Analog Devices EZ-KIT Lite ADSP-BF537 Manuel utilisateur
a
ADSP-BF537 EZ-KIT Lite®
Evaluation System Manual
Revision 2.5, July 2012
Part Number
82-000865-01
Analog Devices, Inc.
One Technology Way
Norwood, Mass. 02062-9106
Copyright Information
© 2012 Analog Devices, Inc., ALL RIGHTS RESERVED. This docu-
ment may not be reproduced in any form without prior, express written
consent from Analog Devices, Inc.
Printed in the USA.
Disclaimer
Analog Devices, Inc. reserves the right to change this product without
prior notice. Information furnished by Analog Devices is believed to be
accurate and reliable. However, no responsibility is assumed by Analog
Devices for its use; nor for any infringement of patents or other rights of
third parties which may result from its use. No license is granted by impli-
cation or otherwise under the patent rights of Analog Devices, Inc.
Trademark and Service Mark Notice
The Analog Devices logo, Blackfin, CrossCore, EngineerZone,
EZ-Extender, EZ-KIT Lite, and VisualDSP++ are registered trademarks of
Analog Devices, Inc.
All other brand and product names are trademarks or service marks of
their respective owners.
Regulatory Compliance
The ADSP-BF537 EZ-KIT Lite is designed to be used solely in a labora-
tory environment. The board is not intended for use as a consumer end
product or as a portion of a consumer end product. The board is an open
system design which does not include a shielded enclosure and therefore
may cause interference to other electrical devices in close proximity. This
board should not be used in or near any medical equipment or RF devices.
The ADSP-BF537 EZ-KIT Lite has been certified to comply with the
essential requirements of the European EMC directive 89/336/EEC
amended by 93/68/EEC and therefore carries the “CE” mark.
The ADSP-BF537 EZ-KIT Lite has been appended to Analog Devices,
Inc. Technical Construction File (TCF) referenced ‘DSPTOOLS1’ dated
December 21, 1997 and was awarded CE Certification by an appointed
European Competent Body as listed below.
Technical Certificate No: Z600ANA1.021
Issued by: Technology International (Europe) Limited
60 Shrivenham Hundred Business Park
Shrivenham, Swindon, SN6 8TY, UK
The EZ-KIT Lite evaluation system contains ESD (electrostatic discharge)
sensitive devices. Electrostatic charges readily accumulate on the human
body and equipment and can discharge without detection. Permanent
damage may occur on devices subjected to high-energy discharges. Proper
ESD precautions are recommended to avoid performance degradation or
loss of functionality. Store unused EZ-KIT Lite boards in the protective
shipping package.
ADSP-BF537 EZ-KIT Lite Evaluation System Manual v
CONTENTS
PREFACE
Product Overview ......................................................................... xi
Purpose of This Manual .............................................................. xiii
Intended Audience ....................................................................... xiv
Manual Contents ......................................................................... xiv
What’s New in This Manual .......................................................... xv
Technical Support ......................................................................... xv
Supported Processors .................................................................... xvi
Product Information .................................................................... xvi
Analog Devices Web Site ........................................................ xvi
EngineerZone ........................................................................ xvii
Related Documents .................................................................... xviii
Notation Conventions ................................................................ xviii
USING THE ADSP-BF537 EZ-KIT LITE
Package Contents .......................................................................... 1-3
Default Configuration ................................................................... 1-3
CCES Install and Session Startup .................................................. 1-4
Session Startup ........................................................................ 1-6
Contents
vi ADSP-BF537 EZ-KIT Lite Evaluation System Manual
VisualDSP++ Install and Session Startup ....................................... 1-8
CCES Evaluation License ........................................................... 1-10
VisualDSP++ Evaluation License ................................................. 1-11
Memory Map ............................................................................. 1-11
SDRAM Interface ....................................................................... 1-13
Flash Memory ............................................................................ 1-15
CAN Interface ............................................................................ 1-15
Ethernet Interface ....................................................................... 1-16
