Barazza 1FICN9E Manuel utilisateur

Instruction manual

INSTALLATION

fig. 3

BUILT-IN OVEN 90x60

• The oven can be installed under a hob or in a column.

• The dimensions of the housing for the oven are given in figure 3.

• Make sure that surrounding materials are heat-resistant.

• Align the oven centrally inside the cabinet then fix it with screws.

• All measurements are in mm.

INSTALLATION

BUILT-IN OVEN 90x48

• The oven can be installed under a hob or in a column.

• The dimensions of the housing for the oven are given in figure 3.

• Make sure that surrounding materials are heat-resistant.

• Align the oven centrally inside the cabinet then fix it with screws.

• All measurements are in mm.

fig. 3

INSTALLATION

INSTALLATION WARNINGS

Built-in under worktop Make sure that the cabinet in the rear/bottom

areas has proper opening, of approx 90mm, to let

the oven work properly once fully built-in installed.

Column installation Make sure that cabinet in the rear/bottom areas

has proper opening, of approx 90mm and 50mm at

the top areas, to let the oven work properly once

fully built-in installed.

• The dimensions and materials of the cabin or cabinet in which the built-in

oven will be installed must be correct and must be resistant to temperature

increases.

• Please install as shown in figure 3.

• The movable walls in which the oven is installed must be heat resistant.

• Wall panels must be 100°C resistant.

• Plastic panels or adhesives that are not resistant to this heat can deform and

sustain damage.

• The instructions for cooking ranges and ovens shall state the appliance must

not be installed behind a decorative door in order to avoid overheating.

• For safety reasons it is necessary to avoid direct contact with the electrical

parts of the oven.

• The insulation and protection parts must be installed such as to prevent them

from being removed from any instrument.

• The oven must be installed as shown in figure 3 in order to provide a more

effective air flow.

• It is advisable to leave a space of at least 90 mm on the back for the kitchen

unit in which the oven is installed.

• The rear part of the cabin in the kitchen unit must be removed to provide

better airflow.

• The rear surface of oven, shall be placed against wall.

• It is not recommended to install the device near refrigerators or freezers,

otherwise their performance may be affected by radiated heat.

• For stationary appliances permanently connected to the fixed wiring,

compliance with this requirement is considered to be met if the instruction

concerning disconnection incorporated in the fixed wiring is in accordance with

AS/NZS 3000.This requirement is valid only for Australia and New Zealand.

INSTALLATION

Dear Customer,

We thank you and congratulate you on your choice to purchase one of our

products.We are confident that this new appliance, built with quality materials, will

fully satisfy your requirements.

Use of this new equipment is easy, however we invite you to read this manual

carefully before installing and using the appliance.

The manual provides correct information on installation, use and maintenance as

well as providing useful advice.

GENERAL WARNINGS

Please read this instruction manual before installing and using the equipment.The

manual must be kept together with the appliance for any future consultation. If the

appliance should be sold or transferred to another person, ensure that the manual

accompanies it, so that the new user will be informed of the operation and of the

relevant warnings.

The product label, with the serial number, is glued to the front of the oven.

The manufacturer declines all responsibility in the event of damage to property

or to persons resulting from improper installation or from improper, incorrect or

unreasonable use of the appliance.

THE MANUFACTURER

All operations relating to installation, adjustment and adaptation to

the type of gas available must be carried out by qualified personnel

according to the regulations in force.

The specific instructions are described in the part of the manual

reserved for the installer.

Declaration of Conformity:

we declare that our products comply with the European directives,

orders and regulations as well as with the requirements indicated in

the reference standards.

WARNINGS

1.1 Premise

This user manual is an integral part of

the appliance and must be kept intact

and within reach of the user throughout

the life of the appliance.

In case of lost the instruction manual,

it is available in electronic format

upon request electronically to the

manufacturer.

Before using the appliance read this user

manual carefully.

1.2 Product label

The identification plate shows the

technical data, the serial number and the

marking.

The identification plate must never be

removed.

1.3 Responsibility of the

manufacturer

The manufacturer declines all

responsibility for damage to persons and

property caused by:

• Use of the appliance other than that

intended.

• Failure to comply with the

instruction in the user manual.

• Tampering with even a single part of

the appliance.

• The use of non-original spare parts.

1.4 Precautions

• WARNING: Ensure that the

appliance is switched off before

replacing the lamp to avoid the

possibility of electric shock.

• Do not lean or sit on the open door.

• Check that objects are not trapped

in the doors.

