Volt All-Star Brass Tommy Light Manuel utilisateur

VOLT®Low Voltage Landscape Lighting

LED All Star Tommy Light

INSTALLATION INSTRUCTIONS

Specications and product details subject to change without notice.

[email protected] • 813.978.3700

Help Hotline:

1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)

VOLT®LED All Star Tommy Light Package Contents

Parts Required (Sold Separately)

Product Dimensions

Important: Please Read Before Installation

Important Safety Instructions

INSTALLATION INSTRUCTIONS

This luminaire is intended for installation in accordance with local codes

and the National Electric Code (NEC). Failure to adhere to these codes

and instructions may result in serious injury, property damage, or void the

warranty.

These instructions do not intend to cover all variations in installation,

operation maintenance or mounting situation.

1. Make sure that the power is turned OFF before installing or servicing

this luminaire.

2. WARNING: risk of electrical shock. Install all luminaires 10 feet

(3.05M) or more from pool, spa or fountain.

3. This luminaire is intended to be used only with a power supply

(transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.

4. Wiring connections must be made with wire connectors that is suitable

for outdoor use.

5. Position the low voltage wire and wire connector so that it is located

within 6 inches (15.2 cm) from a building structure, a luminaire or

tting.

6. The main low voltage cable is intended for shallow burial - less than 6

inches (152 mm)

7. If additional lengths of low voltage cable is required, please contact

www.voltlighting.com or call 1-813-978-3700.

INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS

Lighted lamp is HOT!

WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.

1. Turn off/unplug and allow to cool before replacing lamp.

2. Lamp gets HOT quickly! Contact only switch/plug when turning on.

3. Do not touch the hot lens, guard or enclosure.

4. Keep lamp away from materials that may burn.

5. Do not touch lamp at any time. Use a soft cloth. Oil from skin may

damage lamp.

6. Do not operate the luminaire tting with a missing or damage shield.

SAVE THESE INSTRUCTIONS

A. (1) Fixture

A. (3) Self-tapping Screws

B. (3) Wall Anchors

www.voltlighting.com [email protected] • 813.978.3700

5.00”

2.55”

C. (1) LED MR16 Lamp

Remove Faceplate and Glare Guard

Glare Guard

Faceplate

Screw

Fixture

Use a screwdriver to unlock the set

screw. Then, remove the glare guard

from the faceplate. Next, remove the

faceplate from the xture.

3.10”

INSTALLATION INSTRUCTIONS

www.voltlighting.com customersupport@voltlighting.com • 813.978.3700

VOLT®LED All Star Tommy Light

Install Lamp

Install Faceplate and Glare Guard

Lamp

Set Screw

Socket

Faceplate

Glare Guard

Fixture

Install Fixture

Determine your desired location for

the xture. Pass self-tapping screws

through the holes on the surface

mount. Thread self-tapping screws

into the wall surface to secure the

xture.

NOTE: Wall anchors are required

for brick walls or concrete walls.

To determine locations for the wall

anchors, place the surface mount

onto your desired location and

mark the points from the holes in

the mount.

Fixture

Self-tapping Screw

Wall Anchors

Insert lamp with correct wattage

and type marked on xture label.

CAUTION: Do not exceed maximum

wattage marked on luminaire label.

NOTE: DO NOT touch lamp with

bare hands. Use soft cloth to

handle lamp.

Replace the faceplate over the

lamp and thread onto the xture.

Tighten until snug. Attach the glare

guard back onto the faceplate and

secure with the set screw. Tighten

until snug with a screwdriver.

Wire Connections

Lay out the supply cable to the transformer. Strip both leads from the

luminaire pigtail. Connect leads from the supply cable to transformer

(sold separately).

Fixture

Pigtail

Transformer

(Sold Separately)

Supply Cable

INSTALLATION INSTRUCTIONS

www.voltlighting.com

VOLT®LED All Star Tommy Light

Specications and product details subject to change without notice.

