Dension Gateway 500 Lite D2B Manuel utilisateur

Gateway 500 Lite D2B

Installation Guide

v1.3

GWL-9211-3

1. INTRODUCTION

Gateway 500 Lite D2B emulates a CD changer and

uses CD changer controls to access off board audio

sources like iPod and USB devices.

2. CONNECTIONS

3. INSTALLATION

The best place to install the Gateway 500 Lite D2B

maybe somewhere behind the dashboard / head unit.

Remove the car’s head unit from the dashboard

according to car manufacturer instructions. If you do not

have a CD changer in your car, please make sure that

the head unit can control a CD changer (e.g. products

light at optical output socket of the head unit.) If not,

please refer to an official Mercedes service, where they

can easily reprogram the head unit to enable the optical

network for Gateway 500 Lite D2B . If you finished this

step or you made sure that the car’s D2B network can

accept a CD changer or a CD Changer exists in your

car please do the following.

4. ELECTRICAL INSTALLATION

(2.) Join the power harness of the Gateway 500 Lite D2B

to the radio.

Plug the power cable lead to the Gateway 500 Lite D2B .

The allocation of the #1 cable is the following:

Red: + 12V battery

Black: GND

Purple: Wakeup

See the pinout of the Mercedes power harness of

different head units.

Audio 10/30

Note:

If the indicated Pin is not populated, make the

connection to the blue/black wire or if that wire does

not exist, measure the right Pin location using a

multimeter. If you have any doubt during the

installation, please ask help from professional

installer in order to avoid any problem.

If you have a Comand head unit the socket of the radio

is different from the other head units.

Comand 2.0/2.5

The pinout of certain Comand head units can differ

from the drawing above. If the GND and +12V pin of

your Head Unit can be found in the position as

indicated in the following picture, then the wakeup wire

should be connected to a different pin.

(The basic voltage level of wakeup line is +12V.)

Note:

If the indicated Pin is not populated, make the

connection to the blue/black wire or if that wire

does not exist, measure the right Pin location

using a multimeter. If you have any doubt during

the installation, please ask help from professional

installer in order to avoid any problem.

5. OPTICAL INSTALLATION

Mercedes cars can have two different layouts of optical

network. That is why the D2B optical kit contains two

different optical harnesses (labels on them will help).

The #22 belongs to the cars with Comand (made by

Bosch) head units and #21 to the others.(3. and 4.)

Unplug the connector of the optical harness from the

head unit and connect it to the #21/22 socket of the

optical harness of the Gateway 500 Lite D2B . If there is

no factory fitted optical cable connected to the Head

Unit, you should connect the given #23 optical loop to

the spare female connector of the #22 optical cable.

(5.) Connect the #21/22 A connector to the back of head

unit.

(6.) Plug the last flying connector of your optical harness

to the Gateway 500 Lite D2B interface, with this step you

are connected to the D2B optical ring.

Finally connect each cable according to the numbers in

the first picture. Lead away the cables where the devices

will be placed. (e.g. the glove compartment or the center

console).

6. TEST AND REFIT

Before you refit the head unit, test the Gateway 500 Lite

D2B with your car audio, making sure all connections are

correct and that you have full functionality.

Note:

If during testing you notice any changes or

inconsistencies in the way the car’s electrical system

operates, disconnect the Gateway product

immediately and consult your dealer.

Take care not to trap any wires and cables or the Dension

product. Refit is the reversal of the removal process for

your specific vehicle, as per your manufacturer’s

instructions.

All photos / illustrations are for representation purposes

only and may differ visually from the equipment in your

vehicle. Information correct at time of going to print E. &

O. E. Dension Audio Systems Ltd. and its registered

partners cannot be held liable for any damages caused by

the incorrect installation of any Dension product.

If you need further assistance in using your Dension

product, please contact your local supplier or visit

www.dension.com/support and open support ticket.

Table des matières

Autres manuels Dension Porte

Dension

Dension 500S Manuel utilisateur

Dension

Dension Lite BT Manuel utilisateur

Dension

Dension 500S BT Manuel utilisateur

Dension

Dension Gateway Pro BT Manuel utilisateur

Dension

Dension GBL-9222-1 Manuel utilisateur

Dension

Dension GWL-9201-1 Manuel utilisateur

Dension

Dension ice>Link Gateway 500 Manuel utilisateur

Dension

Dension GWP-9206-1 Manuel utilisateur

Dension

Dension 500S Manuel utilisateur

Dension

Dension Lite BT Mode d’emploi

Dension

Dension Gateway Blue Manuel utilisateur

Dension

Dension GW 100 Manuel utilisateur

Dension

Dension GWL-9210-1 Manuel utilisateur

Dension

Dension ice Link Gateway 100 Manuel utilisateur

Dension

Dension OC2 Manuel utilisateur

Dension

Dension Lite BT GBL-9230-1 Manuel utilisateur

Dension

Dension GBL-9220-1 Manuel utilisateur

Dension

Dension Gateway Lite Manuel utilisateur

Dension

Dension GWP-9210-1 Manuel utilisateur

Dension

Dension DEGW5-9210-7 Manuel utilisateur

Dension

Dension GWL-9231-1 Manuel utilisateur

Dension

Dension Gateway Pro BT Manuel utilisateur

Dension

Dension iGateway GW1-9202-1 Manuel utilisateur

Dension

Dension GW53MO1 Manuel utilisateur

Manuels Porte populaires d'autres marques

LST

LST M500RFE-AS Manuel utilisateur

Kinnex

Kinnex Media Gateway Manuel utilisateur

2N Telekomunikace

2N Telekomunikace 2N StarGate Manuel utilisateur

Mitsubishi Heavy Industries

Mitsubishi Heavy Industries Superlink SC-WBGW256 Manuel utilisateur

ZyXEL Communications

ZyXEL Communications ZYWALL2 ET 2WE Manuel utilisateur

Telsey

Telsey CPVA 500 - SIP Manuel utilisateur

RTA

RTA 460A-NNA4 Fiche technique

Shaw

Shaw Gateway HDPVR Manuel utilisateur

ABB

ABB VSN900 Guide de démarrage rapide

Commander

Commander Pulse Manuel utilisateur

2N Telekomunikace

2N Telekomunikace ATEUS EasyGate 501309E Manuel utilisateur

NETGEAR

NETGEAR C6300BD Manuel utilisateur

Amit

Amit CDW531AM Manuel utilisateur

HMS

HMS Netbiter EasyConnect EC150 Manuel utilisateur

Huawei

Huawei EchoLife HG620 Manuel utilisateur

AT&T

AT&T U-verse 3801 Manuel d'utilisation et d'entretien

Logic IO

Logic IO RTCU MX2 turbo Manuel utilisateur

Suttle

Suttle MediaMAX MXM-521 Manuel utilisateur