CHIEF MAGNA-VIEW Manuel utilisateur

CHIEF MANUFACTURING INC.

1-800-582-6480 952-894-6280 FAX 952-894-6918

12800 HIGHWAY 13 SOUTH, SUITE 500

SAVAGE, MINNESOTA 55378 USA

CONTROLLER BOARD BOX

TERMINAL FUNCTION DEFINITIONS

TERMINAL

NUMBER FUNCTION DESCRIPTION WIRING OPTIONS NOTES

124 VOLT AC 24 volt AC output

224 VOLT AC

COMMON 24 volt AC common

This is an internal power

supply for powering external

devices & Remote

Controllers.

Chief Mfg. offers the RC-10

Radio Frequency Remote

Controller which runs off of

this power supply.

3GROUND Ground

412 VOLT DC 12 volt DC

This is an internal power

supply for powering external

devices &/or used for

initiating specific functions

(Extend/Retract 5 or Voltage

Sensor 7).

5EXTEND/

RETRACT

Initiates movement if lift is static, or

stops movement if lift is in motion.

Direction of travel will be opposite of

last direction of travel.

Function operates on

momentary switch only.

Operating range is 5 – 30

Volts AC or DC.

6EXTEND/

RETRACT

COMMON

Used in conjunction with

Extend/Retract when using an

external power source to initiate

movement.

To Operate using Internal Power

Source

Connect terminals 3 & 6 with

Jumper Wire. Connect Momentary

Switch to terminal 4. Connect

other line of Momentary Switch to

terminal 5.

To Operate using External Power

Source

Connect External Power Supply’s

Common to terminal 6. Connect

initiating signal to terminal 5.

NOT TO BE USED AS

GROUND FOR FUNCTION

OTHER THAN

EXTEND/RETRACT

TERMINAL 5.

7VOLTAGE

SENSOR

When terminal senses voltage, unit

will extend.

When terminal senses cessation of

voltage, unit will retract.

Operating range is 5 – 30

Volts AC or DC.

8VOLTAGE

SENSOR

COMMON

Used in conjunction with Voltage

Sensor when using an external power

source to initiate movement.

Voltage Sensing

Connect positive lead to terminal 7.

Connect Ground of switching

device to terminal 8.

Single-Pull/Throw Latching Switch

Connect terminals 3 & 8 with

Jumper Wire. Connect first Switch

Terminal to terminal 4.

Connect other Switch Terminal to

terminal 7.

NOT TO BE USED AS

GROUND FOR FUNCTION

OTHER THAN VOLTAGE

SENSOR TERMINAL 7.

9SERVICE

EXTEND

Extends unit to maximum limit,

bypassing normal-use travel setting.

Often used for servicing projectors in

ceiling lifts.

Momentary or Latching contact to

Ground terminals 3, 10, 13, or 20.

Feature not available on all

models.

If using Latching Switch, be

sure to disengage Switch prior

to initiating any other

function.

10 GROUND Ground

Table des matières

Autres manuels CHIEF Support et étagère

CHIEF

CHIEF FHB3036 Manuel utilisateur

CHIEF

CHIEF KTP-Series Manuel utilisateur

CHIEF

CHIEF FCAX08 Manuel utilisateur

CHIEF

CHIEF TPS Series Manuel utilisateur

CHIEF

CHIEF iC Series Manuel utilisateur

CHIEF

CHIEF XFA1U Manuel utilisateur

CHIEF

CHIEF PSS2000 Manuel utilisateur

CHIEF

CHIEF PST 2000 Series Manuel utilisateur

CHIEF

CHIEF CM7W12U Manuel utilisateur

CHIEF

CHIEF QMP1MM2 Manuel utilisateur

CHIEF

CHIEF PNR Manuel utilisateur

CHIEF

CHIEF STLU Manuel utilisateur

CHIEF

CHIEF MSP-GBARKTP320 Manuel utilisateur

CHIEF

CHIEF FSD-4100 Manuel utilisateur

CHIEF

CHIEF OLCB2X1U Manuel utilisateur

CHIEF

CHIEF KBD-MINI Series Manuel utilisateur

CHIEF

CHIEF CM4S57 Manuel utilisateur

CHIEF

CHIEF K0W100 Manuel utilisateur

CHIEF

CHIEF SLB-317 Manuel utilisateur

CHIEF

CHIEF Kontour KRA226 Manuel utilisateur

CHIEF

CHIEF WMAC16 Manuel utilisateur

CHIEF

CHIEF PAC-170 Manuel utilisateur

CHIEF

CHIEF Large Flat Panel Dual Arm Wall Mount PNR Manuel utilisateur

CHIEF

CHIEF MCS6000 Series Manuel utilisateur

Manuels Support et étagère populaires d'autres marques

Salamander

Salamander Acadia AC/W/L400/WH Manuel utilisateur

Fohhn

Fohhn VAT-09 Guide de l'utilisateur

ricoo

ricoo FS0522 Manuel utilisateur

AMSOIL

AMSOIL BMK-22 Guide rapide

Kargo Master

Kargo Master 48220 Manuel utilisateur

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manuel utilisateur

ricoo

ricoo S1222 Manuel utilisateur

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manuel utilisateur

VidaBox

VidaBox VB MNT FFS2 Manuel utilisateur

Welch Allyn

Welch Allyn 48960 Manuel utilisateur

Arkon

Arkon CM035-ST-2 Manuel utilisateur

PROEL

PROEL PLWIN60C Manuel utilisateur

Agilent Technologies

Agilent Technologies E2609B Manuel utilisateur

Mustang

Mustang MV-ARM4 Manuel utilisateur

Mounting Solutions

Mounting Solutions WRM-320 Manuel utilisateur

Pyle

Pyle PMKSPAD1 Manuel utilisateur

ShelterIt

ShelterIt 21208 Manuel utilisateur

SPL

SPL RackPack?4 1040 Manuel utilisateur