XAC XCE-25-C Manuel utilisateur

CHIP AND PIN MOBILE PAYMENT DEVICE XCE-25-C

INSTALLATION GUIDE

EFORE

TARTING

There is a micro USB port (Figure 1) covered under the protection cover (Figure 2); this port is

used for battery charging, debugging, firm are update and key injection.

NOTE: The battery of xCE-25-C is built-in and rechargeable.

Figure 1 Figure 2

Operating Temperature: 0

C to 40

Battery Pack: 3.7V, 1050mAh

Input: 5V, 500mA

OWER

FF THE

EVICE

To po er on the device, press and hold the Po er key for five seconds until the green LED

light flashes and the screen sho s ords. Once it is po ered on, the LED ill blink every five

seconds to indicate it is active.

To po er off the device, press and hold the Po er key for five seconds until the screen

become blank.

Figure 3

NOTE: xCE-25-C ill po er off itself automatically if unused for 5 minutes.

ONNECTING TO

MART

EVICES

Once xCE-25-C is po ered on Bluetooth ill be searchable. From the smart device’s Bluetooth

settings, pair and connect to xCE-25-C.

SING THE

AGNETIC

ARD

EADER

Find the magnetic card reader slot on the right side of the device (Figure 4). S ipe the card

through the slot ith magnetic stripe side facing the same direction as the keypad (Figure 5).

Figure 4 Figure 5

SING THE

ARD

EADER

Find the IC card reader slot on the bottom of the device (Figure 6). Insert an IC card into the

slot ith the chip side facing the same direction as the keypad (Figure 7).

Figure 6 Figure 7

SING THE

Press Cancel(X) key to terminate any current function and press the Enter(O) key to confirm a

value or an option. Press the numeric key to enter the desirable numbers. Press the letter B

should press 2 number key t ice, then the screen displays “B” (Figure 8).

Figure 8

SING THE

ONTACTLESS

ARD

EADER

Contactless reader antenna is around the display and PIN pad. It ill light up ith LED signal

hen terminal is po ered on and that means reader is orking normally. Put contactless card

to approach the antenna of card reader (Figure 9) for reading the card data during transaction.

Figure 9

Federal Communication Commission Interference Statement

This device complies ith Part 15 of the FCC Rules. Operation is subject

to the follo ing t o conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

This equipment has been tested and found to comply ith the limits for

a Class A digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in

accordance ith the instructions, may cause harmful interference to

radio communications. Ho ever, there is no guarantee that

interference ill not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, hich

can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one of the follo ing

measures:

- Reorient or relocate the receiving antenna.

- Increase the separation bet een the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that

to hich the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by

the party responsible for compliance could void the user's authority to

operate this equipment.

This transmitter must not be co-located or operating in conjunction ith

any other antenna or transmitter.

Radiation Exposure Statement:

The product comply ith the FCC portable RF exposure limit set forth for

an uncontrolled environment and are safe for intended operation as

described in this manual. The further RF exposure reduction can be

achieved if the product can be kept as far as possible from the user body

or set the device to lo er output po er if such function is available.

The above information is the exclusive intellectual property of XAC Automation Corporation and shall not be disclosed,

distributed or reproduced without permission of XAC Automation Corporation.

XAC AUTOMATION CORP. shall not be held liable for technical and editorial omissions or errors made herein; nor for

incidental or consequential damages resulting from the furnishing, performance or use of his material.

XAC Automation Corporation

886-3-577-2738

www.xac.com.tw

Table des matières

Autres manuels XAC Terminal de paiement

XAC

XAC RP-10 Instructions d'utilisation et d'entretien

XAC

XAC XC50 Manuel utilisateur

XAC

XAC XCL AT-100 SERIES Manuel utilisateur

XAC

XAC XCL AT-150 SERIES Manuel utilisateur

XAC

XAC xCL AT-170 Series Manuel utilisateur

XAC

XAC xCL AP-10 Manuel utilisateur

XAC

XAC PINPAD 8006L1-1CR Series Manuel utilisateur

XAC

XAC FD130 Manuel utilisateur

XAC

XAC 8002R PIN PAD Manuel utilisateur

XAC

XAC XPED-8006L2-3CR Manuel utilisateur

XAC

XAC FD150 Manuel utilisateur

XAC

XAC FD130Duo Manuel utilisateur

XAC

XAC xCL AP-10 Manuel

XAC

XAC xCL_AT-150 Series Manuel utilisateur

XAC

XAC xAPT-103LE Manuel utilisateur

XAC

XAC XCL_AT-170 Manuel utilisateur

XAC

XAC XCL_T305 Instructions d'utilisation et d'entretien

XAC

XAC xAPT-103WiFi.3G Manuel utilisateur

XAC

XAC XCL AT-150 SERIES Instructions d'utilisation et d'entretien

XAC

XAC CL AT-170-R Series Manuel utilisateur

Manuels Terminal de paiement populaires d'autres marques

PAX

PAX D180SRF Manuel utilisateur

LinkPoint

LinkPoint AIO Manuel utilisateur

Moneris

Moneris hispeed 6200 Manuel utilisateur

Moneris

Moneris iWL220 Manuel utilisateur

Ingenico

Ingenico iUC280 Manuel utilisateur

Ingenico

Ingenico Tetra Move/5000 Manuel utilisateur

Ingenico

Ingenico iWL250B Manuel utilisateur

Optimum

Optimum M4230 Manuel utilisateur

Triton

Triton RL5000 Manuel utilisateur

Ingenico group

Ingenico group Lane/8000 Manuel utilisateur

Gilbarco

Gilbarco FlexPay IV CRIND Manuel d'installation et d'exploitation

Infinite Peripherals

Infinite Peripherals Infinea Tab Lite Manuel utilisateur

PAX

PAX S920 Manuel utilisateur

Ingenico

Ingenico iCT220, iCT250 Manuel utilisateur

dejavoo

dejavoo Z Series Manuel utilisateur

VeriFone

VeriFone VX 520 Series Manuel utilisateur

Optomany

Optomany axept S900 Manuel utilisateur

Skyzer

Skyzer iWL252 BLUETOOTH Manuel utilisateur