Cabletron Systems 9C300-1 Guide de démarrage rapide

PN 9031321-02 Page 1

9C300-1 ENVIRONMENTAL MODULE BOOT PROM UPGRADE INSTRUCTIONS

Introduction

These upgrade instructions explain how to upgrade the Boot PROMS in the 9C300-1 Environmental Module. To help

eliminate any potential problems during or after the upgrade, please be sure to read and understand all of the instructions

in this document and in the release notes supplied in this Upgrade kit.

The upgrade involves removing the metal cover that protects the PCB board, removing the existing Boot PROMS and

replacing them with new Boot PROMS. Follow the detailed steps under each task listed to successfully complete the

replacement. Before beginning work, make sure the chassis is powered off in a logical and orderly fashion.

This Upgrade kit contains:

• 1 prom #02151161-02 low Boot PROM

• 1 prom #02151162-02 high Boot PROM

• 1 PLCC extraction tool

• 1 set of release notes

• 1 set of 9C300-1 Environmental Module Boot PROM Upgrade Instructions

In addition to the information listed above, you will also need:

• A medium size Phillips screwdriver

To avoid damage from static discharge, be sure to observe all static precautions during this

procedure. Failure to do so could result in damage to the Boot PROMS.

CAUTION

Page 2 PN 9031321-02

Removing Metal Cover

1. Before you begin, shut down the SmartSwitch 9000 Chassis in a logical and orderly manner and set up a static free

work area.

2. Remove the Environmental Module from the SmartSwitch 9000 Chassis.

3. Set the Environmental Module down in the static free work area, with the front of the Environmental Module to

the left.

4. Referring to Figure 1, complete the following steps:

a. Remove the four small screws from the top front of the cover and set aside.

b. Remove the single screw from each side and set aside.

c. Remove the eight screws and lock washers from the fan grills and set aside.

5. Remove the four grills covering the fans and set aside.

6. Remove the metal cover to expose the PCB board and set aside.

Figure 1. Removing Metal Cover

small

large screws

screws

single side screw

fan grill

PN 9031321-02 Page 3

Removing Existing Boot PROMS

1. Referring to Figure 2, locate the sockets numbered U201 and U143.

2. Remove the Boot PROM, following the steps detailed in the “Extraction Procedure” section of the instruction sheet

packaged with the extraction tool.

3. Repeat this procedure for the PROM in socket number U143.

Figure 2. Socket Locations

Inserting Replacement Boot PROMS

1. Referring to Figure 3, align the diagonal side of Boot PROM number 02151162-02 with the diagonal corner of

socket U201.

2. Gently and evenly apply downward pressure on the Boot PROM pushing it into the socket.

3. Repeat steps 1 and 2 to insert Boot PROM number 02151161-02 into socket U143.

Figure 3. Inserting Replacement Boot PROMS

U201 U143

02151162-02

U201

Diagonal

Corner

Page 4 PN 9031321-02

Replacing Metal Cover

1. Replace the metal cover over the PCB board by lining up the holes in the metal cover with the corresponding holes

on the Environmental Module.

2. Replace the six small screws (four on the top and one on each side).

3. Replace the four fan grids and secure with the eight large screws and lock washers.

Getting Help

If you need additional support related to this device, or if you have any questions, comments, or suggestions concerning

this manual, contact the Cabletron Systems Global Call Center:

Before calling the Cabletron Systems Global Call Center, have the following information ready:

• Your Cabletron Systems service contract number

• A description of the failure

• A description of any action(s) already taken to resolve the problem (e.g., changing mode switches,

rebooting the unit, etc.)

• The serial and revision numbers of all involved Cabletron Systems products in the network

• A description of your network environment (layout, cable type, etc.)

• Network load and frame size at the time of trouble (if known)

• The device history (i.e., have you returned the device before, is this a recurring problem, etc.)

