about 1 second, battery begins charging.

2. If the utility power failure exceeds the battery backup time, UPS shutdown to prevent excessive battery

discharge. For Nova AVR 625/1250, UPS will restart as soon as utility returns. For Nova AVR 500, please press

On/Off switch about 1 second to restart UPS.

3. The overload breaker trip off during a severe overload. If this occurs, unplug excessive loads and reset circuit

breaker by pressing its reset button.

4. Do not connect non-computer type loads to Nova AVR outlets.

5. Battery Replacement

CAUTION:

Read and follow safety instructions before removing batteries. This must be done by qualified personnel

due to risk of high energy.

Switch off the UPS and disconnect it from utility power and critical loads◗

Remove watches, rings or other metal objects◗

Use tools with insulated handles◗

Nova AVR 625 battery replacement drawing.

Battery replacement step description:

1. Take off front panel

2. Pull out battery

3. Disconnect battery wire

Note:

Nova AVR 1250 battery replacement is very similar to Nova AVR 625 except 2 batteries contained. Total battery

voltage is 12V for Nova AVR 625 and 24V for Nova AVR 1250.

Nova AVR 500 battery replacement is not applicable.

Disposal of the old battery

Never throw the battery in a fire (risk of explosion)◗

Do not attempt to open the battery (the electrolyte can harm the skin and eyes)◗

Store the battery in a dry location◗

◗The battery contains lead, a substance that can harm the environment if the battery is not disposed of

correctly

The battery must be recycled by a certified organization, in compliance with applicable regulations◗

◗Drop the battery off at authorized collection points or contact EATON to have the battery collected and

recycled

MAU-00046AD - Page 6

6. Performance & Product Specifications

Nova AVR 500 Nova AVR 625 Nova AVR 1250

UPS power rating --- VA 500VA 625VA 1250VA

UPS power rating --- W 250W 360W 660W

Input mains voltage range 165-253V±5% 165-280V±5% 160-290V±5%

Output voltage in mains mode 184-253V±3% 184-253V±3% 184-253V±3%

Output voltage in bat mode 230V + 15/-20%

(184-264V)

230V + 15/-20%

(184-264V)

230V + 15/-20%

(184-264V)

Output frequency in bat mode 50/60Hz±1Hz 50/60Hz±1Hz 50/60Hz±1Hz

Deep discharge protection 4 hours 4 hours 4 hours

UPS backup time 10 minutes for 1 sets PC 15 minutes for 1 sets PC 15 minutes for 2 sets PC

UPS output waveform Quasi-sine Quasi-sine Quasi-sine

Input/Output cord IEC 10A IEC 10A IEC 10A

Input protection Fuse 5A/250V Fuse 5A/250V Circuit breaker 10A/250V

Recharge time 8 hours to recover 80%

after complete discharge

8 hours to recover 80%

after complete discharge

8 hours to recover 80%

after complete discharge

Battery Sealed lead acid battery

12V/4.5Ah x 1

Sealed lead acid battery

12V/7.2Ah x 1

Sealed lead acid battery

12V/7.2Ah x 2

Operating temperature 0-40°C 0-40°C 0-40°C

Relative humidity 10-90% 10-90% 10-90%

Product size 113 x 241 x 145mm 350.5 x 125 x 143 mm 376.5 x 170 x 188 mm

Product weight 4.6 Kg 5.9 Kg 11.2 Kg

7. Trouble Shooting

Nova AVR 500

Condition Item need to check

LED (green) is off, UPS has no output Check if the UPS is correctly plugged to the AC power

available and press On/Off switch about 1 second.

UPS has little or no backup time Charge UPS during 8 hours and try again.

Green ON and beep keep alarm

1. Potential internal failure. Restart UPS. If green LED

still light and beep keep alarm, call for assistance.

