WE-EF ETV100 LED Manuel

Surge Protection

This product features built-in surge protection circuitry in compliance with

applicable standards.

For comprehensive protection of a luminaire installation against lightning and

electrical surges, it is essential to cover mains supply and data input lines at

the distribution board level, by using respective primary (Type 1) and secondary

(Type 2) surge arrestors in compliance with EN61643-11/IEC61643-1.

Warning

Ensure that all required surge protection measures are in place and activated

prior to luminaire installation. Also, disconnect luminaires before operating

high-power devices such as, for example, electrical arc welders.

Do not open during installation

This product is factory-sealed.

Refer to the instructions contained in this

document for details.

WE-EF LEUCHTEN

Installation and Maintenance

Instructions

Inground Luminaire

ETV100 LED

Inground Luminaire

ETV100

IP67, IK08. Class I. ta = 25°C

Product Dimensions:

ETV100 series L

ETV120 627

ETV130/ETV130-CC 927

ETV140/ETV140-CC 1227

Mounting Accessories:

Installation blockout Type I Type II

B = 160 mm B = 130 mm A

for 1 x ETV120 186-0306 186-0281 675

for 2 x ETV120 186-0307 186-0282 1304

for 3 x ETV120 186-0308 186-0283 1933

for 4 x ETV120 186-0309 186-0284 2562

for 1 x ETV130/ETV130-CC 186-0310 186-0285 975

for 2 x ETV130/ETV130-CC 186-0311 186-0286 1905

for 3 x ETV130/ETV130-CC 186-0312 186-0287 2833

for 4 x ETV130/ETV130-CC 186-0313 186-0288 3762

for 1 x ETV140/ETV140-CC 186-0314 186-0289 1275

for 2 x ETV140/ETV140-CC 186-0315 186-0290 2504

for 3 x ETV140/ETV140-CC 186-0316 186-0291 3733

for 4 x ETV140/ETV140-CC 186-0317 186-0292 4962

d:h

[A6] 1:10

[LA10] 1:5

Light Source

LED

Maintenance

Apart from cleaning the product’s exterior surfaces, no special maintenance work is required.

Do not use high-pressure cleaners.

In case of component failure due to abnormal circumstances or at end of life, replacement must be carried out

E\DVXLWDEO\TXDOLƂHGDQGWUDLQHGSURIHVVLRQDO

Warning: Do not open luminaire while mains supply is switched on.

For operation with Tunable White, a DALI DT8 controller is required.

Installation

The product must be installed and maintained by a

VXLWDEO\TXDOLƂHGSURIHVVLRQDOLQFRPSOLDQFHZLWKODWHVW

building/construction and/or electrical regulations and

relevant legislation.

Warning: Switch off mains electrical supply prior to

installing and connecting the luminaire.

Notice:,IWKHOXPLQDLUHLVPRGLƂHGE\DQ\ERG\RWKHU

than the original manufacturer, then the warranty will

no longer be valid and shall become the full respon-

sibility of the modifying person/organisation. Claims

based on defects attributable to improper installation

and/or application, and the consequences thereof, are

excluded.

Attention: The luminaire is factory-sealed and does

not need to be opened during installation.

The installation on site must comply with local and/or

national health and safety regulations.

Blockout Installation Procedure

(during earth or masonry work)

1) Ensure that proper drainage is provided for

the shown installation methods:

a) In landscape/paved areas, sand or concrete

with gravel base (Fig. I).

b) With fully concreted installation, drainage

piping must be provided (Fig. II).

3) Test drainage (ensure water drains within

30 mins, Warning: warranty void if luminaire

installed without appropriate drainage)

2) Ensure a suitable recess.

Fig. II

Draining pipe

Fig. I

Fig. Il

4) Remove installation cover Aout of installation

blockout B.

5) Feed mains supply cable C(and second cable

Efor through wiring) through holes inside

blockout.

6) Replace blockout cover prior to luminaire

installation to prevent tripping hazard/

concrete dirt getting into blockout.

7) Blockout needs to get placed on an even, stable

DUHD7RSHGJHQHHGVWREHƃXVKZLWKVXUIDFH

Attention: ,IƃRRUZLOOEHWLOHGRUSDYHG

afterwards leave an appropriate gap. In case

luminaire gets installed at a later time, blockout

must get covered by installation cover A, to

make sure no concrete or dirt may enter

luminaire. Installation cover ensures that

blockout does not get damaged during masonry

works and needs to remain inside blockout until

installation of luminaire.

8) Framing should be installed to prevent vegeta-

tion from growing over the lens.

Frame

9) Switch off mains electrical supply.

12)Remove installation cover Afrom blockout B.11)Luminaire is pre-wired and LED included.

Opening the luminaire is not necessary.

Luminaire Installation Procedure

10)Check that rating shown on luminaire label

conforms with mains electrical supply.

(example)

ETV120 220-240V/50-60 Hz

186-XXXX SOE XXXXXXX

02/19 IP67

b) DALI (L = Phase, N = Neutral, = Earthing,

DA/DA = DALI control line, DA/DA = DALI

control line)

a) ON/OFF (L = Phase, N = Neutral,

= Earthing)

ø 7.5-16 mm for ON/OFF ø 6.5-12 mm for DALI

c) DMX: refer to separate TO9256W wiring instruction for hybrid DMX cable.

