Danfoss REP24CO Manuel utilisateur

REP24 CO

GB Installation Instructions

User Instructions

Electronic Proportional Heat / Cool Thermostat

with Manual Heat/Cool Selection

Index

INDEX

Installation Instructions 3-5

User Instructions 6

Please note

This product should only be installed by a suitably qualied

electrician or heating installer. The installation must comply

with local Building Regulations and Wiring Regulations,

including any competent person requirements that may exist.

Installation Instructions

Thermostat features

Temperature Range 10-30°C

Thermostat Heat, Standby, Cool

Selector Yes

Power Supply 24 Vac ± 15%, 50/60Hz

Control Method P+I, 2k Proportional Band

Dimensions (mm) 110 wide x 90 high x 40 high

Design Standard EN60730-2-9

Rated Impulse Voltage 2.5Kv

Ball Hardness Test 75°C

Control Pollution Situation Degree 2

Temperature Accuracy ±1°C

Control Output 0 - 10 Vdc

Specication

Product overview

This thermostat is designed for fan coil and chilled beam

applications alongside proportional valve and actuator systems

where a 0-10v proportional control output is required.

Installation

First remove the wallplate from the back of the unit.

Fix at a height of approximately 1.5m from the oor, away

from draughts or heat sources such as fan-coil outlets,

sunlight or oce equipment.

Installation Instructions

Wiring

Connection Diagram

COM

0V/

return

Electronics

Heating

24 Vac

Cool Heat

Cooling

0-10V outputs

0V 24V

Installation Instructions

Mounting thermostat to the wallplate

To mount the thermostat to the wallplate, align the tabs on

the top of the thermostat with the apertures in the wallplate

and hinge the thermostat down, pressing rmly to engage

the securing clip in the wallplate.

Fan Con Fan Auto

Sw On

MOT WAX

DIL Switch options, shown in factory set position.

DIL Switch Descriptions

Switch 1: Not used on this model

Switch 2: MOT - Motorised valve actuator selection.

WAX - Wax valve actuator selection.

User Instructions

Setting the temperature

Turn the setting dial to the required temperature.

Frost Protection

To activate frost protection, turn the dial below 10°C. Frost

protection becomes active at 8°C. If the temperature in the room

drops below 8°C then the output will activate.

When frost protection is activated the right LED will turn orange.

Standby Mode

In cooling mode, the standard frost protection is not available;

instead there is standby mode. When the dial is turned past 10°C

the unit enters standby mode and cooling will be inactive until the

dial is turned up past 10°C.

Locking & limiting

To lock or limit the setting range turn the setting dial to 3 and

remove knob.

 Position the locking springs on the rear of the dial to the

desired position and re-mount the knob ensuring that

number 3 on the dial aligns with the reference mark on the

case.

User Instructions

Heat Mode

Standby Mode

Cool Mode

LED lit green when

thermostat is powered

LED o when setpoint reached

LED red when heating

LED green when cooling

LED orange when frost

protection activated

Temperature setting dial

Frost protection mode

8Part No 25284v01 07/08

www.danfoss.com/BusinessAreas/Heating

(2004/108/EC)

(2006/95/EC)

Table des matières

Autres manuels Danfoss Thermostat

Danfoss

Danfoss GET B-RF Mode d’emploi

Danfoss

Danfoss RESD Series Manuel utilisateur

Danfoss

Danfoss living connect Z Manuel utilisateur

Danfoss

Danfoss TP5001RF Manuel utilisateur

Danfoss

Danfoss RET 230 Manuel utilisateur

Danfoss

Danfoss living connect Z Manuel utilisateur

Danfoss

Danfoss CET2000B-RF + RX1-S + CS2 Manuel utilisateur

Danfoss

Danfoss ECL Comfort 210 Manuel utilisateur

Danfoss

Danfoss HC75A-1 Manuel d'utilisation

Danfoss

Danfoss DBR Manuel utilisateur

Danfoss

Danfoss RET B Mode d'emploi

Danfoss

Danfoss TP75M Manuel utilisateur

Danfoss

Danfoss FH-CWP Manuel utilisateur

Danfoss

Danfoss DEVIreg 531 Manuel utilisateur

Danfoss

Danfoss LX 420 Manuel utilisateur

Danfoss

Danfoss ECtemp 535 Manuel utilisateur

Danfoss

Danfoss GreenCon RC-C2 Manuel utilisateur

Danfoss

Danfoss MBC 8000 Manuel utilisateur

Danfoss

Danfoss TP5000 RF Si Mode d’emploi

Danfoss

Danfoss ECL Comfort 310, A302 Manuel utilisateur

Danfoss

Danfoss 088U0215 Manuel utilisateur

Danfoss

Danfoss ECtemp Touch Manuel utilisateur

Danfoss

Danfoss Icon Master Manuel utilisateur

Danfoss

Danfoss TP7001 series Manuel utilisateur

Manuels Thermostat populaires d'autres marques

EWELLY

EWELLY EW-181 Manuel utilisateur

Prolon

Prolon T1100 Instructions d'installation

Computherm

Computherm Q20 Manuel utilisateur

Heatmiser

Heatmiser neoStat Manuel utilisateur

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Manuel utilisateur

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manuel utilisateur

Saswell

Saswell SAS920XWHB-7-S-RF Mode d’emploi

Aircalo

Aircalo TFP1-ET85P2 Manuel utilisateur

Honeywell

Honeywell CM721 Manuel utilisateur

Carrier

Carrier DEBONAIR 33CS Manuel utilisateur

Lennox

Lennox iHarmony Zone Thermostat Instructions de montage

Gemtech

Gemtech GT7000 Mode d’emploi

Rollei

Rollei Smartes 45000 Manuel utilisateur

Sinope

Sinope TH1300RF Manuel utilisateur

Honeywell

Honeywell RLV4305 Manuel utilisateur

Honeywell

Honeywell Prestige 2.0 THX9421 Manuel utilisateur

NuTone

NuTone NTBZ48 Instructions d'utilisation d'origine

Stelpro

Stelpro MAESTRO ASMT402AD Manuel utilisateur