Alpha Alpha 240 Boiler Range Manuel d'instructions et de sécurité

Instructions for setting the burner

pressures on the gas valve

Alpha 240, 280 and 500 Boiler Range

1. GENERAL

The maximum and minimum burner pressures are factory set and should not require adjusting. However, if the gas valve

has been replaced, then these burner pressures must be set by adjustment on the gas valve. Refer to the Installation and

Servicing instructions for gaining access to and for replacement of the gas valve.

Note: Ensure that the plastic tube between the gas valve and the room sealed chamber is fitted correctly.

2. SETTHE MAXIMUM BURNER PRESSURE

a. Loosen the burner pressure test point screw on the gas valve

and connect a pressure gauge.

b. Release the modulating coil spring and remove the coil from

the spindle (B).

c. Turn the screw (A) fully in by hand in a clockwise direction.

d. Release the locking nut (C) securing the spindle (B) to the gas

valve.

e. Set the selector switch to (DHW only) and fully open a hot

tap.

f. Rotate the spindle (B) to set the maximum burner pressure, i.e.

clockwise to increase the burner pressure, anti-clockwise to

decrease the burner pressure.

g. When the correct maximum burner pressure is obtained with

the room sealed chamber panel fitted, carefully tighten the

locking screw (C) to secure the spindle (B) - take care not to

allow the spindle to turn.

Note: With the locking nut tightened, check that the maximum

burner pressure is correct.

3. SETTHE MINIMUM BURNER PRESSURE

The maximum burner pressure must be correctly set as described

above before the minimum burner pressure is set.

a. Turn the screw (A) anti-clockwise until the minimum burner

pressure is obtained with the room sealed chamber panel

fitted.

b. Replace the modulating coil and ensure it is secured with the

spring clip. Recheck the maximum burner pressure. Continue

to adjust and check until both the maximum and minimum

burner pressures are as shown in the table below.

c. Set the selector switch to '0' to turn off the boiler. Disconnect

the pressure gauge and tighten the test point screw.

d. Test for gas soundness using a suitable leak detection fluid.

Burner pressure

test point

Room sealed

chamber

pressure tube

Inlet gas

pressure

test point

Modulating

coil spring

clip

Modulating

coil

Locking nut (C)

Spindle (B)

Minimum burner

pressure adjusting

screw (A)

Boiler Maximum Burner Pressure

LPG

240 Range

280 Range

500E

Nat gas LPG

mbar

9.6

11.8

10.8

in wg

3.84

4.70

4.32

mbar

36.6

35.0

in wg

14.6

14.0

mbar

1.1

1.5

1.9

in wg

0.44

0.60

0.76

mbar

6.2

4.0

5.8

in wg

2.84

1.60

2.32

Minimum Burner Pressure

Nat gas

02/04/D163

Compiled and designed by Publications 2000, Tel (01670) 356211

These instructions have been carefully prepared but we reserve the right to

alter the specification at any time in the interest of product improvement.

Alpha Therm Limited.

NepicarHouse,LondonRoad,WrothamHeath,

Sevenoaks, Kent TN15 7RS

Tel: 0870 3001964

email: [email protected]

website: www.alpha-boilers.com

Autres manuels pour Alpha 240 Boiler Range

Ce manuel convient aux modèles suivants

Autres manuels Alpha Chaudière

Alpha

Alpha Alpha CD50 Manuel utilisateur

Alpha

Alpha Alpha InTec 12SNG Guide de l'utilisateur

Alpha

Alpha Evoke 28 Guide de l'utilisateur

Alpha

Alpha Alpha C23 Guide de l'utilisateur

Alpha

Alpha ARES Pro 150 Guide de l'utilisateur

Alpha

Alpha InTec 12S (NG) Guide de l'utilisateur

Alpha

Alpha DS 24 TF Manuel du produit

Alpha

Alpha Alpha CD13R Guide de l'utilisateur

Alpha

Alpha Alpha Plus DH Units Mode d’emploi

Alpha

Alpha Alpha HE CB25 Guide de l'utilisateur

Alpha

Alpha CD90S Guide de l'utilisateur

Alpha

Alpha Alpha CD25X Guide de l'utilisateur

Alpha

Alpha Alpha CB24 Guide de l'utilisateur

Alpha

Alpha Alpha CB24 Manuel utilisateur

Alpha

Alpha Alpha CD50 Guide de l'utilisateur

Alpha

Alpha Alpha C23 Manuel utilisateur

Alpha

Alpha Alpha CD18S Guide de l'utilisateur

Alpha

Alpha Alpha CD24C Guide de l'utilisateur

Alpha

Alpha Alpha CD50 Manuel utilisateur

Alpha

Alpha Alpha C Boiler Manuel utilisateur

Alpha

Alpha Alpha CD35C Manuel utilisateur

Alpha

Alpha 30C Guide de l'utilisateur

Alpha

Alpha 41 532 05 Guide de l'utilisateur

Alpha

Alpha Ocean Style FF Manuel utilisateur

Manuels Chaudière populaires d'autres marques

Vaillant

Vaillant uniSTOR VIH SW GB 500 BES Manuel utilisateur

Radijator

Radijator BIO max 23.1 Manuel utilisateur

Brunner

Brunner BSV 20 Manuel utilisateur

Buderus

Buderus Logamax GB062-24 KDE H V2 Manuel utilisateur

Potterton

Potterton 50e Fiche technique

UTICA BOILERS

UTICA BOILERS TriFire Manuel utilisateur

Joannes

Joannes LADY Series Manuel

ECR International

ECR International UB90-125 Manuel d'instructions

Froling

Froling FHG Turbo 3000 Manuel utilisateur

Froling

Froling P4 Pellet 8 - 105 Manuel utilisateur

U.S. Boiler Company

U.S. Boiler Company K2 Manuel utilisateur

Henrad

Henrad C95 FF Manuel utilisateur

NeOvo

NeOvo EcoNox EF 36 Manuel utilisateur

Potterton

Potterton PROMAX SL 12 Manuel utilisateur

Eco Hometec

Eco Hometec EC 25 COMPACT Manuel utilisateur

Viessmann

Viessmann VITODENS 200 Mode d’emploi

Baxi

Baxi Prime 1.24 Manuel utilisateur

REXNOVA

REXNOVA ISA 20 BITHERMAL Manuel utilisateur