Attention:

a) To properly terminate and seal cables with sealable junction box, refer to information

packed with each sealable junction box G.

b) Cable sheaths must be contained within gel.

For operation with Tunable White, a DALI DT8 controller is required.

13)Take sealable junction box Gfrom its bag and open it.

Warning: Be careful to not get dirt inside the gel connector when opened and connecting mains

cable. Connect leads of luminaire cable Dand mains supply cable C (and second cable Efor through

wiring) to respective terminals in terminal connector F. Mains cables Cand Emust not cross to

ensure sealable junction box Gcan be properly closed.

15)Install spacers I. 16)To remove luminaire unfasten screws K out

of spacers I until you can grab their heads.

Insert lever Lbetween head of screws and

spacers. Lift spacers in an upwards direction.

14)Place sealable junction box Gand luminaire Hinside blockout. Make sure no cable is squeezed.

Attention: For [LA10] and [A6], ensure correct orientation of the luminaire.

Remove label before operation of luminaire.

we-ef

DIRECT LUMINAIRE TOWARDS WALL

www.we-ef.com

WE-EF LEUCHTEN

Germany

Tel +49 5194 909 0

Fax +49 5194 909 299

info.germany@we-ef.com

WE-EF LUMIERE

France

Tel +33 4 74 99 14 44

Fax +33 4 74 99 14 40

info.france@we-ef.com

WE-EF HELVETICA

Switzerland

Tel +41 22 752 49 94

Fax +41 22 752 49 74

info.switzerland@we-ef.com

WE-EF LIGHTING

Thailand

Tel +66 2 738 9610

Fax +66 2 175 2174

LQIRDVLDSDFLƂF#ZHHIFRP

WE-EF LIGHTING

Australia

Tel +61 3 8587 0444

Fax +61 3 8587 0499

info.australia@we-ef.com

WE-EF LIGHTING

United States of America

Tel +1 724 742 0030

Fax +1 724 742 0035

info.usa@we-ef.com

TO9258W0321© WE-EF 2021

7HFKQLFDOVSHFLƂFDWLRQVDUH

subject to change.

Table des matières

Autres manuels WE-EF Éclairage extérieur

WE-EF

WE-EF PFL230 Manuel utilisateur

WE-EF

WE-EF DOC100 LED Series Manuel utilisateur

WE-EF

WE-EF ASP500 LED Manuel utilisateur

WE-EF

WE-EF RMM320 Manuel utilisateur

WE-EF

WE-EF ETC109 LED Manuel utilisateur

WE-EF

WE-EF LEUCHTEN AFL100 Series Manuel utilisateur

WE-EF

WE-EF RMM320 LED Manuel utilisateur

WE-EF

WE-EF PSY414 Manuel utilisateur

WE-EF

WE-EF PIA230 Manuel utilisateur

WE-EF

WE-EF STO Series Manuel utilisateur

WE-EF

WE-EF LTM444 Manuel utilisateur

WE-EF

WE-EF ZA630 Manuel utilisateur

WE-EF

WE-EF PIA240 Manuel utilisateur

WE-EF

WE-EF PIA230 LED Manuel utilisateur

WE-EF

WE-EF LTM440 LED Manuel utilisateur

WE-EF

WE-EF FLA441 LED Manuel utilisateur

WE-EF

WE-EF VLR110 LED Manuel utilisateur

WE-EF

WE-EF PFL540 Manuel utilisateur

WE-EF

WE-EF PLS400 Series Manuel utilisateur

WE-EF

WE-EF EFL540 LED Manuel utilisateur

WE-EF

WE-EF QRO379 LED Manuel utilisateur

WE-EF

WE-EF PFL540 LED Manuel utilisateur

WE-EF

WE-EF ETV100 Series Manuel utilisateur

WE-EF

WE-EF ETC100 Series Manuel utilisateur

Manuels Éclairage extérieur populaires d'autres marques

Sealey

Sealey LED37 Manuel utilisateur

nordlux

nordlux VEJERS Guide de l'utilisateur

SImx

SImx ELITE LED LHTC637 Manuel utilisateur

GEV

GEV CAROLINE 10833 Manuel utilisateur

NEBO

NEBO NEB-LSP-0020 Manuel utilisateur

Lindby

Lindby 9949029 Manuel utilisateur

HEPER

HEPER DOGO Side LW6048.585-US Instructions d'installation et d'utilisation

HEPER

HEPER LW8034.003-US Instructions d'installation et d'utilisation

Maretti

Maretti VIBE S 14.6080.04.A Manuel utilisateur

BEGA

BEGA 84 253 Manuel

HEPER

HEPER MINIMO Instructions d'installation et d'utilisation

LIGMAN

LIGMAN BAMBOO 3 Manuel utilisateur

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Manuel utilisateur

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Manuel utilisateur

urban ambiance

urban ambiance UQL1273 Manuel utilisateur

TotalPond

TotalPond 52238 Manuel utilisateur

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Manuel utilisateur

LIGMAN

LIGMAN DE-20023 Manuel utilisateur