Bosch DS940P Manuel utilisateur

DS940P/DS940PT

Passive Infrared Detector

With Pet Immunity

Installation Instructions

1.0 Description

The DS940P is a high performance Passive Infrared (PIR) Motion Sensor which uses advanced signal processing to provide outstanding

catch performance and unsurpassed false alarm immunity. It is designed to detect movement in the interior of a structure by sensing the

Infrared energy emitted from the human body as it moves across the sensor’s field of view. When motion is detected the unit sends an alarm

signal to the Control Panel. With Bosch Security Systems Pet Friendly®pet immunity, the DS940P will not detect a dog up to 30 pounds (13

kilos), two cats, or numerous rodents. This pet immunity feature has not been tested by Underwriters Laboratories.

2.0 Specifications

•Input Power: 9-15 volts DC

•Current Draw: 17 mA @ 12 VDC (standby and maximum)

•Standby Power: No internal standby battery. For UL Listed Prod-

uct Installations, 4 hours (68 mAh) standby pow-

er must be provided.

•Relay Form “A” Normally Closed (NC) contact set rated

for 125 mA@ 28 volts maximum DC, 18 volts

maximum AC for resistive loads.

•Tamper: (DS940PT only) Normally Closed (with cover on).

Contacts rated at 28 VDC, 125mA max. Connect

tamper circuit to a 24hr. protection circuit.

•Temperature: -20° to +120°F (-29° to +49°C). For UL Listed

Product Installations, the temperature range is

+32° to +120°F (0° to +49°C).

•Humidity: 0 - 85% non-condensing.

•Dimensions: 3 in. H x 2.25 in. W x 1.5 in. D

(7.6 cm x 5.7 cm x 3.8 cm)

•Options: B335SwivelMountingBracket.Useofthisbracket

may decrease the PIR range and increase dead

zones.

• Reading Bosch Security Systems, Inc. Product Date Codes

For Product Date Code information, refer to the Bosch Security

Systems, Inc. Web site at: http://www.boschsecurity.com/

datecodes/

3.2 Press the vertical adjust tab

toward the side of the case and

lift out the board.

3.4 Avoid.

3.0 Installation

3.1 Remove the cover using

a small flat-blade

screwdriver.

3.3 Select a mounting location.

Mountthe sensorwherean

intruder will most likely cross

throughthe coveragepattern.

3.5 Observe the pet immunity mounting recommendations.

Bottom of Detector

Insert screwdriver here or here

Pet

Immune

Area

LED

7.5-9ft

Don't point where pets can climb

Note: The upper areas are not

pet immune.

7.5 - 9 ft.

(2.25 - 2.7 m)

Mount the detector 7.5 - 9 feet

(2.25 - 2.7 meters) above the floor

Moving Objects

Heat

Sources

Windows

and

Uninsulated

Walls

Air

Conditioning

Outlets

Direct Hot or

Cold

Drafts

Mounting

Outdoors

Direct Sunlight

2/11

DS940P/DS940PTInstallationInstructions

P/N: F01U035202-07 Page 2

130 Perinton Parkway, Fairport, New York 14450

www.boschsecurity.com

3.6 Mount the detector. 3.8 WiretheDetector.

5.0 CoveragePatterns

3.9 Select LED Operation 3.10 In non-pet applications only,

if look-down is desired, peel

awaythelook-downmasks.Do

not remove the clear plastic

lens.

3.7 Snap the board into the clip so that

the notch aligns with the tab on the

clip.

4.0 WalkTest.PerformtheWalkTest

at the time of installation and

annuallythereafter.

Corner Mount

Surface

Mount

Remove

Thinwall knockouts

for wiring =7.5 - 9 Ft

(2.25 - 2.7 m)

Areas

if using the

B335 Bracket

Do not use

the B335

Bracket in

pet

applications

Don't overtighten the mounting screws

Cover may not attach correctly

LED

7.5-9ft

OFF

LED

7.5-9ft

Peel away

the mask

LED

7.5-9ft This detector contains an environmental sta-

bilization circuit which requires

approximately 2 minutes after

initial power-up to warm up.

