Vaxcel T0414 Manuel d'instructions

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

T0414 / T0415

180408

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Mounting Screw X2

#8/32X1/2 in

Mounting Screw X2

#6/32 X1/2 in

Decorative cover Fixture Mounting Screw

Mounting StrapMounting Screw X2

#10/24 X1/4 in

Wire Connector X3

Page 1 / 3

Wall Mounted Eave Mounted

Note: Fixture can be wall mounted or eave mounted.

Important to Know:

1. If you are not familiar with state and local electrical

codes, it is recommended that you consult with a

qualified electrician.

2. This fixture requires a 120 VAC, 60 Hz power

source.

3. For general safety and to avoid any possible

damage to the photocell, be sure the power is

switched "off" before adjustment.

Maximum Wattage: 44 W

Working Temperature Range: - 4°F ~ 113°F

Features:

1. Energy saving LED fixture.

2. Photocell keeps the light OFF during daylight hours.

3. When in manual override mode, it can be switched

from 100％high level to low level brightness.

IMPORTANT:

FUNCTION:

The fixture features a photocell sensor which enables the light to turn on at dusk and off at

dawn automatically.

Turn off the power at fuse or circuit box.

180408

Page 2 / 3

1. Install the mounting strap to the outlet box with the stamped word “FRONT” facing away from the outlet box, using two

mounting screws that best fit the outlet box. Back plate should sit flush against wall surface when secured.

(Choose one matching pair of suitable mounting screws from the 3 pairs provided)

2. Pull out the source wires from the outlet box. Make wire connections using wire connectors as follows:

---Connect the black wire from the fixture to the black wire from the power source (usually black).

---Connect the white wire from the fixture to the white wire from the power source (usually white).

Carefully tuck the wires back into the outlet box.

3. Attach the back plate of the light to the mounting strap, secure it with the fixture mounting screw.

4. Push the decorative cover firmly into the fixture mounting screw hole on

the light.

5. With silicone caulking compound, caulk completely around where the back

plate meets the wall surface.

CAUTION: Be sure to caulk completely where the back plate meets

the wall surface to prevent water from seeping into the outlet box.

Manual Override Mode (nighttime operation only)

● To temporarily override the settings in “ 100% Brightness ”,

100% Brightness modes switch to manual override, turn the

wall switch “OFF” then turn it “ON” twice within 3 seconds.

switch to low level. To shift back to “ 100% Brightness

mode”, turn the wall switch “OFF” then turn it “ON” twice

within 3 seconds again.

● The light turns off automatically at dawn. ( See Fig.1 )

FRONT

Mounting Strap

Outlet Box

Wire Connector

Back Plate

Mounting Screw

Light Head

Photocell

Fixture Mounting Screw

Decorative cover

Light fixture should be mounted as shown above when installed (depending upon type of installation)

Installation Steps

100% Brightness

( low-level and

high-level ) Mode

Manual

Override

Manual Override Operation Diagram

Turn wall switch OFF-ON

-OFF-ON in 0.5~3

Seconds

Turn wall switch OFF-ON

-OFF-ON in 0.5~3 Seconds

Fig. 1

Page 3 / 3 180408

Turn on the power at the main fuse or circuit breaker box.

6. Gently grasp the light heads and move them up or down, left or right to

adjust the light coverage area. Keep the light heads 30˚ below horizontal

to avoid water damage and electrical shock (See Fig 2) .

Note: When power is first applied, the light will turn on immediately. Wait for 15 seconds to allow the sensor to

warm up.

Assembly Kit

5852MM (1 SET) For T0414

5853MM (1 SET) For T0415

The following parts are available for re-order if damaged or missing.

Mounting Screw X2

#6/32 X1/2 in Decorative cover Fixture Mounting Screw

Mounting Strap

Mounting Screw X2

#10/24 X1/4 in Wire Connector X3

Fig. 2

A: 9"

B: 6-1/4"

C: 5-3/4"

5-YEAR LIMITED WARRANTY:

All products are warranted to be free of defects in material and workmanship for five (5) years from date of purchase.