[email protected] • 813.978.3700

www.voltlighting.com

Help Hotline:

1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)

Adjust Angle of Lamp

Install/Replace Lamp

Unscrew the set screw on the glare guard, then remove the glare guard

and faceplate to expose the lamp. Replace it with the correct wattage and

type marked on the xture label. Finally, reinstall the faceplate and glare

guard, then tighten the set screw.

IMPORTANT: Halogen lamps must be protected from moisture and dust at

all times. Always reinstall Faceplates and glare guards immediately.

Knuckle

Adjustment

Loosen the knuckle adjustment

screw and adjust the luminaire to

your desired angle and then tighten

adjustment screw.

is-GGT1-ver1.pdf

Table des matières

Autres manuels Volt Éclairage paysager

Volt

Volt VPL-1041-4-BBZ Manuel utilisateur

Volt

Volt VFL-4002-ABZ Manuel utilisateur

Volt

Volt VFL-4501-4-BBZ Manuel utilisateur

Volt

Volt VAL-1811-40-BBZ Manuel utilisateur

Volt

Volt VHS-605-4-FPG Manuel utilisateur

Volt

Volt VHS-650-4-BBK Manuel utilisateur

Volt

Volt VSM-2407 Manuel utilisateur

Volt

Volt VAL-2049-35-4-BBZ Manuel utilisateur

Volt

Volt VPL-3024-BBZ Manuel utilisateur

Volt

Volt RGBW BuddyPro VHS-6725-0-BRB Manuel utilisateur

Volt

Volt VWL-7125-BBZ Manuel utilisateur

Volt

Volt VDL-6009-4-BBZ Manuel utilisateur

Volt

Volt VPL-1047-4-BBZ Manuel utilisateur

Volt

Volt VPL-3024-BBZ Manuel utilisateur

Volt

Volt VSPL-1047-BBZ Manuel utilisateur

Volt

Volt VPL-1019-26-4-BBZ Manuel utilisateur

Volt

Volt VPL-1012-BBZ Manuel utilisateur

Volt

Volt VPL-1042-4-BBZ Manuel utilisateur

Volt

Volt All-Star VAL-2000 Series Manuel utilisateur

Volt

Volt Sedona VHT-306-11-BBZ Manuel utilisateur

Volt

Volt VAL-180 Manuel utilisateur

Volt

Volt VSM-2408-0-BBZ Manuel utilisateur

Volt

Volt VPL-1006 Manuel utilisateur

Volt

Volt VDL-6000 Manuel utilisateur

Manuels Éclairage paysager populaires d'autres marques

Intex

Intex SL1006 Manuel utilisateur

LED Group

LED Group ROBUS R2IN13W Manuel utilisateur

Patriot Lighting

Patriot Lighting 343-1484 Manuel utilisateur

Hess

Hess SERA G: SERA S Manuel utilisateur

LIGMAN

LIGMAN JET 44 Manuel utilisateur

LIGMAN

LIGMAN MALTA 1 Manuel utilisateur

Cooper Lighting

Cooper Lighting MCGRAW-EDISON WBG Manuel utilisateur

Cooper Lighting

Cooper Lighting Invue 42 - 175W Manuel utilisateur

Saxby Lighting

Saxby Lighting Islay 68784 Manuel

LIGMAN

LIGMAN EU-10016-3 Manuel utilisateur

Cooper Lighting

Cooper Lighting McGraw-Edison ZD Credenza Manuel utilisateur

LIGMAN

LIGMAN KI-60475 Manuel utilisateur

Cooper Lighting

Cooper Lighting Generation CLB25MWW5C373 Manuel utilisateur

Malibu Boats

Malibu Boats CL905K Manuel utilisateur

LIGMAN

LIGMAN NYB-30161 Manuel utilisateur

LIGMAN

LIGMAN SI-80021 Manuel utilisateur

Malibu Boats

Malibu Boats CM110P Manuel utilisateur

U.S.T.E.

U.S.T.E. VISTA 8202 Manuel utilisateur