During this time the detector will

not respond to any movement.

Please wait 2 minutes after initial power-

up to perform any walk tests.

LED

9-15

VDC Alarm

Contacts Tamper

Contacts

Normally Closed (NC) contacts

(DS940PT

only)

Note:To avoid possible circuit board damage,

use only the mounting hardware

provided in the appropriate punch-out

mounting holes.

DS940P Lens

(inside view)

1234567891011

12 22

23 33

34 44

45 55

56 66

67 77

Althoughgenerally notrequired, if

maskingis desired, thelensdiagram

showstheappropriate areas to be

masked(seeshaded area on the

DS940Plens diagram).Use an

opaquematerial (such as,electrical

tape)tomask the desired areas.

010

012

1234

Meters

Feet

Look

Down

67-

77 56-

66 45-

55 34-

44 23-

33 12-

22 1-

11 40

2010

20 126

7.5

Feet

Meters

Ce manuel convient aux modèles suivants

Autres manuels Bosch Capteur de sécurité

Bosch

Bosch ISC-BDL2-WP12 Manuel utilisateur

Bosch

Bosch IR LD 1.0 Manuel utilisateur

Bosch

Bosch RADION PIR RFPR-12 Manuel utilisateur

Bosch

Bosch GMS 120 Manuel utilisateur

Bosch

Bosch ISP-SM90-120 Manuel utilisateur

Bosch

Bosch ISW-ZPR1-WP13 Manuel utilisateur

Bosch

Bosch CS LD 1.0 Manuel utilisateur

Bosch

Bosch BMA400 Mode d’emploi

Bosch

Bosch FCP-O 500 Manuel utilisateur

Bosch

Bosch Motion Detector Manuel utilisateur

Bosch

Bosch DS150I Manuel utilisateur

Bosch

Bosch 520 Series Manuel utilisateur

Bosch

Bosch TriTech+ ISC-PDL1-WA18G Manuel utilisateur

Bosch

Bosch WEU PDO 6 Manuel utilisateur

Bosch

Bosch DS935Z Manuel utilisateur

Bosch

Bosch FAP-440 Manuel utilisateur

Bosch

Bosch D-tect 120 Professional Manuel utilisateur

Bosch

Bosch ISC-BPR2-W12 Manuel utilisateur

Bosch

Bosch DS1103i Manuel utilisateur

Bosch

Bosch RADION PIR C Manuel utilisateur

Bosch

Bosch ISC-SM-90 Manuel utilisateur

Bosch

Bosch PAVIRO Series Manuel utilisateur

Bosch

Bosch DS940 Manuel utilisateur

Bosch

Bosch Multi-Detector DMD4 Instructions de montage

Manuels Capteur de sécurité populaires d'autres marques

THORLABS

THORLABS PDA10JT Manuel utilisateur

Waeco

Waeco UV-DETECT Manuel utilisateur

Intermatic

Intermatic IOS-DSIMF Manuel utilisateur

urmet domus

urmet domus 1083 Manuel utilisateur

Siemens

Siemens AZL66 Series Manuel utilisateur

BTI

BTI Profiline Multi Finder Manuel utilisateur

Challenger

Challenger SL01 Manuel utilisateur

DMP Electronics

DMP Electronics 1122INT Manuel utilisateur

Rielta

Rielta Ladoga MK-RK Manuel utilisateur

Mirion Technologies

Mirion Technologies ACCURAD PRD Manuel utilisateur

DBI SALA

DBI SALA EZ Stop Manuel de l'opérateur

Lamptime

Lamptime ST05C Manuel utilisateur

Ubiquiti

Ubiquiti MFI-MSC Manuel utilisateur

Subsite

Subsite 910R Instructions d'installation

Satel

Satel OPAL Pro Manuel utilisateur

Aleph

Aleph XC-1XTEU Manuel utilisateur

Pima

Pima LARIS QUAD Manuel utilisateur

Solinst

Solinst 301 Manuel utilisateur