• Any previous Return Material Authorization (RMA) numbers

Phone (603) 332-9400

Internet mail suppor[email protected]

FTP ctron.com (134.141.197.25)

anonymous

Password

your email address

BBS (603) 335-3358

Modem setting 8N1: 8 data bits, No parity, 1 stop bit

For additional information about Cabletron Systems or our products,

visit our World Wide Web site:

http://www.cabletron.com/

For technical support, select

Service and Support

Autres manuels pour 9C300-1

Table des matières

Autres manuels Cabletron Systems Matériel réseau

Cabletron Systems

Cabletron Systems Netlink FRX4000 Manuel utilisateur

Cabletron Systems

Cabletron Systems WPIM T1 Manuel utilisateur

Cabletron Systems

Cabletron Systems TRMIM-22 Manuel utilisateur

Cabletron Systems

Cabletron Systems MMAC-5FNB Manuel utilisateur

Cabletron Systems

Cabletron Systems BRIM F6 BRIM-F6 Manuel utilisateur

Cabletron Systems

Cabletron Systems 9C300-1 Manuel utilisateur

Cabletron Systems

Cabletron Systems TRBMIM-T Manuel utilisateur

Cabletron Systems

Cabletron Systems Cabletron BRIM-F6 Manuel utilisateur

Cabletron Systems

Cabletron Systems EPIM-3PS Manuel utilisateur

Cabletron Systems

Cabletron Systems SWPIM-BRI Manuel utilisateur

Cabletron Systems

Cabletron Systems Expansion module 9T122-08 Guide de démarrage rapide

Cabletron Systems

Cabletron Systems 9E429-36 Guide de démarrage rapide

Cabletron Systems

Cabletron Systems Spectrum EMM-E6 Instructions d'installation et d'utilisation

Cabletron Systems

Cabletron Systems SPECTRUM FRX6000 Manuel utilisateur

Cabletron Systems

Cabletron Systems HSIM-FE6 Manuel utilisateur

Cabletron Systems

Cabletron Systems MMAC-Plus 9E423-24 Manuel utilisateur

Cabletron Systems

Cabletron Systems MMAC-Plus 9G536-04 Manuel utilisateur

Cabletron Systems

Cabletron Systems CBUPRI/E1 Manuel utilisateur

Cabletron Systems

Cabletron Systems TRBMIM Manuel utilisateur

Cabletron Systems

Cabletron Systems 6E122-26 Manuel utilisateur

Cabletron Systems

Cabletron Systems NBR-220 Manuel utilisateur

Cabletron Systems

Cabletron Systems WPIM-SY Manuel de programmation

Cabletron Systems

Cabletron Systems ELS10-26 Manuel utilisateur

Cabletron Systems

Cabletron Systems TRFMIM-22 Manuel utilisateur

Manuels Matériel réseau populaires d'autres marques

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manuel utilisateur

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manuel utilisateur

Yudor

Yudor YDS-16 Manuel utilisateur

D-Link

D-Link ShareCenter DNS-320L Manuel utilisateur

Samsung

Samsung ES1642dc Instructions d'utilisation

Honeywell Home

Honeywell Home LTEM-PV Instructions de montage

evertz

evertz 7700 Series Manuel utilisateur

D-Link

D-Link ShareCenter DNS-343 Manuel utilisateur

Asante

Asante AsanteBridge 1012 Manuel utilisateur

FireBrick

FireBrick FB2700 Manuel utilisateur

Audiovox Electronics

Audiovox Electronics ARWH2T Manuel utilisateur

ADC

ADC DSX-1 Manuel

NetComm

NetComm NF2 Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 5620 Manuel utilisateur

Dell EMC

Dell EMC XC6420 Series Manuel utilisateur

Lanner

Lanner NCA-1020A Manuel utilisateur

Allied Telesis

Allied Telesis AT-TN121-A Manuel utilisateur

Arista

Arista CCA-ETM-Q12 Manuel utilisateur