1.5 Appliance purpose

• This appliance is intended for the

cooking of food in a domestic

environment.Any other use is

improper.

• This appliance can be used by

children aged from 8 years and

above and persons with reduced

physical, sensory or mental

capabilities or lack of experience

and knowledge if they have been

given supervision or instruction

concerning use of the appliance in a

safe way and understand the hazards

involved .

• The appliance is not designed

to work with external timers or

remote control systems.

• Racks and trayshave to be inserted

into the side guides until they come

to a complete stop.The mechanical

safety locks that prevent the rack

from being taken out accidentally

must face downwards and towards

the back of the oven.

WARNINGS

1.6 Damage to persons

• WARNING:This appliance and its

accessible parts become very hot

during use.

• Do not touch the heating elements

during use.

• Keep children under 8 years of

age away if they are not being

continuously supervised.

• Children shall not play with the

appliance.

• During use, do not place metal

objects such as knives, forks, spoons

and lids on the appliances.

• Switch off the appliance after use.

• Never try to extinguish a flame/fire

with water: switch off the appliance

and smother the flame with a lid or

a fireproof blanket.

• Cleaning and user maintenance

shall not be made by children

without supervision.

• Have the installation and servicing

• performed by qualified personnel in

compliance with the regulations in

force.

• Do not modify the appliance.

• Do not insert sharp metallic objects

(cutlery or utensils) into the slots.

• Never attempt to repair the

appliance yourself or without the

intervention of a qualified technician.

1.7 Damage to the appliance

• Do not use harsh abrasive cleaners

or sharp metal scrapers to clean the

oven door glass, since they scratch

the surface, which may result in

shattering of the glass.

• Use wooden or plastic utensils if

necessary.

• Do not sit on the appliance.

• Do not use steam jets to clean the

appliance.

• Do not obstruct the openings,

ventilation and heat dissipation slots.

• Do not leave the appliance

unattended during cooking that can

release fats and oils.

• Do not leave objects on the cooking

surfaces.

• If the door glass breaks, turn off the

oven to avoid electric shock .

• Never use the appliance to heat the

room.

• If the power supply cable is

damaged, contact the technical

assistance service immediately,

which will replace the cable.

WARNINGS

To dispose of the appliance

Cut the power supply cable and remove the cable together with the plug.

Electrical voltage

Danger of electrocution

• Turn off the power supply from the electrical system.

• Disconnect the power supply cable from the electrical system.

• Take the appliance to the appropriate waste collection centres for electrical and

electronic waste, or return the appliance to the retailer at the time of purchase

of equivalent equipment, on a like-for-like exchange.

• It should be noted that non-polluting and recyclable materials are used for

packaging of the appliance.

• Give the packaging materials to the appropriate recycling centres.

Plastic packaging

Danger of suffocation

• Do not leave the packaging or parts of it unattended.

• Do not allow children to play with the plastic packaging bags.

This appliance must be disposed of separately from other waste

(directives 2002/95/EC, 2002/96/EC, 2003/108/EC). This appliance does

not contain substances in quantities such as to be considered hazardous

to health and to the environment, in accordance with the current

European directives.

1.8 Disposal

CONTENTS

1.WARNINGS

1.1 Premise

1.2 Product Label

1.3 Manufacturer liability

1.4 Precautions

1.5 Appliance purpose

1.6 Damage to person

1.7 Damage to the appliance

1.8 Disposal

2. INSTALLATION

2.1 Electrical connection

2.2 General information

2.3 Fixed connection

2.4 Connection with plug and socket

2.5 For the installer

2.6 Oven Installation

3. DESCRIPTION

3.1 Oven description

3.2 Accessories

3.3 Using the accessories

3.4 First use

3.5 Energeticefciency

3.6 Cooling fan

4.TIMER DESCRIPTION

5. 6 FUNCTION DESCRIPTION

6. 8 FUNCTION DESCRIPTION

7. 9 FUNCTION DESCRIPTION

8. 11 FUNCTION DESCRIPTION

9. CLEANING AND MAINTENANCE

9.1 Warnings

9.2 Removing the oven door

9.3 Internal glass cleaning

9.4 Third glass cleaning

10. DIRECTIVE 2012/19/UE (RAEE)

INSTALLATION

2.1 Electrical connection

Danger of electrocution

Electrical voltage

Have the electrical connection carried

out by qualified technical personnel.

The earth connection is obligatory

according to the methods foreseen by

the safety regulations of the electrical

system.

Turn off the general power supply.

