AWS SR-1KG Manuel utilisateur

American Weigh Scales

SR-1KG (1kg x 0.001g)

SR-5 (5kg x 0.005g)

SR-20 (20kg x 0.01kg)

User Manual

SR-Series

SR-Series Manual

Thank you for purchasing the American Weigh

SR-Series digital hanging scale. Please read all operating

instructions carefully before use. Scales are precision

measuring devices and should always be handled with

proper care. To ensure years of reliable service, keep these

simple tips in mind:

• Do not exceed the scale’s maximum capacity.

Overloading your scale can permanently damage it!

• Avoid exposure to extreme heat or cold. Scales

perform best at normal room temperature. If

temperatures have changed dramatically, calibration

and adjustment may be necessary.

• Allow your scale to warm up for 30-60 seconds before

performing calibration and adjustment (if available).

• Store your scale in a clean, dry location. Dust, dirt,

and moisture can accumulate on the weighing

sensors and electronics causing inaccuracy or

malfunction.

• Avoid using your scale in close proximity to strong

radio wave emitting devices such as computers, cash

registers, and cordless phones.

• Gently apply all items to be weighed. Do not shock

load items onto the weighing hook.

• Avoid dropping your scale. The warranty does not

cover damage due to rough treatment or overload.

• Checkthebatteriesrstifyouarehavinganytrouble

with your scale. This simple step can remedy most

scale issues.

• Do not disassemble your scale. This product contains

no user serviceable parts.

I. Part List

1. Scale

2. Weighing Tray

3. AAA Batteries (x2)

II. Key Description

III. Battery Installation

1. Beforeusingthescaleforthersttime,check

the battery compartment and remove any plastic

insulation strips or packaging that may be in place to

prevent battery drainage during shipping/storage.

2. If you are replacing the batteries, make sure the

positive and negative contacts are properly aligned.

ON/OFF

TARE Key

Auto-O

Select

HOLD

SR-Series Manual

IV. Operation

1. Press the key.

2. Wait for the scale to stabilize ( will be displayed in

the bottom left corner of the LCD). Place the item to

be weighed on the weighing hook.

3. When the weight is stable, the red light will turn on,

and HOLD will be displayed below the weight. (SR-5

and SR-20 only)

4. Remove the object(s) from the hook and tap the

key to re-zero the scale.

5. To turn the scale off, press and hold the key.

V. Auto-Off Selection

To conserve battery power, this scale is set to turn off

automatically after 60 seconds of inactivity.

1. To disable the auto-off feature, open the battery

compartment and locate the Auto-Off Select switch.

(see Section II)

2. Move the switch to the UP position to disable the

Auto-Off feature.

3. Move the switch to the DOWN position to enable the

Auto-Off feature.

VI. Changing the Unit of Measure

This scale can read in KG or LB (G/OZ for SR-1). To change

the weighing mode, follow these instructions:

1. Press and hold until the scale displays the current

weighing unit, then release.

2. Now tap the key to toggle between the available

weighing units.

3. After a couple of seconds of no activity the scale will

enter normal weighing mode with the selected unit.

• SR-1KG Units: g (gram) oz (ounce)

• SR-5, SR-20 Units: lb (pound) kg (kilogram)

VII. Using the Tare Feature

You can use this scale’s tare feature to subtract the weight

of an empty container or vessel for net weight determination.

NOTE: The weight of the container will subtract from the

available capacity.

1. Turn on the scale as described in Section IV.

2. Attach your tare item / empty container using

the hook and wait for it to stabilize (HOLD will be

displayed).

3. Tap the button. “0.0” will be displayed.

4. You can now add items to the container to obtain

just the weight of the contents.

5. When the container is removed the weight will be

held on the display. Press again to zero the scale.

VIII. Calibration

Calibration and adjustment are performed at the factory.

However, the weighing range can shift slightly during

shipping. Also, due to changes in local acceleration of gravity

around the world, adjustment is recommended when moving

the scale from one location to another. To check calibration:

1. Place the required calibration weight on the scale

and note the displayed value.

2. If the displayed value is not within acceptable

tolerance (see chart on next page), adjustment is

required.

SR-Series Manual

Model Acceptable

Tolerance (±)

Calibration

Weight

Recommended

Accuracy Class

SR-1KG 2g 1kg OIML M1

SR-5 0.015kg 5kg OIML M1

SR-20 0.03kg 10kg OIML M1

IX. Adjustment

1. Press the key to turn the scale on.

2. Once the LCD shows “8888” tap the key several

times quickly until the inner code displays.

3. Press again.Thedisplaywillash“CAL”followed

by the required calibration weight (see chart).

4. Add the required weight. The display will show pass

and return to normal weighing mode.

5. Remove the weight and press and hold the key to

turn the scale off. Calibration is complete!

X. Troubleshooting

• Problem: Scale will not turn on

• Solution: Check the batteries

• Problem: Display will not stabilize

• Solution: Make sure the weight is stable on the

hook and not shaking or swinging

• Problem: Displayed weight is inaccurate

• Solution: Perform a calibration adjustment

XI. Error Codes

1. OUTZ - Zero setting has shifted. Perform calibration

adjustment. If the problem persists, the load cell may

be permanently damaged due to overloading.

2. EEEEE - Maximum capacity exceeded. Remove the

extra weight to avoid damaging the load cell.

3. LLLLL - Load cell has been overloaded.

4. UNST - The scale is unstable. Use the scale in a

more stable position

XII. Specications

SR-1KG

Max. Capacity 1000g / 35.30oz

Readability 1g / 0.05oz

Min. Capacity 3g / 0.10oz

Power 2 x AAA Alkaline Batteries

Dimensions 4.0 x 2.3 x 0.7

Hook Dimensions Gap: 0.5in / Throat: 0.5in

Warranty 10 Year Limited Warranty

SR-5 SR-20

Max. Capacity 5kg / 11lb 20kg / 44lb

Readability 0.005kg / 0.01lb 0.01kg / 0.02lb

Min. Capacity 0.015kg / 0.03lb 0.03kg / 0.06lb

Power 2 x AAA Alkaline Batteries

Dimensions 4.0 x 2.3 x 0.7

Hook Dimensions Gap: 0.5in / Throat: 0.5in

Warranty 10 Year Limited Warranty

Ce manuel convient aux modèles suivants

Table des matières

Manuels Échelle populaires d'autres marques

Gima

Gima Glass Body Fat Analyzer Manuel de la liste des pièces

Seca

Seca 374 Manuel utilisateur

TEC

TEC TEC SL59 SERIES Manuel utilisateur

Axis

Axis B/E Series Manuel utilisateur

Alecto

Alecto ACW-40 Manuel utilisateur

Rice Lake

Rice Lake MSI-4260 IS Manuel utilisateur

IKA

IKA RCT basic safety control Manuel utilisateur

ADE

ADE M20011 Manuel utilisateur

Duronic

Duronic KS3000 Manuel utilisateur

Digi

Digi SM-720 Manuel utilisateur

Cardinal

Cardinal CS Series Manuel utilisateur

Korona

Korona Kastella Manuel utilisateur

A&D

A&D FC-50Ki Manuel utilisateur

BDA

BDA CAMARGUE Manuel utilisateur

Tanita

Tanita HD-357 Manuel utilisateur

Leifheit

Leifheit 03173 Manuel utilisateur

Lumme

Lumme LU-1340 Manuel utilisateur

Fidelity Electronics

Fidelity Electronics G2e Manuel utilisateur