6 US Water inFusion Water Conditioner | 169-ISF
Visit us online at www.USWaterSystems.com Give us a call at: 1-800-608-8792
The Infusion system provides iron, sulfur and manganese removal throughout the home.
The Infusion system should be installed at the point of entry to treat your entire home, both
hot and cold water.
The Infusion backwashing tank removes iron, sulfur and manganese using oxidation. When
the system regenerates, air is pulled into the tank and creates an “air space” for the water to
pass through. The oxygen in the air space oxidizes the contaminants and separates them
from solution so they can be removed by filtration. The media in the Infusion tank provides
this filtration. This system should regenerate every night to ensure that an adequate air
space is maintained in the Infusion tank.
Infusion Benefits
Iron, Manganese & Sulfur Removal
Chemical free removal. Cost savings and environmental benefits
Virtually maintenance free.
Improves the efficiency of water-using appliances
Simple installation
Safe for landscaping and lawn watering.
Compatible with all on-site and community wastewater treatment systems
Place the conditioner as close as possible
to the pressure tank (well system) or water
meter (city water).
Place the conditioner as close as possible
to a floor drain, or other acceptable drain
point (laundry tub, sump, standpipe, etc.).
Connect the conditioner to the main water
supply pipe BEFORE the water heater.
DO NOT RUN HOT WATER THROUGH
THE CONDITIONER. Temperature of wa-
ter passing through the softener must
be less than 100 deg. F.
Do not install the conditioner in a
place where it could freeze. Damage
caused by freezing is not covered
by the warranty.
Put the conditioner in a place where
water damage is least likely to occur if
a leak develops. The manufacturer
will not repair or pay for water dam-
age.
A 120 volt electric outlet is needed within 6
feet of the softener. The transformer has
an attached 8 foot power cable. Be sure
the electric outlet and transformer are
in an inside location, to protect from
wet weather.
If installing in an outside location, you must
take the steps necessary to assure the
conditioner, installation plumbing, wiring,
etc. are protected from the elements and
contamination sources.
Keep the conditioner out of direct sun-
light. The sun’s heat may soften and
distort plastic parts.
The inFusion system is often placed after
sediment filtration but prior to any water
softener or UV light. If you have questions
about where to place the inFusion in con-
junction with the current water treatment
equipment.
How The Water Conditioner Works
Where To Install The Conditioner
