Vista 1218 Manuel utilisateur

INSTALLATION INSTRUCTIONS Path and Spread Lights

1218

Shade

Shade screws

1/2" NPT

Stem

Lens

TOOLS REQUIRED FOR

INSTALLATION:

●Wire strippers

●Flat head screwdriver

●Thread sealant

WARNING: Luminaire must be installed and grounded in accordance with the National Electrical Code (NEC)

and local codes. For portable stake or surface mount using a cord and plug, the luminaire must be plugged into

a receptacle protected by a ground fault circuit interrupter (GFI). Failure to do so may result in serious injury and/

or damage to the luminaire.

MAINTENANCE: To assure proper operation and efciency and to prevent luminaire overheating, lens must be

kept clean and free of dirt, dust, leaves, trash and mineral deposits from water. A regular schedule maintenance

program is recommended.

SAFETY WARNING: Luminaire can become very hot depending on the lamp wattage used. Lens and housing

around the lamp can become hot enough to blister hands. Particular care should be taken not to locate

luminaires where small children can reach them if high wattage lamps are used.

NOTE: Always use UL recognized wire connectors for connections.

NOTE: Save these instructions for future reference.

IN GROUND LUMINAIRE IS UL LISTED FOR ABOVE GRADE INSTALLATION ONLY.

LUMINAIRE MOUNTING:

1. Make sure electrical supply is off at circuit breaker before starting luminaire installation or servicing.

2. Thread luminaire onto junction box or other mounting device until it is at desired direction using thread sealant.

3. Attach luminaire leads to line in leads observing polarity, black to black, white to white and green to ground using

silicone lled safety connectors (provided).

4. Attach junction box cover with luminaire to junction box (by others). Make sure not to pinch wires that may be

sandwiched between cover and box.

5. Coat exposed luminaire threads with thread sealant to keep moisture from entering junction box or other mounting

device.

6. Install lamp.

7. Install shade and lens and tighten screws evenly.

8. Supply power to the luminaire and check for proper operation.

1625 Surveyor Avenue • Simi Valley, CA 93063 • (805) 527-0987 • (800) 766-VISTA (8478)

FAX: (888) 670-VISTA (8478) • [email protected] • www.vistapro.com

120V SERIES

Lamp Information

Cat No Lamp Type Max Watts

1217 A19

Incandescent

IMPORTANT SAFETY INSTRUCTIONS

THE LIGHTED LAMP IS HOT!!

WARNING: TO REDUCE THE RISK OF FIRE, OR INJURY TO

PERSONS:

1. Turn off/unplug and allow to cool before replacing lamp.

2. Lamps get hot quickly! Contact only switch/plug when turning on.

3. Do not touch hot lens, guard or enclosure.

4. Keep lamp away from material that may burn.

5. Do not touch the lamp at any time. Use a soft cloth. Oil from the skin may

damage lamp.

6. Do not operate luminaire tting with a missing or damaged cover.

LAMP INSTALLATION/REPLACEMENT:

CAUTION: Do not exceed maximum wattage marked on luminaire label.

1. To prevent electrical shock, disconnect from electrical supply before service.

2. Loosen screws from shade.

3. Remove shade and lens to expose lamp.

4. Replace lamp with correct wattage and type marked on xture label.

NOTE: DO NOT touch lamp with bare hands. Always use soft cloth or the plastic wrapping (if available) from the lamp to

handle the lamp.

5. Re-install shade and lens and tighten screws evenly.

1625 Surveyor Avenue • Simi Valley, CA 93063 • (805) 527-0987 • (800) 766-VISTA (8478)

FAX: (888) 670-VISTA (8478) • [email protected] • www.vistapro.com

Table des matières

Autres manuels Vista Éclairage extérieur

Vista

Vista 5203 Series Manuel utilisateur

Vista

Vista 5104 Manuel utilisateur

Vista

Vista T3-LED Manuel utilisateur

Vista

Vista Landscape Series Manuel utilisateur

Vista

Vista 4243 Manuel utilisateur

Vista

Vista 6223 Landscape Series Manuel utilisateur

Vista

Vista 5237 Manuel utilisateur

Vista

Vista 2500 Manuel utilisateur

Vista

Vista 9222 Landscape Series Manuel utilisateur

Vista

Vista 2130 Series Manuel utilisateur

Vista

Vista 4250 Manuel utilisateur

Vista

Vista 2120 Manuel utilisateur

Vista

Vista 5250 Manuel utilisateur

Vista

Vista 2161 Series Manuel utilisateur

Vista

Vista 1447 Manuel utilisateur

Vista

Vista 12V Series Manuel utilisateur

Vista

Vista Landscape Series Manuel utilisateur

Vista

Vista 4017 Manuel utilisateur

Vista

Vista 12V SERIES Manuel utilisateur

Vista

Vista 1093 Manuel utilisateur

Vista

Vista 7223 Landscape Series Manuel utilisateur

Vista

Vista 2166 Series Manuel utilisateur

Vista

Vista Landscape Series Manuel utilisateur

Vista

Vista 2165 Manuel utilisateur

Manuels Éclairage extérieur populaires d'autres marques

Sealey

Sealey LED37 Manuel utilisateur

nordlux

nordlux VEJERS Guide de l'utilisateur

SImx

SImx ELITE LED LHTC637 Manuel utilisateur

GEV

GEV CAROLINE 10833 Manuel utilisateur

NEBO

NEBO NEB-LSP-0020 Manuel utilisateur

WE-EF

WE-EF PFL540 LED Manuel utilisateur

Lindby

Lindby 9949029 Manuel utilisateur

HEPER

HEPER DOGO Side LW6048.585-US Instructions d'installation et d'utilisation

HEPER

HEPER LW8034.003-US Instructions d'installation et d'utilisation

Maretti

Maretti VIBE S 14.6080.04.A Manuel utilisateur

BEGA

BEGA 84 253 Manuel

HEPER

HEPER MINIMO Instructions d'installation et d'utilisation

LIGMAN

LIGMAN BAMBOO 3 Manuel utilisateur

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Manuel utilisateur

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Manuel utilisateur

urban ambiance

urban ambiance UQL1273 Manuel utilisateur

TotalPond

TotalPond 52238 Manuel utilisateur

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Manuel utilisateur