Venstar T4700 Mode d'emploi

with Humidity Control

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for an

intentional radiator, pursuant to Part 15, subpart C of the FCC rules.These limits

are designed to provide reasonable protection against harmful interference

in a residential installation.This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference in radio communications.

However, there is no guarantee that the interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the

following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that of the

receiver.

•Consult the dealer or an experienced radio orTV technician for help.

Notice: Only peripherals complying with FCC limits may be attached to this

equipment. Operation with noncompliant peripherals or peripherals not

recommended by Venstar, is likely to result in interference to radio and TV

reception. Changes or modiﬁcations to the product, not expressly approved by

Venstar could void the user’s authority to operate the equipment.

FCC - INDOOR Mobile Radio Information:

To comply with FCC/IC RF exposure limits for general population / uncontrolled

exposure, the antenna(s) used for this transmitter must be installed to provide a

separation distance of at least 20 cm from all persons and must not be co-located

or operating in conjunction with any other antenna or transmitter.

This Device complies with Industry Canada License-exempt RSS standard(s).

Operation is subject to the following two conditions: 1) this device may not

cause interference, and 2) this device must accept any interference, including

interference that may cause undesired operation of the device.

Follow the Installation Instructions before proceeding. Set the

thermostat mode to “OFF” prior to changing settings in setup

or restoring Factory Defaults.

CAUTION

This Voyager thermostat has the ability to receive updates to its ﬁrmware.

Periodically ﬁrmware updates are released by the manufacturer to add features

and/or performance enhancements.This manual was produced reﬂecting the

most current ﬁrmware/feature set at the time of publication, ﬁrmware rev. 1.0.

Firmware releases after rev. 1.0 may not be adequately depicted in this manual.

Please refer to the appropriate website or contact your place of purchase to learn

about changes to the thermostat after ﬁrmware release 1.0.

Under Industry Canada regulations, this radio transmitter may only operate using

an antenna of a type and maximum (or lesser) gain approved for the transmitter

by Industry Canada.To reduce potential radio interference to other users, the

antenna type and its gain should be so chosen that the equivalent isotropically

radiated power (e.i.r.p.) is not more than that necessary for successful

communication.

Cet appareil est conforme avec Industrie Canada, exempts de licence standard

RSS(s). Son fonctionnement est soumis aux deux conditions suivantes: 1) ce

dispositif ne doit pas causer d’interférences, et 2) ce dispositif doit accepter

toute interférence, y compris les interférences qui peuvent causer un mauvais

fonctionnement de l’appareil.

En vertu des règlements d’Industrie Canada, cet émetteur de radio ne peut

fonctionner en utilisant une antenne d’un type et maximale (ou moins) Gain

approuvé pour l’émetteur par Industrie Canada. Pour réduire les interférences

radio potentielles aux autres utilisateurs, le type d’antenne et son gain doivent

être choisis aﬁn que la puissance isotrope rayonnée équivalente (PIRE) ne est pas

plus de ce qui est nécessaire pour une communication réussie.

We, Venstar, declare under our sole responsibility that the device to which

this declaration relates: Complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

FCC ID: MUH-SKYPORT3

IC: 12547A-SKYPORT3

These numbers can be located on the inside of the thermostat backplate,

in the upper right corner.

MUH-SKYPORT3

iii

Glossary of Terms

Auto-Changeover: A mode in which the thermostat will turn on the

heating or cooling based on room temperature demand.

Cool Setpoint: The warmest temperature that the space should rise to

before cooling is turned on (without regard to deadband).

Deadband: The number of degrees the thermostat will wait, once a

setpoint has been reached, before energizing heating or cooling.

Dehumidify: To reduce the amount of moisture in the air.

Differential: The forced temperature difference between the heat

setpoint and the cool setpoint.

Heat Setpoint: The coolest temperature that the space should drop to

before heating is turned on (without regard to deadband).

Humidify: To increase the amount of moisture in the air.

Icon: The word or symbol that appears on the thermostat display.

Mode: The current operating condition of the thermostat (i.e. Off, Heat,

Cool, Auto).

Non-Programmable Thermostat: A thermostat that does not have the

capability of running Time Period Programming.

Override: During programmed unoccupied periods, pressing the

Override button will force the thermostat into occupied settings. During

programmed occupied periods, pressing the Override button will force

the thermostat into unoccpied settings.

Programmable Thermostat: A thermostat that has the capability of

running Time Period Programming.

Reheat: Running the cooling and 2nd stage strip heaters at the same

time in order to dehumidify the air without signicantly cooling down

the room temperature.

Temperature Swing: Same as Deadband.

Table of Contents

GET TO KNOW YOUR THERMOSTAT

Get to Know Your Thermostat.................................................... 1

Quick Start .................................................................................. 6

INSTALLATION INSTRUCTIONS

Installation Instructions .............................................................. 9

Sample Wiring Diagrams........................................................... 13

Test Operation............................................................................ 16

USER SETUP

Backlight Operation................................................................... 17

Scrolling Display Options .......................................................... 18

Emergency Heat ........................................................................ 18

Wireless Modules....................................................................... 19

Service Filter .............................................................................. 23

Runtimes .................................................................................... 24

Available Modes......................................................................... 25

INSTALLER SETUP

Setpoint Limits........................................................................... 26

Timers and Deadbands ............................................................. 27

Humidication & Dehumidication............................................ 28

Dry Contact Operation............................................................... 29

Holiday ....................................................................................... 29

Remote Sensor Operation......................................................... 30

Factory Defaults......................................................................... 32

TECHNICIAN SETUP

Sensor Calibration ..................................................................... 33

Equipment Testing ..................................................................... 33

Advanced Setup Table............................................................... 34

Troubleshooting ......................................................................... 36

INDEX ........................................................................................... 37

WARRANTY.................................................................................. 41

Get To Know Your Thermostat

Optional Wireless Module

Backlit, Scrolling Display

Backlit Cooler & Warmer

Buttons

Backlit LCD Display

Override Button

Heat or Cool

Demand Indicator

Red = Heat, Green = Cool

Setup Buttons Behind Door

Get To Know Your Thermostat

Setup Buttons

Get To Know Your Thermostat

Display Features

1The scrolling display will be used to help you easily navigate

the setup screens in the thermostat.