ELVIS Interface .......................................................................... 1-17
Audio Interface ........................................................................... 1-17
LEDs and Push Buttons .............................................................. 1-18
Board Design Database ............................................................... 1-19
Example Programs ...................................................................... 1-19
ADSP-BF537 EZ-KIT LITE HARDWARE REFERENCE
System Architecture ...................................................................... 2-2
External Bus Interface Unit ..................................................... 2-3
SPORT0 Audio Interface ........................................................ 2-4
SPI Interface ........................................................................... 2-4
Programmable Flags (PFs) ....................................................... 2-4
UART Port ............................................................................. 2-7
Expansion Interface ................................................................. 2-7
JTAG Emulation Port ............................................................. 2-8
ADSP-BF537 EZ-KIT Lite Evaluation System Manual vii
Contents
Jumper and Switch Settings ........................................................... 2-9
CAN Enable Switch (SW2) ...................................................... 2-9
Ethernet Mode Select Switch (SW3) ...................................... 2-10
UART Enable Switch (SW4) .................................................. 2-11
Push Button Enable Switch (SW5) ......................................... 2-11
Flash Enable Switch (SW6) .................................................... 2-12
Audio Enable Switch (SW7) .................................................. 2-12
Boot Mode Select Switch (SW16) .......................................... 2-13
3V Power Selection Jumper (JP3) ........................................... 2-13
Expansion Interface Voltage Selection Jumper (JP5) ............... 2-14
UART Loop Jumper (JP9) ..................................................... 2-15
ELVIS Oscilloscope Configuration Switch (SW1) ................... 2-15
ELVIS Function Generator Configuration Switch (SW8) ........ 2-16
ELVIS Voltage Selection Jumper (JP6) ................................... 2-16
ELVIS Select Jumper (JP8) .................................................... 2-17
LEDs and Push Buttons .............................................................. 2-18
Reset Push Button (SW9) ...................................................... 2-18
Programmable Flag Push Buttons (SW10–13) ........................ 2-19
Power LED (LED7) ............................................................... 2-19
Reset LED (LED8) ................................................................ 2-19
User LEDs (LED1–6) ............................................................ 2-20
USB Monitor LED (ZLED3) ................................................. 2-20
Contents
viii ADSP-BF537 EZ-KIT Lite Evaluation System Manual
Connectors ................................................................................. 2-21
Audio Connectors (J9 and J10) ............................................. 2-22
CAN Connectors (J5 and J11) .............................................. 2-22
Ethernet Connector (J4) ....................................................... 2-22
RS-232 Connector (J6) ......................................................... 2-23
Power Connector (J7) ........................................................... 2-23
Expansion Interface Connectors (J1–3) .................................. 2-24
JTAG Connector (ZP4) ......................................................... 2-24
SPORT0 Connector (P6) ...................................................... 2-25
SPORT1 Connector (P7) ...................................................... 2-25
PPI Connector (P8) .............................................................. 2-25
SPI Connector (P9) ............................................................... 2-26
2-Wire Interface Connector (P10) ......................................... 2-26
TIMERS Connector (P11) .................................................... 2-26
UART1 Connector (P12) ...................................................... 2-27
ADSP-BF537 EZ-KIT LITE BILL OF MATERIALS
ADSP-BF537 EZ-KIT LITE SCHEMATIC
INDEX
ADSP-BF537 EZ-KIT Lite Evaluation System Manual ix
PREFACE
Thank you for purchasing the ADSP-BF537 EZ-KIT Lite®, Analog
Devices, Inc. evaluation system for Blackfin®processors.
Blackfin processors embody a type of embedded processor designed specif-
ically to meet the computational demands and power constraints of
today’s embedded audio, video, and communications applications. They
deliver breakthrough signal-processing performance and power efficiency
within a reduced instruction set computing (RISC) programming model.