2. Check if load short. Take off load and then

restart UPS. If UPS still work abnormally. Call for

assistance

Green Blinking and keep alarm UPS lightly or heavily overload, reduce load. Reset

circuit breaker or change fuse on UPS if necessary

Nova AVR 625/1250

Condition Item need to check

LED (green) is off, UPS has no output Check if the UPS is correctly plugged to the AC power

available and UPS is turned “ON”

UPS has little or no backup time Charge UPS during 8 hours and try again. Consider to

replace battery if backup time is short.

Red ON and beep keep alarm Potential internal failure. Restart UPS. If red LED still

light, call for assistance.

Red Blinking and 1 beep every 0.5

second

UPS lightly or heavily overload, reduce load. Reset

circuit breaker or change fuse on UPS if necessary

Red ON Faulty battery. Recharge battery. Replace battery if

fault reappears.

Any information or advice, please visit our web sit at www.eaton.com or contact EATON after-sales service.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Eaton UPS

Eaton

Eaton 93PS Guide de configuration

Eaton

Eaton Powerware 9125 Manuel utilisateur

Eaton

Eaton Powerware 9135 Manuel utilisateur

Eaton

Eaton 93PM 150 kW SIAC-B Three-Wire Manuel utilisateur

Eaton

Eaton Pulsar Series Manuel utilisateur

Eaton

Eaton 91PS UPS 8-40 kW Manuel

Eaton

Eaton FERRUPS Manuel utilisateur

Eaton

Eaton 1000L Manuel utilisateur

Eaton

Eaton 5S Manuel utilisateur

Eaton

Eaton Powerware 9390 Manuel utilisateur

Eaton

Eaton 9155 UPS20-30kVA Manuel utilisateur

Eaton

Eaton Powerware 9390 Manuel utilisateur

Eaton

Eaton Powerware 9135 Manuel utilisateur

Eaton

Eaton Powerware 5115 Manuel utilisateur

Eaton

Eaton Powerware 9355 Manuel utilisateur

Eaton

Eaton Powerware 9125 Manuel utilisateur

Eaton

Eaton 5E Manuel utilisateur

Eaton

Eaton 9125 Two-in-One UPS 2500 Manuel utilisateur

Eaton

Eaton Powerware 5115 Manuel utilisateur

Eaton

Eaton 5E Gen2 Instructions de montage

Eaton

Eaton Powerware 9120 Manuel utilisateur

Eaton

Eaton 9SX 6000VA Manuel utilisateur

Eaton

Eaton Powerware 5115A USB Manuel utilisateur

Eaton

Eaton ARRAY 3A3 Pro Manuel utilisateur

Manuels UPS populaires d'autres marques

Pylontech

Pylontech Victron & Pylontech US5000 Manuel utilisateur

Tecnoware

Tecnoware EVO DSP PLUS MM 6.8 Manuel utilisateur

Mecer

Mecer ME-1000-WTU Manuel utilisateur

Mustek

Mustek PowerMust 530(B) Plus Manuel d'installation et d'exploitation

Emerson

Emerson Liebert NXL series Manuel utilisateur

MAKELSAN

MAKELSAN BOXER SERIES Manuel utilisateur

Block

Block PC-0524-400-0 Manuel utilisateur

CyberPower

CyberPower CP585LCD Manuel utilisateur

CyberPower

CyberPower Office Tower Series UPS 1000 Manuel utilisateur

CyberPower

CyberPower BM100 Manuel utilisateur

Best Power

Best Power 610 Manuel utilisateur

Best Power

Best Power Unity/I UT3K Manuel utilisateur

Mustek

Mustek PowerMust 400 Offline Manuel utilisateur

Xantrex

Xantrex Trace 512 UR-UPS Manuel utilisateur

Forza

Forza SL-1501UL Manuel utilisateur

LEGRAND

LEGRAND keor 310081 Manuel utilisateur

ABB

ABB Conceptpower DPA 500 Manuel utilisateur

ZincFive

ZincFive BC Series Manuel utilisateur