2.2 General information

Check that the characteristics of the

electrical network are suitable for the

data shown on the plate.

The identification plate, with technical

data, serial number and marking is visibly

positioned on the appliance.

The plate must never be removed.

The appliance works with

Use a three-pole cable (3x1.5mm2 cable,

referring to the internal conductor

section).

Provide for the earth connection with a

cable longer than the others by at least

20mm.

2.3 Fixed connection

If a stationary appliance is not fitted

with a supply cord and a plug, a mean

for disconnection from the supply mains

having a contact separation in all poles

that provide full disconnection under

overvoltage category III conditions must

be incorporate in the fixed wiring in

accordance with the wiring rules of the

country where the appliance is installed.

For Australia and New Zealand this

mean of disconnection shall be in

accordance with AS/NZS 3000.

The interruption device must be located

in an easily accessible position and near

the appliance.

2.4 Connection with plug

and socket

Check that the plug and socket are of

the same type.

Avoid using reductions, adapters or

shunts as they could cause heating or

burning.

2.5 For the installer

The plug must remain accessible after

installation. Do not bend or trap the

connection cable to the mains.

The appliance must be installed

according to the installation diagrams.

If the appliance does not function

properly after having carried out all the

checks, refer to the Authorised

Assistance Centre in your area.

When the appliance is correctly

installed, please instruct the user on the

correct method of operation.

Table des matières

Langues :

Autres manuels Barazza Four

Barazza

Barazza CITY STEEL 1FCYP9 Manuel utilisateur

Barazza

Barazza 1FVCFY Manuel utilisateur

Barazza

Barazza FIBFT Series Mode d’emploi

Barazza

Barazza CITY STEEL 1FCYP9 Manuel utilisateur

Barazza

Barazza 1FOAM 00 Series Manuel utilisateur

Barazza

Barazza 1FUAM 00 Series Manuel utilisateur

Barazza

Barazza 1FSLMP Series Mode d’emploi

Barazza

Barazza 1FVAP IO Series Manuel utilisateur

Barazza

Barazza 1FLBMP9 Mode d’emploi

Barazza

Barazza 1CG9 Mode d’emploi

Barazza

Barazza Velvet FIVLT Series Mode d’emploi

Barazza

Barazza CITY STEEL 1FCYP9 Manuel utilisateur

Barazza

Barazza 1FPA60 Mode d’emploi

Barazza

Barazza Velvet FIVLT Series Mode d’emploi

Barazza

Barazza Velvet FIVLT Series Mode d’emploi

Barazza

Barazza 1MCFY Manuel utilisateur

Barazza

Barazza 1FOFM7X-00 series Mode d’emploi

Barazza

Barazza 1FEVP ENO Series Manuel utilisateur

Barazza

Barazza Velvet FIVLT Series Mode d’emploi

Barazza

Barazza FEEL 1FFYPPI Manuel utilisateur

Barazza

Barazza CITY 1FCYP I0 Series Manuel utilisateur

Barazza

Barazza FIVLT Series Mode d’emploi

Barazza

Barazza 1FOFMPX-00 series Mode d’emploi

Barazza

Barazza 1FEVGVC Manuel utilisateur

Manuels Four populaires d'autres marques

Bosch

Bosch HVA531NS0 Manuel utilisateur

Electrolux

Electrolux EOF6P46X Manuel utilisateur

NEFF

NEFF B44S32 5GB Series Manuel utilisateur

Combi

Combi BLODGETT BC142GDS Manuel utilisateur

AEG

AEG COMPETENCE 311704300 Manuel utilisateur

Falcon

Falcon DOMINATOR PLUS G3106 Series Guide de l'utilisateur

Rational

Rational SCC WE 61G Manuel utilisateur

Smeg

Smeg DOSPA38X Manuel d'installation et d'exploitation

Electrolux

Electrolux air-o-convect 20 GN 2/1 Manuel utilisateur

Miele

Miele HR 1954-2 Manuel utilisateur

KHIND

KHIND OT50 Manuel utilisateur

Henny Penny

Henny Penny Smoker Box Manuel utilisateur

Lang

Lang ECOD-AP Manuel utilisateur

AEG

AEG BEK455310M Manuel utilisateur

Frigidaire

Frigidaire FNGE90JGR Manuel utilisateur

Hotpoint

Hotpoint FE9 S831 JSH IX Manuel utilisateur

GE Advantium SCB2000 Manuel utilisateur

AEG

AEG DE401301DM Manuel utilisateur