AWS CP3 Series Manuel utilisateur
American Weigh Scales, Inc.
CP3-100 (100x0.01g)
CP3-650 (65 0x0.1g) User Manual
CP3-Series
Digital Pocket Scale
M
T
Zero
g
g
ZERO
PCS
UNITS
ON
OFF
T A R E
LIGHT
CP3-Series Manual
Thank you for purchasing the American Weigh CP3-
Series digital pocket scale. Please read all operating
instructions carefully before use. Scales are precision
instruments and should always be handled with proper
care. To ensure years of reliable service, keep these
simple tips in mind:
• Do not exceed the scales maximum capacity.
Overloading your scale can permanently damage it!
• Avoid exposure to extreme heat or cold. Scales
perform best at normal room temperature. If
temperatures have changed dramatically, recalibration
may be necessary.
• Allow your scale to warm up for 30-60 seconds
before performing calibration (if available).
• Store your scale in a clean, dry location. Dust, dirt,
and moisture can accumulate on the weighing sensors
and electronics causing innacuracy or malfunction.
• Avoid using your scale in close proximity to strong
radio wave emitting devices such as computers, cash
registers, and cordless phones.
• Always weigh on a at and level surface, free from
vibrations and drafts. The corner of a room is usually
the most stable.
• Gently apply all items to be weighed. Do not drop
items onto the weighing platform.
• Avoid dropping your scale. The warranty does not
cover damage due to rough treatment or overload.
I. OPERATION
Place Scale on a horizontal at surface.
1. Press [
ON/OFF
] key.
2. Wait until "0.0” or "0.00" is displayed.
3. Place the object(s) on the weighing platform.
4. By pressing the [
UNITS
] key, you can switch
between weighing units.
5. By pressing the [
LIGHT
] key, you can switch the
back-light on or off.
6. The removable lid can also be used as a weighing
tray.
II. TARE WEIGHING
1. Turn on scale as described above.
2. Place a tray or container on the scale platform.
3. Press [ TARE
] and wait until "0.0" or "0.00" is
displayed.
4. You can now add items to the container or tray to
obtain just the weight of the contents.
III. PARTS COUNTING
All object must be of equal weight for counting to work.
1. Turn on scale as described above.
2. Place a sample quantity (25, 50, 75, or 100pcs) of
the material you want to count on the platform
3. Press and hold the [ PCS
] key for 2 seconds until a
number is displayed (ie. 100pcs).
4. Press [
UNITS
] to change the sample quantity to
match the number you have on the platform.
5. Press the [ PCS
] key again to conrm the number.
6. You may now remove the sample quantity and add
any amount of the material to the platform, and the
display will show a count.
7. You can switch between weighing and counting
mode by pressing [ PCS
] or [ UNITS
] respectively.
IV. CALIBRATION
Calibration is NOT required before rst use. Only
calibrate if scale is not weighing properly.
**The CP3-650 calibrates with a 500g weight (not
included). The CP3-100 calibrates with a 100g weight
(not included)**
1. Turn the scale ON.
2. Hold the [ UNITS
] key for a few seconds. The
display will show "CAL".
3. Press the key again. "CAL" will ash, followed by
the required calibration weight (ie. 500g).
3. Place the calibration weight onto the platform.
4. The display will show "PASS" then return to normal
weighing mode. Calibration is complete!
V. TROUBLESHOOTING
[Display] Elimination of errors
-----------------------------------------------
[OUT2] Recalibrate the scale (Section IV).
[EEEE] You are overloading the scale. Remove the
excessive load immediately!
[un2T] Use the scale in a more stable position
Model CP3-650 CP3-100
Capacity 650.0g
22.92oz
20.89ozt
417.95dwt
100.00g
3.527oz
500ct
1543.2gn
Resolution 0.1g
0.01oz
0.01ozt
0.1dwt
0.01g
0.001oz
0.05ct
0.1gn
Weighing Units g, oz, ozt, dwt g, oz, ct, gn
Calibration Weight (not Included) 500g 100g
Platform Dimensions (inches) 2.0 x 2.7 “ Stainless Steel
Scale Dimensions (inches) 4.5 x 2.4 x 0.5”
Power 2 x CR2032 Batteries (included)
Warranty 10 Year Warranty
Specications
Ce manuel convient aux modèles suivants
2
Table des matières
Autres manuels AWS Échelle
AWS
AWS MERCURY PRO MPR-180 Manuel utilisateur
AWS
AWS LB-1000 Manuel utilisateur
AWS
AWS ME-5KG Manuel utilisateur
AWS
AWS CHROME-1KG Manuel utilisateur
AWS
AWS BS-100 Manuel utilisateur
AWS
AWS AMW-DISC-55 Manuel utilisateur
AWS
AWS AMW-Card120 Manuel utilisateur
AWS
AWS Gemini-20 Manuel utilisateur
AWS
AWS CP2-100 Manuel utilisateur
AWS
AWS AMW-500i Manuel utilisateur
AWS
AWS CQ-350 Manuel utilisateur
AWS
AWS MB-100 Manuel utilisateur
AWS
AWS V2-600 Manuel utilisateur
AWS
AWS H-110 Manuel utilisateur
AWS
AWS BT2 series Manuel utilisateur
AWS
AWS CP5-100 Manuel utilisateur
AWS
AWS CP5-100 Manuel utilisateur
AWS
AWS HX-502 Manuel utilisateur
AWS
AWS H-11 Manuel utilisateur
AWS
AWS GeminiPRO Manuel utilisateur