2Clock with Day of the Week

Indicates the current time and day. This clock is also used to

program the time period schedules.

3Mode Indicators

Selects the operational mode of the equipment.

HEAT - Indicates the heating mode.

COOL - Indicates the air conditioning mode.

HEAT & COOL - Indicates the system will automatically change-over

between heat and cool modes as the temperature varies.

OFF - Indicates heating and cooling is turned off.

4RoomTemperature Display

Indicates the current room temperature and displays the outdoor

temperature when selected.

5Outdoor icon

Indicates the temperature displayed is from the optional

outdoor sensor.

Outdoor

Fan On

COOL

AUXHEAT

Override

Day Night

Morning

Evening

Setup Step

2nd

Stage

18:88

188

Get To Know Your Thermostat

Display Features

6 Desired SetTemperature

Indicates desired room temperature(s). Also displays

the highest and lowest temperatures for the day.

7 Wi-Fi icons

One dot indicates the thermostat recognizes the wireless module.

The “pull” icon indicates the thermostat is currently connected to

the Local access point, via the optional Wi-Fi Module.

8 Setup Step icon

Indicates the step number when the thermostat

is in the setup mode.

9 2nd Stage icon

Indicates what stage of cooling or heating is currently energized.

10 icon

Indicates the keypad has been locked.

Outdoor

Fan On

EAT

Override

Day Night

Morning

Evening

Setup Step

2nd

Stage

18:88

188

Get To Know Your Thermostat

11 AuxHeat icon

Indicates 2nd stage electric strip heat is being used when the

thermostat is programmed for Heat Pump operation. Only the

Aux icon will appear during Cool to Dehumidify to indicate

Reheat operation.

12 Fan On icon

Indicates constant, continuous fan operation.

When Fan On is not lit - indicates the fan will only

operate when necessary to heat or to cool.

Outdoor

Fan On

EAT

Override

Day Night

Morning

Evening

Setup Step

2nd

Stage

18:88

188

Display Features

Table des matières

Autres manuels Venstar Thermostat

Venstar

Venstar T1900 Manuel utilisateur

Venstar

Venstar EXPLORER Manuel technique

Venstar

Venstar P474-1100RF Manuel utilisateur

Venstar

Venstar T1800 Manuel utilisateur

Venstar

Venstar T2000 Instructions originales

Venstar

Venstar INSTEON 2491T1E Manuel utilisateur

Venstar

Venstar T2300FS Manuel utilisateur

Venstar

Venstar ACC0434 Manuel utilisateur

Venstar

Venstar T0130 Manuel utilisateur

Venstar

Venstar T2900SCH Manuel utilisateur

Venstar

Venstar T1 900 Manuel utilisateur

Venstar

Venstar T2900SCH Manuel utilisateur

Venstar

Venstar EXPLORER RESIDENTIAL T3950-IAQ Mode d'emploi

Venstar

Venstar T2150 Instructions originales

Venstar

Venstar ColorTouch T5800 Mode d'emploi

Venstar

Venstar T4975-IAQ Mode d'emploi

Venstar

Venstar T1119RF Manuel utilisateur

Venstar

Venstar T1045 Manuel utilisateur

Venstar

Venstar T2700 Manuel utilisateur

Venstar

Venstar EXLORER Mini Instructions originales

Venstar

Venstar T2700 Manuel utilisateur

Venstar

Venstar T1050 Manuel utilisateur

Venstar

Venstar T1000FS Manuel utilisateur

Venstar

Venstar T1100FS Manuel utilisateur

Manuels Thermostat populaires d'autres marques

EWELLY

EWELLY EW-181 Manuel utilisateur

Prolon

Prolon T1100 Instructions d'installation

Computherm

Computherm Q20 Manuel utilisateur

Heatmiser

Heatmiser neoStat Manuel utilisateur

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Manuel utilisateur

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manuel utilisateur

Saswell

Saswell SAS920XWHB-7-S-RF Mode d’emploi

Aircalo

Aircalo TFP1-ET85P2 Manuel utilisateur

Honeywell

Honeywell CM721 Manuel utilisateur

Carrier

Carrier DEBONAIR 33CS Manuel utilisateur

Lennox

Lennox iHarmony Zone Thermostat Instructions de montage

Gemtech

Gemtech GT7000 Mode d’emploi

Rollei

Rollei Smartes 45000 Manuel utilisateur

Sinope

Sinope TH1300RF Manuel utilisateur

Honeywell

Honeywell RLV4305 Manuel utilisateur

Honeywell

Honeywell Prestige 2.0 THX9421 Manuel utilisateur

NuTone

NuTone NTBZ48 Instructions d'utilisation d'origine

Stelpro

Stelpro MAESTRO ASMT402AD Manuel utilisateur