Venstar T3900 Guide de démarrage rapide
SM
i
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for an
intentional radiator, pursuant to Part 15, subpart C of the FCC rules.These limits
are designed to provide reasonable protection against harmful interference
in a residential installation.This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference in radio communications.
However, there is no guarantee that the interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that of the
receiver.
•Consult the dealer or an experienced radio orTV technician for help.
Notice: Only peripherals complying with FCC limits may be attached to this
equipment. Operation with noncompliant peripherals or peripherals not
recommended by Venstar, is likely to result in interference to radio and TV
reception. Changes or modifications to the product, not expressly approved by
Venstar could void the user’s authority to operate the equipment.
FCC - INDOOR Mobile Radio Information:
To comply with FCC/IC RF exposure limits for general population / uncontrolled
exposure, the antenna(s) used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be co-located
or operating in conjunction with any other antenna or transmitter.
This Device complies with Industry Canada License-exempt RSS standard(s).
Operation is subject to the following two conditions: 1) this device may not
cause interference, and 2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Follow the Installation Instructions before proceeding. Set the
thermostat mode to “OFF” prior to changing settings in setup
or restoring Factory Defaults.
CAUTION
ii
This Voyager thermostat has the ability to receive updates to its firmware.
Periodically firmware updates are released by the manufacturer to add features
and/or performance enhancements.This manual was produced reflecting the
most current firmware/feature set at the time of publication, firmware rev. 1.0.
Firmware releases after rev. 1.0 may not be adequately depicted in this manual.
Please refer to the appropriate website or contact your place of purchase to learn
about changes to the thermostat after firmware release 1.0.
Under Industry Canada regulations, this radio transmitter may only operate using
an antenna of a type and maximum (or lesser) gain approved for the transmitter
by Industry Canada.To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
Cet appareil est conforme avec Industrie Canada, exempts de licence standard
RSS(s). Son fonctionnement est soumis aux deux conditions suivantes: 1) ce
dispositif ne doit pas causer d’interférences, et 2) ce dispositif doit accepter
toute interférence, y compris les interférences qui peuvent causer un mauvais
fonctionnement de l’appareil.
En vertu des règlements d’Industrie Canada, cet émetteur de radio ne peut
fonctionner en utilisant une antenne d’un type et maximale (ou moins) Gain
approuvé pour l’émetteur par Industrie Canada. Pour réduire les interférences
radio potentielles aux autres utilisateurs, le type d’antenne et son gain doivent
être choisis afin que la puissance isotrope rayonnée équivalente (PIRE) ne est pas
plus de ce qui est nécessaire pour une communication réussie.
We, Venstar, declare under our sole responsibility that the device to which
this declaration relates: Complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
MUH-SKYPORT3
iii
Glossary of Terms
Auto-Changeover: A mode in which the thermostat will turn on the
heating or cooling based on room temperature demand.
Cool Setpoint: The warmest temperature that the space should rise
to before cooling is turned on (without regard to deadband).
Deadband: The number of degrees the thermostat will wait, once a
setpoint has been reached, before energizing heating or cooling.
Dehumidify:To reduce the amount of moisture in the air.
Differential: The forced temperature difference between the heat
setpoint and the cool setpoint.
Heat Setpoint:The coolest temperature that the space should drop
to before heating is turned on (without regard to deadband).
Humidify:To increase the amount of moisture in the air.
Icon: The word or symbol that appears on the thermostat display.
Mode: The current operating condition of the thermostat (i.e. Off,
Heat, Cool, Auto, Program On).
Non-Programmable Thermostat: A thermostat that does not have the
capability of runningTime Period Programming.
Programmable Thermostat: A thermostat that has the capability of
runningTime Period Programming.
Reheat: Running the cooling and 2nd stage strip heaters at the same
time in order to dehumidify the air without cooling down the room
temperature.
Temperature Swing: Same as Deadband.
Time Period Programming: A program that allows the thermostat
to automatically adjust the heat setpoint and/or the cool setpoint
based on the time of the day.
Table of Contents
GET TO KNOW YOUR THERMOSTAT
Get to Know Your Thermostat....................................................... 1
Quick Start ..................................................................................... 6
INTALLATION INSTRUCTIONS
Installation Instructions ................................................................. 9
Sample Wiring Diagrams.............................................................. 13
Test Operation............................................................................... 16
USER SETUP
Backlight Operation...................................................................... 17
Scrolling Display Options ............................................................. 18
Programming Vacation/Away....................................................... 19
Emergency Heat ........................................................................... 19
Wireless Modules ......................................................................... 20
Service Filter ................................................................................. 24
Runtimes ....................................................................................... 25
Time Period Programming ........................................................... 26
INSTALLER SETUP
Program Mode Operation............................................................. 28
Setpoint Limits.............................................................................. 29
Timers and Deadbands ................................................................ 30
Programming Fan Operation........................................................ 31
Comfort Recovery Operation ....................................................... 31
Humidication & Dehumidication .............................................. 32
Dual Fuel Operation...................................................................... 33
Remote Sensor Operation............................................................ 34
Auxiliary Output ............................................................................ 35
Dry Contact Operation ................................................................. 37
Factory Defaults............................................................................ 38
TECHNICIAN SETUP
Sensor Calibration ........................................................................ 40
Equipment Testing ........................................................................ 40
Advanced Output Testing............................................................. 40
Advanced Setup Table ................................................................. 41
Troubleshooting ............................................................................ 44
INDEX .............................................................................................. 45
Table of Contents
1
Get To Know Your Thermostat
Optional Wireless Module
Backlit, Scrolling Display
Backlit Cooler & Warmer
Buttons
Backlit LCD Display
Mode Button
Heat or Cool
Demand Indicator
Red = Heat, Green = Cool
Setup Buttons Behind Door
Setup Buttons
2
Get To Know Your Thermostat
3
Get To Know Your Thermostat
Display Features
1The scrolling display will be used to help you easily navigate
the setup screens in the thermostat.