Blackfin processors support a media instruction set computing (MISC)
architecture. This architecture is the natural merging of RISC, media
functions, and digital signal processing (DSP) characteristics. Blackfin
processors deliver signal-processing performance in a microprocessor-like
environment.
Based on the Micro Signal Architecture (MSA), Blackfin processors com-
bine a 32-bit RISC instruction set, dual 16-bit multiply accumulate
(MAC) DSP functionality, and 8-bit video processing performance that
had previously been the exclusive domain of very-long instruction word
(VLIW) media processors.
x ADSP-BF537 EZ-KIT Lite Evaluation System Manual
The evaluation board is designed to be used in conjunction with the
CrossCore®Embedded Studio (CCES) and VisualDSP++®development
environments to test the capabilities of the ADSP-BF537 Blackfin proces-
sors. The development environment gives you the ability to perform
advanced application code development and debug, such as:
• Create, compile, assemble, and link application programs written
in C++, C, and ADSP-BF537 assembly
• Load, run, step, halt, and set breakpoints in application programs
• Read and write data and program memory
• Read and write core and peripheral registers
• Plot memory
Access to the ADSP-BF537 processor from a personal computer (PC) is
achieved through a USB port or an optional JTAG emulator. The USB
interface gives unrestricted access to the ADSP-BF537 processor and the
evaluation board peripherals. Analog Devices JTAG emulators offer faster
communication between the host PC and target hardware. Analog Devices
carries a wide range of in-circuit emulation products. To learn more about
Analog Devices emulators and processor development tools, go to
http://www.analog.com/dsp/tools.
The ADSP-BF537 EZ-KIT Lite provides example programs to demon-
strate the capabilities of the evaluation board.
Autres manuels pour EZ-KIT Lite ADSP-BF537
2
Table des matières
Autres manuels Analog Devices Matériel informatique
Analog Devices
Analog Devices AD73360L Manuel utilisateur
Analog Devices
Analog Devices EVAL-ADAU1772Z Manuel utilisateur
Analog Devices
Analog Devices LTC3728EG Manuel utilisateur
Analog Devices
Analog Devices LINEAR DC2672A-A Guide de configuration rapide
Analog Devices
Analog Devices SHARC Series Manuel utilisateur
Analog Devices
Analog Devices Linear ADI Power LT1964 Guide de configuration rapide
Analog Devices
Analog Devices ADSP-BF609 EZ-KIT Lite Manuel utilisateur
Analog Devices
Analog Devices HPUSB Manuel utilisateur
Analog Devices
Analog Devices CN-0506 Manuel utilisateur
Analog Devices
Analog Devices Linear LT3383 Guide de configuration rapide
Analog Devices
Analog Devices EVAL-ADAU1860 Manuel utilisateur
Analog Devices
Analog Devices ADRV902 Series Manuel utilisateur
Analog Devices
Analog Devices DC2745A Guide de configuration rapide
Analog Devices
Analog Devices EZ-Extender PWM 180-Pin Manuel utilisateur
Analog Devices
Analog Devices EVAL-ADA4351-2 Manuel utilisateur
Analog Devices
Analog Devices MAX77831 Manuel utilisateur
Analog Devices
Analog Devices ADSP-TS101 TigerSHARC Guide d'application
Analog Devices
Analog Devices ADDS-218X-ICE-2.5V Manuel utilisateur
Analog Devices
Analog Devices ADuCM322 Manuel utilisateur
Analog Devices
Analog Devices ADF7021-V Manuel utilisateur
Manuels Matériel informatique populaires d'autres marques
EMC2
EMC2 VNX Series Manuel du propriétaire
Panasonic
Panasonic DV0PM20105 Manuel utilisateur
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Manuel utilisateur
Gigabyte
Gigabyte B660M DS3H AX DDR4 Manuel utilisateur
Raidon
Raidon iT2300 Manuel utilisateur
National Instruments
National Instruments PXI-8186 Manuel utilisateur
