SR Series Inverter
1-2-7. Install the inverter in a well-ventilated area. Do not block the front
air vents, or the rear air exhausts of the unit.
1-2-8.
proper use; correct wiring sizes must be ensured.
1-2-9. Mount the inverter such that the fan axis is horizontal.
1-2-10.Do not operate the inverter close to combustible gas or open fire.
1-2-11. Do not operate appliances that may feed power back into the
inverter.
1-2-12.Temperature: The inverter should be operated in an ambient
may be affected. Air flow to the inverter must not be restricted.
1-2-2. Do not operate near water or in excessive humidity.
1-2-3. Do not open or disassemble the inverter, warranty may be voided.
1-2-4. The DC side connections should be firm and tight.
1-2-5. Grounding: Reliable grounding of rack-mounted equipment should
be maintained.
1-2-6. Do not drop a metal tool on the battery. The resulting spark or short-
circuit on the battery or on the other electrical part may cause an
explosion.
Wiring: Adequate input power must be supplied to the inverter for
temperature range of 0°C to 50°C or else the output efficiency
1-3. Rack-Mounted Installation
1-3-1. "Equipment intended for installation in Restricted Access Location" and
Input DC terminal at back of Rack to prevent qualified service personnel
can be touch.
Rack-Mounted Equipment – The unit is intended to be rack-mounted, the
Installation Instructions shall contain wording to address the following concerns
when the unit is mounted in a rack system.
A. “The equipment is to be installed in an environment with maximum ambient
temperature must not exceed 50°C.”
B. “The openings on the enclosure are for air convection hence protected the
equipment from overheating. DO NOT COVER THE OPENINGS.”
C. “Lay this equipment on a reliable surface when install. A drop or fall could
cause injury.”
D. “The equipment shall be installed according to specification as nameplate.
Make sure the voltage of the power source when connect the equipment to
the power outlet. The current of load and output power of loads shall be not
over the specification.”
E. “This equipment must be connected to the reliable earthing before using.”
4