This warranty is limited to the correction of any such defect, or the replacement of any such defective item(s), provided

that: (a) we are properly notified and consent to return of the item(s) in question:(b) the item(s) is / are returned with proof

of purchase date; and (c) it is found upon inspection by us that the item(s) is / are defective as noted above. This warranty

does not cover labor costs, consequential damages, nor does it apply to any item(s) that have been improperly installed,

overloaded, altered, or otherwise abused by the customer, its agent(s) or employee(s). Finishes are specially excluded

from the terms of this warranty since they are subject to environmental maintenance deemed beyond our control. Other

than the described obligation, we assume no further liability with respect to the sale or use of our products.We make no

warranty, express or implied, and disclaim any warranty of merchantability or fitness for a particular purpose.

Troubleshooting

---The light does not come on at all:

1. Make sure the wall switch and circuit breaker are on.

2. Make sure the wiring is correct.

Mounting Screw X2

#8/32X1/2 in

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Vaxcel Éclairage extérieur

Vaxcel

Vaxcel T0521 Manuel d'instructions

Vaxcel

Vaxcel T0517 Manuel d'instructions

Vaxcel

Vaxcel X0090 Manuel d'instructions

Vaxcel

Vaxcel T0238 Manuel d'instructions

Vaxcel

Vaxcel T0696 Manuel d'instructions

Vaxcel

Vaxcel T0199 Manuel d'instructions

Vaxcel

Vaxcel T0130 Manuel d'instructions

Vaxcel

Vaxcel T0696 Manuel d'instructions

Vaxcel

Vaxcel T0594 Manuel d'instructions

Vaxcel

Vaxcel Theta T0612 Manuel d'instructions

Vaxcel

Vaxcel T0258 Manuel d'instructions

Vaxcel

Vaxcel T0624 Manuel d'instructions

Vaxcel

Vaxcel T0595 Manuel d'instructions

Vaxcel

Vaxcel T0571 Manuel d'instructions

Vaxcel

Vaxcel T0717 Manuel d'instructions

Vaxcel

Vaxcel T0181 Manuel d'instructions

Vaxcel

Vaxcel T0620 Manuel d'instructions

Vaxcel

Vaxcel T0694 Manuel d'instructions

Vaxcel

Vaxcel T0103 Manuel d'instructions

Vaxcel

Vaxcel T0575 Manuel d'instructions

Vaxcel

Vaxcel T0692 Manuel d'instructions

Vaxcel

Vaxcel T0616 Manuel d'instructions

Vaxcel

Vaxcel T0468 Manuel d'instructions

Vaxcel

Vaxcel T0476 Manuel d'instructions

Manuels Éclairage extérieur populaires d'autres marques

Sealey

Sealey LED37 Manuel utilisateur

nordlux

nordlux VEJERS Guide de l'utilisateur

SImx

SImx ELITE LED LHTC637 Manuel utilisateur

GEV

GEV CAROLINE 10833 Manuel utilisateur

NEBO

NEBO NEB-LSP-0020 Manuel utilisateur

WE-EF

WE-EF PFL540 LED Manuel utilisateur

Lindby

Lindby 9949029 Manuel utilisateur

HEPER

HEPER DOGO Side LW6048.585-US Instructions d'installation et d'utilisation

HEPER

HEPER LW8034.003-US Instructions d'installation et d'utilisation

Maretti

Maretti VIBE S 14.6080.04.A Manuel utilisateur

BEGA

BEGA 84 253 Manuel

HEPER

HEPER MINIMO Instructions d'installation et d'utilisation

LIGMAN

LIGMAN BAMBOO 3 Manuel utilisateur

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Manuel utilisateur

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Manuel utilisateur

urban ambiance

urban ambiance UQL1273 Manuel utilisateur

TotalPond

TotalPond 52238 Manuel utilisateur

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Manuel utilisateur