ACME Thunder Manuel utilisateur
CONTENTS
1. Safety Instruction........................................................................................... 2
2. Technical Specifications ................................................................................. 4
3. Installation and Connection........................................................................... 5
4. Control Panel ................................................................................................. 8
5. How To Set The Unit ...................................................................................... 9
5.1 Main Function.......................................................................................... 9
5.2 Home Position Adjustment .................................................................... 15
6. Control By Universal DMX Controller........................................................... 18
6.1 DMX512 Connection.............................................................................. 18
6.2 Address Setting...................................................................................... 19
6.3 DMX512 Configuration .......................................................................... 20
7. Error Information......................................................................................... 24
8. Troubleshooting........................................................................................... 26
9. Fixture Cleaning ........................................................................................... 26
1E
1. Safety Instruction
WARNING
Please keep this User Guide for future consultation. If you sell the unit to another user, be sure
that they also receive this instruction manual.
Important:
Damages caused by the disregard of this user manual are not subject to warranty. The dealer
will not accept liability for any resulting defects or problems.
Unpack and check carefully that there is no transportation damage before using the unit.
This product is suitable for wet locations. Do not immerse in water.
DO install and operate by qualified operator.
DO NOT allow children to operate the fixture.
Use safety chain when fixing the unit. Handle the unit by carrying its base instead of head
only.
The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent
surfaces.
Be sure that no ventilation slots are blocked, otherwise the unit will be overheated.
Before operating, ensure that the voltage and frequency of power supply match the power
requirements of the unit.
It’s important to ground the yellow/green conductor to earth in order to avoid electric shock.
Minimum ambient temperature TA: 0℃. Maximum ambient temperature TA: 40℃.
DO NOT connect the device to any dimmer pack.
Make sure there are no flammable materials close to the unit while operating to avoid fire
hazard.
Examine the power wires carefully; replace them immediately if there is any damage.
Unit’s surface temperature may reach up to 75℃. DO NOT touch the housing bare-handed
during its operation.
Avoid any inflammable liquids, water or metal objects entering the unit. Once it happens, cut
Please read the instruction carefully which includes important information
about the installation, usage and maintenance.
2E
off the mains power immediately.
DO NOT operate in dirty or dusty environment, do clean fixtures regularly.
DO NOT touch any wire during operation as there might be a hazard of electric shock.
Avoid power wires together twist other cables.
The minimum distance between light output and the illuminated surface must be more than
0.5 meters.
In the event of serious operating problem, stop using the unit immediately.
Never turn on and off the unit time after time.
The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly damaged.
DO NOT open the unit as there are no user serviceable parts inside.
Never try to repair the unit by yourself. Repairs carried out by unskilled people can lead to
damage or malfunction. Please contact the nearest authorized technical assistance center if
needed.
Disconnect the mains power if the fixture is has not been used for a long time.
DO use the original packing materials before transporting it again.
DO NOT look directly at the light while the LED is on.
DO NOT start on the unit without LED enclosure or when housing is damaged.
3E
2. Technical Specifications
Power Voltage:
AC 100~240V, 50/60Hz
Power Consumption:
515W
Light Source:
1188x0.8W RGBW LED
Beam Angle:
110°
Spot Angle:
152°
Dimmer/Strobe:
Smooth dimming from 0-100%; outstanding strobe effect with variable speed
Control:
DMX Channel: 4(8 bit)/8(16 bit)/8/9(16 bit)/16 Channels
Control Mode: DMX512, RDM
Firmware Upgrade via DMX link
Construction:
Display: OLED display
Data In/Out: 3-pin IP XLR (5-pin IP XLR is optional)
Power In/Out: Waterproof Power Connector in/out
Protection Rating: IPX4
Features:
Variable CTO
High brightness, smooth color mixing, powerful wash effect
3 x led zones can be controlled individually
Equipped with a special patented plug structure, can be easily combined with each other or with
other THUNDER series
4E
Dimension/Weight:
503x183x318mm, 10.5kgs
19.8"x7.2"x12.5"in, 23.1lbs
Photometric Diagram:
3. Installation and Connection
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is
firmly fixed to avoid vibration and slipping while operating. Always ensure that the structure to
which you are attaching the unit is secure and is able to support a weight of 10 times of the unit’s
weight. Also always use a safety cable that can hold 12 times of the weight of the unit when
installing the fixture.
The equipment must be fixed by professionals. And it must be fixed at a place where is out of the
touch of people and has no one pass by or under it. The installation height of the equipment is
between 0 and 30 meters.
5E
Installation mode of the hanging bracket:Installation mode of a single angle-adjustable
equipment’s hanging bracket:
Installation mode of the bolt: Assembly method between two equipment:
Installation mode of the big hanging bracket (operational):
6E
Assembly method between multiple equipment:
Warning: no more than 7 equipment can be spliced vertically
7E
4. Control Panel
1. Display: To show the various menus and the selected function
2. Button:
MENU To enter into move backward or leave the menu
UP To go backward to move up in the menu
DOWN To go forward to move down in the menu
ENTER To perform the desired functions
3. DMX IN:
For DMX512 operation, use 3-pin XLR cable to link the units together (5-pin XLR is optional)
4. DMX OUT:
For DMX512 operation, use 3-pin XLR cable to link the next unit (5-pin XLR is optional)
5. POWER IN: Used to connect to supply power
6. POWER OUT: Used to connect to the next fixture
8E
5. How To Set The Unit
5.1 Main Function
Turn on the unit, press the MENU button into menu mode, and press the UP/DOWN button until
the required function is shown on the monitor. Select the function by the ENTER button. Use the
UP/DOWN button to choose the submenu, press the ENTER button to store and automatically
return to the last menu. Press the MENU button or let the unit idle 30 seconds to exit menu mode.
The main functions are shown below:
9E
Table des matières
Autres manuels ACME Équipement d'éclairage
ACME
ACME COMET Manuel utilisateur
ACME
ACME Inferno Manuel utilisateur
ACME
ACME Gemini Manuel utilisateur
ACME
ACME Theatre Spot 150 Manuel utilisateur
ACME
ACME BRIGHT Manuel utilisateur
ACME
ACME TRACK 10 Manuel utilisateur
ACME
ACME LED-MTX6S-8W Manuel utilisateur
ACME
ACME IP Cabin AR-01 Manuel utilisateur
ACME
ACME CHIRON Manuel utilisateur
ACME
ACME LS-1005 Manuel utilisateur
ACME
ACME LED-212RGB Manuel utilisateur
ACME
ACME XP-5000SZ F Manuel utilisateur
ACME
ACME VENOM LED-460 Manuel utilisateur
ACME
ACME Xperior 1500SZ Manuel utilisateur
ACME
ACME LED-MS600 PE Manuel utilisateur
ACME
ACME DMX512 Dynamic Scan Manuel utilisateur
ACME
ACME Dotline180 Manuel utilisateur
ACME
ACME Spartan Hybrid Manuel utilisateur
ACME
ACME Ozone 3 Manuel utilisateur
ACME
ACME Splendor 220 II Manuel utilisateur
Manuels Équipement d'éclairage populaires d'autres marques
Qazqa
Qazqa Suplux SL 3 Black 103062 Manuel utilisateur
Commercial Electric
Commercial Electric 54568141 Manuel utilisateur
CREE LIGHTING
CREE LIGHTING 304 Series Manuel utilisateur
Goobay
Goobay 49867 Manuel utilisateur
ECOMAN ITALIA
ECOMAN ITALIA LED T8 Manuel utilisateur
Alkalite
Alkalite Krypton KT-81 Manuel utilisateur