2Clock with Day of the Week
Indicates the current time and day. This clock is also used to
program the time period schedules.
3Mode Indicators
Selects the operational mode of the equipment.
HEAT - Indicates the heating mode.
COOL - Indicates the air conditioning mode.
HEAT & COOL - Indicates the system will automatically change-over
between heat and cool modes as the temperature varies.
OFF - Indicates heating and cooling is turned off.
4Program icon
Indicates thatTime Period Programming is running or is enabled
to be set.
5RoomTemperature Display
Indicates the current room temperature and displays the outdoor
temperature when selected.
6Outdoor icon
Indicates the temperature displayed is from the optional
outdoor sensor.
HI
Lo
Program ONOFF
Outdoor
Fan On
COOL
AUXHEAT
Day Night
Morning
Evening
Setup Step
2nd3rd
Stage
Am
Pm
18:88
188
188
88
188
1
3
3
5
6
2
4
4
Get To Know Your Thermostat
Display Features
7 Desired SetTemperature
Indicates desired room temperature(s). Also displays
the highest and lowest temperatures for the day.
8 Morning, Day, Evening & Night icons
Indicates the day part of the time period program.
9 Wi-Fi icons
Indicates the thermostat is currently connected to the
Local Area Network, via the optional Wi-Fi module.
10 Setup Step icon
Indicates the step number when the thermostat
is in the setup mode.
11 2nd and 3rd Stage icons
Indicates what stage of cooling or heating is currently energized.
12 icon
Indicates the keypad has been locked.
HI
Lo
Program ONOFF
Outdoor
Fan On
C
OO
L
A
UX
H
EAT
Day Night
Morning
Evening
Setup Step
2nd3rd
Stage
Am
Pm
18:88
188
188
88
188
7
12
7
9
10
11
8
5
Get to know your thermostat
Display Features
13 AuxHeat icon
Indicates 2nd stage electric strip heat is being used when the
thermostat is programmed for Heat Pump operation. Only the
Aux icon will appear during Cool to Dehumidify to indicate
Reheat operation.
14 Lo icon
Indicates the lowest recorded outdoor temperature for the day.*
15 Hi icon
Indicates the highest recorded outdoor temperature
for the day.*
16 Fan On icon
Indicates constant, continuous fan operation.
When Fan On is not lit - indicates the fan will only
operate when necessary to heat or to cool.
* Hi and LoTemperatures for the day, reset at midnight.
HI
Lo
Program ONOFF
Outdoor
Fan On
C
OO
L
A
UX
H
EAT
Day Night
Morning
Evening
Setup Step
2nd3rd
Stage
Am
Pm
18:88
188
188
88
188
15
13
14
16
Ce manuel convient aux modèles suivants
2
Table des matières
Autres manuels Venstar Thermostat
Venstar
Venstar T2150 Instructions originales
Venstar
Venstar T4700 Mode d'emploi
Venstar
Venstar T1700 Manuel utilisateur
Venstar
Venstar ColorTouch Manuel utilisateur
Venstar
Venstar T2900SCH Manuel utilisateur
Venstar
Venstar EXPLORER RESIDENTIAL T3950-IAQ Mode d'emploi
Venstar
Venstar T1800 Manuel utilisateur
Venstar
Venstar T2700 Manuel utilisateur
Venstar
Venstar EXPLORER Mini T2100 Manuel utilisateur
Venstar
Venstar T0051FS Manuel utilisateur
Venstar
Venstar TSTATCCPB501 Manuel utilisateur
Venstar
Venstar P474-1100RF Manuel utilisateur
Venstar
Venstar ColorTouch T8900 Guide de dépannage
Venstar
Venstar INSTEON 2491T1E Manuel utilisateur
Venstar
Venstar T1700 Manuel utilisateur
Venstar
Venstar T1000FS Manuel utilisateur
Venstar
Venstar T1900 Manuel utilisateur
Venstar
Venstar EXLORER Mini Instructions originales
Venstar
Venstar T1800 Manuel utilisateur
Venstar
Venstar T1045 Manuel utilisateur
Manuels Thermostat populaires d'autres marques
EWELLY
EWELLY EW-181 Manuel utilisateur
Prolon
Prolon T1100 Instructions d'installation
Computherm
Computherm Q20 Manuel utilisateur
Heatmiser
Heatmiser neoStat Manuel utilisateur
Aube Technologies
Aube Technologies TH111GFCI-NP 240 VCA Manuel utilisateur
Mars
Mars HEAT CONTROLLER IR Wireless Thermostat Manuel utilisateur
